PMP135 Series MEDICAL 1 2 0 - 1 3 5 W AT T S - A C / D C S I N G L E O U T P U T FEATURES • • • • • • • • • Low safety ground leakage current Class I and Class II models are certified to medical and ITE safety standards Wide input range 90 to 264 VAC Optional output connectors 100% burn-in Overvol tage protection Overcurrent protection Compliant wi th CEC and Energy Star Efficiency level V requirements Compliant with RoHS requirements SPECIFICATIONS INPUT OPERATING MTBF 150,000 hours minimum at full load at 25°C ambient, calculated per MIL-HDBK217F Average active 87% min. (except 85% min. for PMP150-12 and PMP150-13) 90-160 KHz Voltage range 90-264 VAC Frequency Inrush current Earth leakage current 47-63 Hz 60 A @ 115 VAC or 120 A @ 230 VAC, at 25°C cold start 80 A @ 115 VAC or 160 A @ 230 VAC, at 25°C cold start 200 µA max. @ 264 VAC, 63 Hz Touch current 100 µA max. @ 264 VAC, 63 Hz Operating temperature: 0°C to +60°C Power factor 0.98 Typical at 115 VAC Storage temperature: -40°C to +85°C Input – Output: 4000VAC Input – Case:1500VAC Output – Case: 500VAC Relative humidity: Derating: 5% to 95% non-condensing Derate from 100% at +40°C linearly to 50% at +60°C Output voltage See table Safety Output current See table UL 60601-1, CSA C22.2 No. 601.1, TÜV EN 60601-1, UL 60950-1, CSA C22.2 No. 60950-1, TÜV EN 60950-1 Ripple and noise 1% peak to peak maximum at full load C-Tick AS/NZS CISPR11 Group1, Class A Line regulation ±0.5% maximum at full load EMC standards Load regulation See table Minimum load current 0A all models (IEC60601-1-2) EN55011 / EN55022 and FCC, VCCI: Class B conducted . class B radiated Transient response Maximum excursion of 4% or better on all models, recovering to 1% of final value within 500 us after a 25% step load change Immunity standards EN61000-3-2, EN61000-3-3, EN61000-42, EN61000-4-3, EN61000-4-4, EN610004-5, EN61000-4-6, EN61000-4-8, EN61000-4-11 Overvoltage protection Provided and set at 115-140% of its nominal output voltage Protected to short circuit conditions Input current Isolation OUTPUT Overcurrent protection Switching frequency ENVIRONMENT STANDARDS AND APPROVALS Temperature coefficient ±0.04% /°C maximum Hold-up time 15 ms minimum at 115 VAC Doc. No. PBC9 Rev.C 28-4-11 Efficiency MECHANICAL Dimensions 171x72x42mm Weight 681g Powering Progress – www.powerbox.com.au 385 MEDICAL PMP135 Series 1 2 0 - 1 3 5 W AT T S - A C / D C S I N G L E O U T P U T SELECTION TABLE MODEL(1) CLASS I PMP135-12 PMP135-12-1 PMP135-13 PMP135-13-1 PMP135-13-3 PMP135-14 PMP135-15 PMP135-16 PMP135-17 PMP135-18 OUTPUT CLASS II V1 PMP135F-12 PMP135F-12-1 PMP135F-13 PMP135F-13-1 PMP135F-13-3 PMP135F-14 PMP135F-15 PMP135F-16 PMP135F-17 PMP135F-18 12 V 13 V 14 V - 16 V 18 V - 19 V 20 V - 21 V 24 V - 25 V 28 V - 29 V 30 V - 32 V 36 V - 38 V 46 V - 50 V MIN. CURRENT MAX. CURRENT TOL. RIPPLE & NOISE (2) MAX POWER AVERAGE ACTIVE EFFICIENCY (TYPICAL) @ 115 / 230 VAC 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 10.00 A 9.23 A 9.29 A 7.50 A 6.75 A 5.63 A 4.83 A 4.50 A 3.75 A 2.94 A ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% 120 mV 120 mV 130 mV 135 mV 135 mV 135 mV 135 mV 135 mV 135 mV 135 mV 120W 120W 130W 135W 135W 135W 135W 135W 135W 135W 88 / 89 % 87 / 89 % 87 / 89 % 88 / 89 % 87 / 89 % 88 / 90 % 88 / 90 % 89 / 90 % 89 / 91 % 90 / 91 % NOTES: 1. Class I models are equipped with IEC320/C14 inlet, and class II models with IEC320/C18 inlet. 2. Ripple and noise is maximum peak-to-peak voltage value measured at output within 20 MHz bandwidth, at rated line voltage and output load ranges, and with a 10 µF tantalum capacitor in parallel with a 0.1 µF ceramic capacitor across the output. OUTPUT POWER DERATING CURVE MECHANICAL SPECIFICATIONS NOTES: 1. 2. 3. 4. Dimensions shown in inches [mm] Tolerance 0.02 [0.5] maximum Weight: 681 grams (1.505 lbs.) approx. Refer to Section titled “OPTIONAL OUTPUT CONNECTORS”. Add the suffix assigned for a selected connector to a wanted model number, e.g. PMP135-14-B1, for ordering. 5. The length of output cable for PMP135-12, PMP135-12-1, PMP135-13, PMP135F-12, PMP135F-12-1, and PMP135F-13 is 37.4 (950) PIN CHART MODEL PMP135-12 PMP135-12-1 PMP135-13 PMP135-13-1 PMP135-13-3 PMP135-14 PMP135-15 PMP135-16 PMP135-17 PMP135-18 386 PIN 1 2 3 4 PMP135F-12 PMP135F-12-1 PMP135F-13 PMP135F-13-1 PMP135F-13-3 PMP135F-14 PMP135F-15 PMP135F-16 PMP135F-17 PMP135F-18 V1 Return +V1 V1 Return +V1 Doc. No. PBC9 Rev.C 28-4-11