P6LG

P6LG-xxxxELF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
[email protected]
PM4-SERIES
Rev.06-2010
1 Watt
Regulated
Single Output
SIP7 Case
3 kV DC I/O Isolation
Low Ripple and Noise
The PM4 series P6LG-xxxxELF is a family of cost effective 1 W regulated
single output DC/DC converters. These converters are in an ultra miniature
SIP7 case. Devices are encapsulated. High performance features:
Regulated Output, 3000VDC input/output isolation, high efficiency
operation, output voltage accuracy of ±2% maximum, input range of ±10%
tolerance and low output ripple and noise.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
± 10%
Capacitors
20 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation (0% - 100%)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
± 2%
Short Term
± 0.5%
± 0.5% (3.3Vout Models: ± 1.0%)
50 mV pk-pk
± 0.02% / °C
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
3000 VDC
60 pF, typ.
1000 M Ohm
50 kHz (Variable)
95% rel H
> 4.261 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 2.7g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection (10 mm distance required)
Soldering 260°C, max. (1.5 mm from case 10s.)
PM4-Series – P6LG-xxxxELF – Single Output – SIP7 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3
Selection Guide
Single Output
A)
)
)
d (m
(mA ad (mA
a
)
o
d
L
a
C
)
ll
Lo
F)²
D
C
Lo
t Fu
d (u
(VD
Full
No
e (V
n
)
a
t
t
g
e
e
o
n
n
a
r
%
g
t
rre
rre
y(
l ta
or L
Cur
Vol
t Cu put Cu
t Vo
ienc
acit
put
put
In p u
In p u
In
O ut
O ut
E ffic
Cap
Order #
SINGLE OUTPUT
P6LG-053R3ELF
P6LG-0505ELF
P6LG-057R2ELF
P6LG-0509ELF
P6LG-0512ELF
P6LG-0515ELF
P6LG-123R3ELF
P6LG-1205ELF
P6LG-127R2ELF
P6LG-1209ELF
P6LG-1212ELF
P6LG-1215ELF
P6LG-243R3ELF
P6LG-2405ELF
P6LG-247R2ELF
P6LG-2409ELF
P6LG-2412ELF
P6LG-2415ELF
5
5
5
5
5
5
12
12
12
12
12
12
24
24
24
24
24
24
30
30
30
35
35
35
20
20
20
20
20
20
10
10
10
10
10
10
385
307
307
307
294
294
160
132
128
126
122
126
76
64
64
61
61
61
3.3
5
7.2
9
12
15
3.3
5
7.2
9
12
15
3.3
5
7.2
9
12
15
333
200
138.9
111.1
83.3
66.7
333
200
138.9
111.1
83.3
66.7
333
200
138.9
111.1
83.3
66.7
57
65
65
65
68
68
57
63
65
66
68
66
60
65
65
68
68
68
220
220
220
220
220
220
220
220
220
220
220
220
220
220
220
220
220
220
If you need other specifications, please enquire.
Notes:
PM4-Series – P6LG-xxxxELF – Single Output – SIP7 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 2/3
Package / Pinning / Derating
2.1
(0.9)
All dimensions are typical in millimeters (inches).
- Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002)
- Pin pitch tolerance: +/-0.35 (+/-0.014)
- Case tolerance +/-0.5 (+/-0.02)
Specification may change without notice.
0.50
(0.02)
0.50
(0.02)
6.00
(0.24)
19.50
(0.76)
PEAK
Modelcode
Datecode
1
2.54
(0.10)
2
4
5
6
7
SIP 7 – PLASTIC CASE
15.24
(0.60)
PIN CONNECTIONS
#
SINGLE (3KV)
1 +Vin
2 - Vin
4 Omitted
5 - Vout
6 Omitted
7 +Vout
App Notes:
¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH.
² = Tested by minimal Vin and constant resistive load.
PM4-Series – P6LG-xxxxELF – Single Output – SIP7 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 3/3