EMEA Integrated Network Zone System: ZCCB04--SA-UKE

Integrated Network
Zone System
The integrated network zone system enables network
communications between the control room and manufacturing
floor within an industrial facility. Available in three base
configurations, the systems are integrated with an Allen-Bradley*
Stratix Industrial Ethernet switch for fast deployment. The active
equipment is deployed with network structured cabling and cable
management according to best practices and industry installation
guidelines. Systems also include Allen-Bradley* uninterruptible
power supplies installed behind a touch-safe protective cover, and
are CE approved.
Key Features
Benefits
Integrated solution
Significantly reduces the amount of effort and complication when integrating the
plant floor and enterprise networks, up to 75% reduction in deployment time may be
achieved with the integrated solution
Managed switching
Integrated Allen-Bradley* Stratix switches offer management and diagnostics from
within IT, and controls environments and optimizes network traffic
IT-ready
Protects from shock hazards, allows clean segmentation between the upper level
plant network and the machine level network to help maintain network service level
agreements (SLAs)
Validated performance
Thermally tested and validated designs incorporate best practices for switch
deployment, media selection, and cable management to maximize performance
Applications
Panduit’s Integrated Network Zone System is used to deploy an EtherNet/IP*** network between the enterprise
and the plant floor. Using the Integrated Network Zone System allows the usability and familiarity of IT switches
while maintaining the critical uptime needs and controls interfaces on the plant floor. This ensures that
management and control of your network does not get in the way of making the most effective use of
your data available on the network.
*Allen-Bradley, Integrated Architecture, Stratix 8000, and Stratix 5700 are trademarks of Rockwell Automation, Inc.
**Cisco is a registered trademark of Cisco Technology Inc.
***EtherNet/IP is a trademark of ODVA.
w w w. p a n d u i t . c o m
Integrated Network Zone System
Deploying Zone Network Topology
Control Room
Zone Infrastructure
Manufacturing Cell
A highly effective way to deploy EtherNet/IP*** solutions in a plant floor environment is to follow the
recommendations from Rockwell Automation and Cisco** in their Converged Plant-wide Ethernet (CPwE) design
and implementation guide. In this guide the use of zoned network topology is recommended as a best practice.
Using Panduit’s Network Zone System integrated with Stratix switches from Rockwell Automation provides a platform
for implementing small VLANs for cell/area zones, as recommended in the CPwE to improve manageability and limit
Layer 2 broadcast domains‡.
1
SYS T
RPS
MASTR
STAT
DU PLX
SPE ED
STAC K
MODE
1X
2X
1
SYS T
RPS
MASTR
STAT
DU PLX
SPE ED
STAC K
MODE
1X
2X
S
T
A
S
C
T
K
A
1
C
C
O
NS
C
OL
O
E
NS
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
K
1
The zone enclosures allow all cables within a cell to be managed and patched within a single enclosure. By using
a zone cabling architecture approach, network cabling becomes easier to locate, manage, and maintain because
each additional device is routed within the same pathways and enclosures. Managed cabling helps reduce
the number of home runs throughout a facility and helps reduce abandoned cable in plenum spaces, helping make
the workplace run more efficiently and safely.
S
T
A
S
C
T
K
A
2
C
2
K
2
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
15X 17X
OL
E
16X 18X
33
34
33
34
31X 33X
16X 18X
15X 17X
32X 34X
31X 33X
32X 34X
R
10
1.6AA
00.9A,
TI
24
R
10
50-60
N
0V
1.6AA
0HZ
G
~
0.9A,
TI
24
50-60
N
0V
HZ
G
~
Catalyst 3750
35
36
37
38
39
40
41
42
43
44
45
46
47
48
35
36
37
38
39
40
41
42
43
44
45
46
47
48
47X
Plant
Level
Zone
SERIES
3
1
2
4
48X
Catalyst 3750
47X
SERIES
1
3
2
4
48X
Machine
Level
Zone
A
D
C
C
A
D
C
C
A
D
C
C
Following a zone topology allows a highly scalable and flexible deployment using building blocks of the CPwE architecture.
Layout
Part Description
Stratix
Industrial
Ethernet Switches
Power
Input
Allen-Bradley* UPS
Uplinks
Z23N-SBAAD1
24" x 36" Network Zone System with Stratix 8000* 1783-MS10T switch with 2 1 Gb MM fiber optic uplinks,
with redundant 100-250Vac power supply input and UPS pre-installed.
