P6DG-xxxxELF Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] PM4-SERIES Rev.11-2008 1 Watt Regulated Single Output DIP14 Case 1 kV DC I/O Isolation Low Ripple and Noise The PM4 series P6DG-xxxxELF is a family of cost effective 1 W regulated single output DC/DC converters. These converters are in an ultra miniature DIP14 case. Devices are encapsulated. High performance features: Regulated Output, 1000VDC input/output isolation, high efficiency operation, output voltage accuracy of ±2% maximum, input range of ±10% tolerance and low output ripple and noise. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ ± 10% Capacitors 20 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation (0% - 100%) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 2% Short Term ± 0.5% ± 0.5% (3.3Vout Models: ± 1.0%) 50 mV pk-pk ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) See Table 1000 VDC 60 pF, typ. 1000 M Ohm 50 kHz (Variable) 95% rel H > 4.261 Mhrs Physical Specifications Case Material Potting Material Weight Non Conductive Black Plastic (UL94V-0 rated) Epoxy (UL94V-0 rated) ~ 2.7g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +85°C (ambient) 100°C -40 to +125°C Free Air Convection Soldering 260°C, max. (1.5mm from case 10s.) PM4-Series – P6DG-xxxxELF – Single Output – DIP14 – Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/3 Selection Guide Single Output ) ) mA) (mA ad (mA ad ( ) o d L a C ) o L D F)² C Lo ull d (u (VD e (V No F u ll ) nt F a g t t e e o a n n % r g t ( r L l e e y rr rr lta or Cu Vo ienc t Vo t Cu put Cu acit put put Inpu In p u In O ut O ut E ffic Cap Order # SINGLE OUTPUT P6DG-053R3ELF P6DG-0505ELF P6DG-057R2ELF P6DG-0509ELF P6DG-0512ELF P6DG-0515ELF P6DG-123R3ELF P6DG-1205ELF P6DG-127R2ELF P6DG-1209ELF P6DG-1212ELF P6DG-1215ELF P6DG-243R3ELF P6DG-2405ELF P6DG-247R2ELF P6DG-2409ELF P6DG-2412ELF P6DG-2415ELF 5 5 5 5 5 5 12 12 12 12 12 12 24 24 24 24 24 24 30 35 45 40 35 35 20 20 20 20 20 20 10 10 10 10 10 10 350 317 327 298 298 298 146 132 132 128 122 126 73 76 76 61 63 63 3.3 5 7.2 9 12 15 3.3 5 7.2 9 12 15 3.3 5 7.2 9 12 15 333 200 138.9 111.1 83.3 66.7 333 200 138.9 111.1 83.3 66.7 333 200 138.9 111.1 83.3 66.7 57 63 61 67 67 67 57 63 63 65 68 66 57 60 60 68 66 66 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 If you need other specifications, please enquire. Notes: PM4-Series – P6DG-xxxxELF – Single Output – DIP14 – Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/3 10.16 (0.40) 7.62 (0.30) 0.25 (0.01) Package / Pinning / Derating PIN CONNECTIONS # SINGLE 1 - Vin 7 N.C. 8 Omitted 9 +Vout 10 Omitted 11 - Vout 14 +Vin others Omitted App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH. ² = Tested by minimal Vin and constant resistive load. - Operation under no-load conditions will not damage these devices, but they will not observe the listed specifications. PM4-Series – P6DG-xxxxELF – Single Output – DIP14 – Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/3