RADIAL-TAPING SPECIFICATIONS FOR RECTIFIERS-I TAPING P h A D F K2 d K1 B K3 K4 L H A1 W2 A2 W1 W0 W T P0 P1 D0 t Fig.: Configuration of I-TAPING ITEM Lead-wire clinch heigth Kinker heigth Kinker position Lead kinker length Component kinker spacing Adhesive tape position Body diameter Body length Lead-wire diameter Component pitch Feed hole pitch Component lead spacing Deflection Tape width Hole-down tape width Hole position Length from seating plane Feed hole diameter Totai tape thickness Cut out length Leed protrusion Center of seating plane location Adhesive tape position Lead bend Notes : SYMBOL SPECIFICATIONS(mm) SPECIFICATIONS(inch) A2 K1 K2 K3 K4 A1 D A d P P0 F h W W0 W1 H D0 t L T P1 W2 B 15.5 0.2 5.0 1.0 3.0 1.0 3.0 1.0 2.5 1.0 6.0 Min. 2.5 0.2 3.1 0.3 0.6 0.1 12.7 1.0 12.7 1.0 5.0 0.8 0.0 2.0 18.0+1.0/-0.5 12.5 Min. 9.0+0.7/-0.5 20.0 0.5 4.0 0.3 0.7 0.2 11.0 Max. 2.0 Max. 6.35 0.7 3.0 Max. 1.0 Max. 0.610 0.008 0.197 0.039 0.118 0.039 0.118 0.039 0.098 0.039 0.236 Min. 0.098 0.008 0.122 0.012 0.024 0.004 0.500 0.039 0.500 0.039 0.197 0.031 0.0 0.079 0.709+0.039/-0.020 0.492 Min. 0.354+0.028/-0.020 0.787 0.020 0.157 0.012 0.028 0.008 0.433 Max. 0.079 Mix. 0.250 0.028 0.118 Max. 0.039 Max. 1.Devices are pecked in accordance with EIA standard RS-468and specifications listed above. Available only for R-1 product utilizing 0.6mm diameter leads. 2.Maximum cumulative pitchtolerance : 1.0mm/20pitch. 3.Standard packing code is "l". Visit http:// www.rectron.com for complete datasheets E2