Z23N-SBABD1
24" x 36" Network Zone System with Stratix 8000* 1783-MS10T switch with 2 1 Gb MM fiber optic uplinks and
1783-MX08T expansion module, with redundant 100-250Vac power supply input and UPS pre-installed.
Z23N-SBABA1
24" x 36" Network Zone System with Stratix 8000* 1783-MS10T switch with 2 1 Gb copper uplinks and
1783-MX08T expansion module, with redundant 100-250Vac power supply input and UPS pre-installed.
Two 1 Gb copper uplinks
Z23N-SBBAD1
24" x 36" Network Zone System with 2 Stratix 8000* 1783-MS10T switches each with 2 1 Gb MM fiber optic
uplinks, with redundant 100-250Vac power supply input and UPS pre-installed.
Four 1 Gb OM3 multimode
fiber optic uplinks with LC
cord and connector
Z23N-SBBFD1
24" x 36" Network Zone System with 2 Stratix 8000* 1783-MS10T switches each with 2 1 Gb MM fiber optic
uplinks and 2 1783-MX08T expansion modules, with redundant 100-250Vac power supply input and
UPS pre-installed.
Z22N-SDAD1
24" x 24" Network Zone System with Stratix 5700* 1783-BMS10CGA switch with 2 1 Gb MM fiber optic uplinks,
with redundant 100-250Vac power supply input and UPS pre-installed.
Z22N-SDAA1
24" x 24" Network Zone System with Stratix 5700* 1783-BMS10CGA switch with 2 1 Gb copper uplinks, with
redundant 100-250Vac power supply input and UPS pre-installed.
Z22N-SEAD1
24" x 24" Network Zone System with Stratix 5700* 1783-BMS20CGP switch with 2 1 Gb MM fiber optic uplinks,
with redundant 100-250Vac power supply input and UPS pre-installed.
Stratix 5700* Managed Industrial
Ethernet Switch 1783-BMS20CGP
Z11N-SDD
12" x 14" Network Zone System with Stratix 5700* 1783-BMS10CGA switch with 2 1 Gb MM fiber optic uplinks.
Z11N-SDA
12" x 14" Network Zone System with Stratix 5700* 1783-BMS10CGA switch with 2 1 Gb copper uplinks.
Stratix 5700*
Managed Industrial
Ethernet Switch
1783-BMS10CGA
Z11N-SED
12" x 14" Network Zone System with Stratix 5700* 1783-BMS20CGP switch with 2 1 Gb MM fiber optic uplinks.
Stratix 8000* Modular
Managed Switch 1783-MS10T
100-250Vac
Rated at 12 V 7Ah
tested to 59 minutes
(fully expanded)
Two 1 Gb OM3 multimode
fiber optic uplinks with LC
cord and connector
Downlink
Port Count
Pre-Installed
8 RJ45 Ethernet
Maximum
Downlink
Port Count
48 RJ45 Ethernet‡‡
16 RJ45 Ethernet
48 RJ45 Ethernet
Stratix 5700*
Managed Industrial
Ethernet Switch
1783-BMS10CGA
Stratix 5700* Managed Industrial
Ethernet Switch 1783-BMS20CGP
100-250Vac
Rated at 12 V 7Ah
tested to 3.5 hrs.
Two 1 Gb OM3 multimode
fiber optic uplinks with LC
cord and connector
8 RJ45 Ethernet
8 RJ45 Ethernet
Two 1 Gb OM3 multimode
fiber optic uplinks with LC
cord and connector
16 RJ45 Ethernet
16 RJ45 Ethernet, 2 SFP+
Two 1 Gb OM3 multimode
fiber optic uplinks with LC
cord and connector
8 RJ45 Ethernet
8 RJ45 Ethernet
16 RJ45 Ethernet
16 RJ45 Ethernet, 2 SFP+
Two 1 Gb copper uplinks
24 V dc or
48 V dc
N/A
Two 1 Gb copper uplinks
Two 1 Gb OM3 multimode
fiber optic uplinks with LC
cord and connector
‡For additional reference see the Panduit Popular Configuration Drawing “Overview of Industrial Switch Deployment” PCD0001.
‡‡Maximum port count may require additional switch and expansion modules to be installed.
