Plastic Packages for Integrated Circuits Package Outline Drawing L48.7x7G 48 LEAD QUAD FLAT NO-LEAD PLASTIC PACKAGE Rev 0, 1/10 7.00 6 PIN 1 INDEX AREA 6 PIN #1 INDEX AREA 4X 5.5 A B 37 48 36 1 7.00 44X 0.50 (4X) EXP. DAP 5.70 SQ. 12 25 0.15 24 13 48X 0.40 48x 0.20 4 TOP VIEW BOTTOM VIEW SEE DETAIL "X" 1.00 MAX 0.10 C C 0.08 C SEATING PLANE ( 44X 0 . 5 ) 6 .80 SQ SIDE VIEW 5.70 SQ C 0 . 2 REF 5 ( 48X 0 . 20 ) 0 . 00 MIN. 0 . 05 MAX. ( 48X 0 . 60 ) TYPICAL RECOMMENDED LAND PATTERN DETAIL "X" NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to ASME Y14.5m-1994. 3. Unless otherwise specified, tolerance : Decimal ± 0.05 4. Dimension applies to the metallized terminal and is measured between 0.015mm and 0.30mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 indentifier may be either a mold or mark feature. 1