ES1A THRU ES1J SUPER FAST RECTIFIER VOLTAGE RANGE 50 to 600 Volts CURRENT 1.0 Ampere FEATURES SMA - J (DO-214AC) Low forward voltage drop Low leakage current High forward surge capability MECHANICAL DATA Case: SMA-J mold plastic Epoxy: UL94V-0 rate flame retardant Polarity: Indicated by cathode band Lead: Solder plated, solderable per MIL-STD-750 method 2026 Mounting position: Any MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Dimensions in inches and (millimeters) Ratings at 25℃ ambient temperature unless otherwise specified , Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load derate current by 20% PARAMETER SYMBOLS ES1A ES1B ES1C ES1D ES1G ES1J UNIT Maximum Repetitive Peak Reverse Voltage VRRM 50 100 150 200 400 600 Volts Maximum RMS Voltage VRMS 35 70 105 140 280 420 Volts Maximum DC Blocking Voltage VDC 50 100 150 200 400 600 Volts Maximum Average Forward Rectified Current at TA=55℃ I(AV) Amp 1.0 s Peak Forward Surge Current 8.3mS single half sine-wave IFSM 30 Amps superimposed on rated load (JEDEC method) Maximum Instantaneous Forward Voltage at 1.0A Maximum DC Reverse Current VF 0.95 1.25 1.7 5.0 TA = 25℃ IR at rated DC Blocking Voltage Volts uA 30 TA = 100℃ Maximum Reverse Recovery Time(NOTE1) TRR 35 Typical Thermal Resistance (NOTE 2) CJ 15 pF RθJA 55 ℃/W TJ,TSTG -55 to +150 ℃ Typical Thermal Resistance (NOTE 3) Operating and Storage Temperature Range 1. Reverse Recovery Test Conditions: If=0.5A, Ir=1.0A, Irr=0.25A. 2. Measured at 1.0MHz and applied reverse voltage of 4.0 Volts. 3. Thermal Resistance from Junction to Ambient at. 5.0×5.0mm2 copper pad areas. Website: www.kingtronics.com Email: [email protected] Tel: (852) 8106 7033 Fax: (852) 8106 7099 1 ES1A THRU ES1J RATINGS AND CHARACTERISTIC CURVES Note: Specifications are subject to change without notice. Website: www.kingtronics.com Email: [email protected] Tel: (852) 8106 7033 Fax: (852) 8106 7099 2