Leveraging the Rockwell Automation Integrated Architecture* technology simplifies switch configuration and integration while providing machine-based diagnostics and troubleshooting tools. Stratix Industrial
Ethernet Switches also leverage the Cisco** operating system, bringing the world's leading switching technology to the plant floor environment. Advanced switch feature sets include: STP/RSTP/MST, Resilient
Ethernet Protocol (REP), Flexlinks, EtherChannel (link aggregation), QoS, IGMP snooping with querier, VLANs with trunking, IEEE 1588 PTP v2, IPv6 support, storm control with alarming, egress traffic shaping;
compatible with Cisco** Network Assistant (CNA) and CiscoWorks.
*Allen-Bradley, Integrated Architecture, Stratix 8000, and Stratix 5700 are trademarks of Rockwell Automation, Inc.
**Cisco is a registered trademark of Cisco Technology Inc.
***EtherNet/IP is a trademark of ODVA.
2
3
Integrated Network Zone System
Te c h n i c a l I n f o r m a t i o n
Standards
CE
Rating
UL Type 4/12 and IP66
Environment
40°C ambient outside of enclosure or 60°C maximum within enclosure at up to 95%
(non-condensing) humidity; Z11N systems rated up to 50°C ambient
Installation
Wall mount with optional outside-mount flange
Dimensions
Z23N series: 36.0"H x 24.0"W x 11.7"D (914mm x 610mm x 297mm)
Z22N series: 24.0"H x 24.0"W x 11.7"D (610mm x 610mm x 297mm)
Z11N series: 14.0"H x 12.0"W x 9.7"D (356mm x 305mm x 247mm)
Add-On Kits
Part Number
Part Description
Z23N Add-On Kits
1783-MS10T
Stratix 8000* switch, available from Rockwell Automation.
1783-MX08T
Stratix 8000* copper expansion module, available from Rockwell Automation.
1783-MX08F
Stratix 8000* fiber expansion module, available from Rockwell Automation.
FSPD504
OptiCore™ Dielectric Conduited Fiber Uplink Cable.
PUC6004IG-EY
Copper downlink cable (CM).
PUL6004BU-EY
Copper downlink cable (LSZH).
LEDS12
12.5" LED strip light.
LEDDS
Door switch.
LEDCPS4
Din-mount power supply.
Z22N Add-On Kits
FSPD504
OptiCore™ Dielectric Conduited Fiber Uplink Cable.
PUC6004IG-EY
Copper downlink cable (CM).
PUL6004BU-EY
Copper downlink cable (LSZH).
Z11N Add-On Kits
FSPD504
OptiCore™ Dielectric Conduited Fiber Uplink Cable.
PUC6004IG-EY
Copper downlink cable (CM).
PUL6004BU-EY
Copper downlink cable (LSZH).
Related Items – Pre-Configured Micro Data Center for Industrial Network Deployment
CQSMDC48
24 RU Pre-Configured Industrial Micro Data Center, 48.4" (1239mm) height, network cabling, 4 casters, and shock pallet.
CQSMDC79
42 RU Pre-Configured Industrial Micro Data Center, 78.1" (1984mm) height, network cabling, 4 casters, and shock pallet.
*Allen-Bradley, Integrated Architecture, Stratix 8000, and Stratix 5700 are trademarks of Rockwell Automation, Inc.
**Cisco is a registered trademark of Cisco Technology Inc.
***EtherNet/IP is a trademark of ODVA.
WORLDWIDE SUBSIDIARIES AND SALES OFFICES
PANDUIT CANADA
Markham, Ontario
[email protected]
Phone: 800.777.3300
PANDUIT EUROPE LTD.
London, UK
[email protected]
Phone: 44.20.8601.7200
PANDUIT SINGAPORE PTE. LTD.
Republic of Singapore
[email protected]
Phone: 65.6305.7575
PANDUIT JAPAN
Tokyo, Japan
[email protected]
Phone: 81.3.6863.6000
PANDUIT LATIN AMERICA
Guadalajara, Mexico
[email protected]
Phone: 52.33.3777.6000
PANDUIT AUSTRALIA PTY. LTD.
Victoria, Australia
[email protected]
Phone: 61.3.9794.9020
For a copy of Panduit product warranties, log on to www.panduit.com/warranty
TM
For more information
Visit us at www.panduit.com
Contact Customer Service by email: [email protected]
or by phone: 800.777.3300
©2014 Panduit Corp.
ALL RIGHTS RESERVED.
Product Bulletin Number ZCCB04--SA-UKE-ENG
Replaces ZCCB03--SA-ENG
2/2014