PMP90 Series MEDICAL 6 0 - 9 0 W AT T S - A C / D C S I N G L E O U T P U T FEATURES • • • • • • • • Low safety ground leakage current Class I and Class II models are certified to medical and ITE safety standards Wide input range Optional output connectors Over voltage protection Over current protection Compliant with CEC and Energy Star Efficiency level IV RoHS Compliant SPECIFICATIONS INPUT OPERATING MTBF Voltage range 90-264 VAC Frequency Inrush current Earth leakage current 47-63 Hz 50 A @ 115 VAC or 100 A @ 230 VAC, at 25°C cold start 1.20 A (rms) for 115 VAC 0.60 A (rms) for 230 VAC 180 µA max. @ 264 VAC, 63 Hz Touch current 100 µA max. @ 264 VAC, 63 Hz Power factor 0.98 Typical Input current Isolation Input – Output: 4000VAC Input – Case:1500VAC Output – Case: 500VAC Efficiency Switching frequency Operating temperature: 0°C to +60°C Storage temperature: -40°C to +85°C Relative humidity: Derating: 5% to 95% non-condensing Derate from 100% at +40°C linearly to 50% at +60°C STANDARDS AND APPROVALS See table Output current See table Ripple and noise 100 mVp-p maximum on 5 V, 6 V and 9 V outputs, 1% maximum on other voltage outputs (12 V, 13.5 V …, 48 V etc.) Line regulation ±0.5% maximum at full load Load regulation See table Minimum load current 0A all models Transient response Maximum excursion of 4% or better on all models, recovering to 1% of final value within 500 us after a 25% step load change Overvoltage protection Temperature coefficient Provided and set at 112-140% of its nominal output voltage Provided and set at 112-140% of its nominal output voltage All outputs ±0.04% /°C maximum Hold-up time 10 ms minimum at 110 VAC Overcurrent protection Doc. No. PBC9 Rev.C 28-4-11 50-110 KHz ENVIRONMENT OUTPUT Output voltage 150,000 hours minimum at full load at 25°C ambient, calculated per MIL-HDBK217F 85% min. (except 77% min. for PMP9010, PMP90-10-1, PMP90-11 and PMP9012) Safety UL 60601-1, CSA C22.2 No. 601.1, TÜV EN 60601-1, UL 60950-1, CSA C22.2 No. 60950-1, TÜV EN 60950-1 C-Tick AS/NZS CISPR11 Group1, Class A EMC standards (IEC60601-1-2) EN55011 / EN55022 and FCC, VCCI: Class B conducted . class B radiated Immunity standards EN61000-3-2, EN61000-3-3, EN61000-42, EN61000-4-3, EN61000-4-4, EN610004-5, EN61000-4-6, EN61000-4-8, EN61000-4-11 MECHANICAL Dimensions 130x76x43.7mm Weight 658g Powering Progress – www.powerbox.com.au 379 MEDICAL PMP90 Series 6 0 - 9 0 W AT T S - A C / D C S I N G L E O U T P U T SELECTION TABLE V1 MIN. CURRENT MAX. CURRENT TOL. RIPPLE & NOISE (2) MAX POWER AVERAGE ACTIVE EFFICIENCY (TYPICAL) @ 115 / 230 VAC 5.0 V 6.0 V 9.0 V 12.0 V 13.5 V 15.0 V 18.0 V 19.0 V 24.0 V 30.0 V 48.0 V 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 12.0 A 10.0 A 7.78 A 6.67 A 6.30 A 5.67 A 5.00 A 4.74 A 3.75 A 3.00 A 1.87 A ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% ±5% 100 mV 100 mV 100 mV 120 mV 135 mV 150 mV 180 mV 190 mV 240 mV 300 mV 480 mV 60 W 60 W 70 W 80 W 85 W 85 W 90 W 90 W 90 W 90 W 90 W 78 / 79 % 78 / 79 % 81 / 82 % 86 / 85% 86 / 85% 86 / 85 % 86 / 85 % 86 / 86 % 87 / 86 % 87 / 86 % 88 / 87 % MODEL(1) CLASS I PMP90-10 PMP90-10-1 PMP90-11 PMP90-12 PMP90-12-1 PMP90-13 PMP90-13-1 PMP90-13-2 PMP90-14 PMP90-16 PMP90-18 OUTPUT CLASS II PMP90F-10 PMP90F-10-1 PMP90F-11 PMP90F-12 PMP90F-12-1 PMP90F-13 PMP90F-13-1 PMP90F-13-2 PMP90F-14 PMP90F-16 PMP90F-18 NOTES: 1. Class I models are equipped with IEC320/C14 inlet, and class II models with IEC320/C18 inlet. 2. Ripple and noise is maximum peak-to-peak voltage value measured at output within 20 MHz bandwidth, at rated line voltage and output load ranges, and with a 10 µF tantalum capacitor in parallel with a 0.1 µF ceramic capacitor across the output. OUTPUT POWER DERATING CURVE MECHANICAL SPECIFICATIONS NOTES: 1. 2. 3. 4. 5. Dimensions shown in inches [mm] Tolerance 0.02 [0.5] maximum Weight: 658 grams (1.45 lbs.) approx. Output connector is 4 pin plug without lock, mating with Kycon P/N KPJX-4S-S socket or equivalent. Refer to Section titled “OPTIONAL OUTPUT CONNECTORS”. Add the suffix assigned for a selected connector to a wanted model number, e.g. PMP90-14-B1, for ordering. PIN CHART MODEL PMP90-10 PMP90-10-1 PMP90-11 PMP90-12 PMP90-12-1 PMP90-13 PMP90-13-1 PMP90-13-2 PMP90-14 PMP90-16 PMP90-18 380 PIN 1 2 3 4 PMP90F-10 PMP90F-10-1 PMP90F-11 PMP90F-12 PMP90F-12-1 PMP90F-13 PMP90F-13-1 PMP90F-13-2 PMP90F-14 PMP90F-16 PMP90F-18 V1 Return +V1 V1 Return +V1 Doc. No. PBC9 Rev.C 28-4-11