AOZ8011 PRELIMINARY Package Dimensions, DFN 1.6 x 4.0, 16L D B bbb A CAB e b 16 16 R E1 E aaa C 1 aaa C L 2x 1 2x D1 TOP VIEW BOTTOM VIEW A ccc C A1 c ddd C Seating B Plane SIDE VIEW RECOMMENDED LAND PATTERN 3.20 0.45 1.30 0.30 0.25 0.50 UNIT: mm Dimensions in millimeters Dimensions in millimeters Symbols A A1 b c D D1 E E1 e L R aaa bbb ccc ddd Symbols A A1 b c D D1 E E1 e L R aaa bbb ccc ddd Min. 0.70 0.00 0.18 0.15 Nom. 0.75 0.02 0.25 0.20 4.00 BSC 3.05 3.20 1.60 BSC 0.30 0.45 0.50 BSC 0.20 0.30 0.10 0.15 0.10 0.10 0.08 Max. 0.80 0.05 0.30 0.25 3.30 0.55 0.40 Min. 0.028 0.000 0.007 0.006 Nom. Max. 0.030 0.031 0.001 0.002 0.010 0.012 0.008 0.010 0.157 BSC 0.120 0.126 0.130 0.063 BSC 0.012 0.018 0.022 0.020 BSC 0.008 0.012 0.016 0.004 0.006 0.004 0.004 0.003 Notes: 1. Dimensions and tolerancing conform to ASME Y14.5M-1994. 2. All dimensions are in millimeters. 3. Dimension b applies to metallized terminal and is measured between 0.10mm and 0.30mm from the terminal tip. If the terminal has the optional radius on the other end of the terminal, the dimension b should not be measured in that radius area. 4. Coplanarity ddd applies to the terminals and all other bottom surface metallization. Rev. 1.3 August 2007 www.aosmd.com Page 5 of 6