2N1875-2N1880 SILICON CONTROLLED RECTFIERS High-reliability discrete products and engineering services since 1977 FEATURES Available as “HR” (high reliability) screened per MIL-PRF-19500, JANTX level. Add “HR” suffix to base part number. Available as non-RoHS (Sn/Pb plating), standard, and as RoHS by adding “-PBF” suffix. MAXIMUM RATINGS Symbol 2N1875 2N1876 2N1877 2N1878 2N1879 2N1880 Unit Repetitive peak off-state voltage Rating VDRM 15 30 60 100 150 200 V Repetitive peak reverse voltage VRRM 15 30 60 100 150 200 V DC on-state current 100°C ambient 100°C case IT 250 1.25 mA A Repetitive peak on-state current ITRM Up to 30 A Peak one cycle surge (non-repetitive) onstate current ITSM 15 A Peak gate current IGM 250 mA Average gate current IG(AV) 25 mA Reverse gate voltage VGR 5 V Thermal resistance, junction to case RӨJC 20 °C/W TJ, Tstg -65 to 150 °C Operating and storage temperature range ELECTRICAL CHARACTERISTICS (TA = 25°C unless otherwise specified) Characteristics Symbol Min Typ Max Unit Test Condition Off-state current IDRM - 0.5 5 µA VDRM = rating, RGK = 1KΩ Reverse current IRRM - 0.5 10 µA VRRM = rating Reverse gate current IGR - 0.5 10 µA VGR = 2V Subgroup 2 (25°C test) Gate trigger current IGT - 5 20 µA VD = 5V, RGS = 10KΩ Gate trigger voltage VGT 0.44 0.52 0.60 V VD = 5V, RGS = 100Ω IAT - 100 - µA VD = 5V On-state voltage VT 0.8 1.8 2.5 V IT = 2A(pulse test) Holding current IH 0.3 1.0 3 mA IG = -150µA, VAA = 5V Turn-on time ton - 0.1 - µs Turn-off time toff - 0.5 - µs tpg(on) - 0.5 - µs tq - 10 - µs IT = 0.5A, IR = 0.5A, RGK = 1KΩ High temperature off-state current IDRM - 5 20 µA VD = rating, RGK = 1KΩ High temperature reverse current IRRM - 15 100 µA VRRM = rating Anode trigger current (1) Subgroup 3 (25°C test) Gate trigger – on pulse width Circuit commutated turn-off time IG = 20mA, IT = 0.5A, VD = 30V Subgroup 4 (125°C test) Note 1: For a maximum limit of 50µA, use suffix “-1” and drop 2N. Voltage ratings apply over the operating temperature range, provided the gate is connected to the cathode through an appropriate resistor, or adequate gate bias is used. Rev. 20130116 2N1875-2N1880 SILICON CONTROLLED RECTFIERS High-reliability discrete products and engineering services since 1977 MECHANICAL CHARACTERISTICS Case: TO-5 Marking: Body painted, alpha-numeric Pin out: See below TO-5 Dim HD CD CH LL LD LU P TL TW TH LO α Inches Min Max 0.335 0.370 0.305 0.335 0.240 0.260 1.500 0.016 0.021 0.016 0.019 Millimeters Min Max 8.510 9.400 7.750 8.510 6.100 6.600 38.100 0.410 0.530 0.410 0.480 0.100 2.540 - 0.029 0.045 0.028 0.034 0.009 0.125 0.141 NOM 45°TP - 0.740 1.140 0.710 0.860 0.230 3.180 3.590 NOM 45°TP Rev. 20130116