P6CG-xxxxELF Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] PM4-SERIES Rev.02-2009 1 Watt Regulated Single Output SIP7 Case 1 kV DC I/O Isolation Low Ripple and Noise The PM4 series P6CG-xxxxELF is a family of cost effective 1 W regulated single output DC/DC converters. These converters are in an ultra miniature SIP7 case. Devices are encapsulated. High performance features: Regulated Output, 1000VDC input/output isolation, high efficiency operation, output voltage accuracy of ±2% maximum, input range of ±10% tolerance and low output ripple and noise. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ ± 10% Capacitors 20 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation (0% - 100%) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 2% Short Term ± 0.5% ± 0.5% (3.3Vout Models: ± 1.0%) 50 mV pk-pk ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) See Table 1000 VDC 60 pF, typ. 1000 M Ohm 50 kHz (Variable) 95% rel H > 4.261 Mhrs Physical Specifications Case Material Potting Material Weight Non Conductive Black Plastic (UL94V-0 rated) Epoxy (UL94V-0 rated) ~ 2.7g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +85°C (ambient) 100°C -40 to +125°C Free Air Convection (10 mm distance required) Soldering 260°C, max. (1.5 mm from case 10s.) PM4-Series – P6CG-xxxxELF – Single Output – SIP7 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/3 Selection Guide Single Output ) ) m A) (mA ad (mA ad ( ) o d L a C ) o l o l C L u uF)² ll L VD (VD nt F ) ad ( t No rent Fu ge ( e e o n a r % g t L r ( l e a r r r y lt or Cu Vo t Cu put Cu t Vo ienc acit put put In p u In p u In O ut O ut E ffic Cap Order # SINGLE OUTPUT P6CG-053R3ELF P6CG-0505ELF P6CG-057R2ELF P6CG-0509ELF P6CG-0512ELF P6CG-0515ELF P6CG-123R3ELF P6CG-1205ELF P6CG-127R2ELF P6CG-1209ELF P6CG-1212ELF P6CG-1215ELF P6CG-243R3ELF P6CG-2405ELF P6CG-247R2ELF P6CG-2409ELF P6CG-2412ELF P6CG-2415ELF 5 5 5 5 5 5 12 12 12 12 12 12 24 24 24 24 24 24 30 30 30 35 35 35 20 20 20 20 20 20 10 10 10 10 10 10 385 307 307 307 294 294 160 132 128 126 122 126 76 64 64 61 61 61 3.3 5 7.2 9 12 15 3.3 5 7.2 9 12 15 3.3 5 7.2 9 12 15 333 200 138.9 111.1 83.3 66.7 333 200 138.9 111.1 83.3 66.7 333 200 138.9 111.1 83.3 66.7 57 65 65 65 68 68 57 63 65 66 68 66 60 65 65 68 68 68 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 If you need other specifications, please enquire. Notes: PM4-Series – P6CG-xxxxELF – Single Output – SIP7 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/3 Package / Pinning / Derating 2.1 (0.9) All dimensions are typical in millimeters (inches). - Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) - Case tolerance +/-0.5 (+/-0.02) Specification may change without notice. 0.50 (0.02) 0.50 (0.02) 6.00 (0.24) 19.50 (0.76) PEAK Modelcode Datecode 1 2.54 (0.10) 2 4 5 6 7 SIP 7 – PLASTIC CASE 15.24 (0.60) PIN CONNECTIONS # SINGLE 1 +Vin 2 - Vin 4 - Vout 5 Omitted 6 +Vout 7 Omitted App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH. ² = Tested by minimal Vin and constant resistive load. - Operation under no-load conditions will not damage these devices, but they will not observe the listed specifications. PM4-Series – P6CG-xxxxELF – Single Output – SIP7 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/3