X

※ This Weatherproof IR Camera is
designed for Ceiling or Wall Mounting
Dimensions (mm)
Simple to install
126.0
122.0
COMPOSITION:
62.0
101.5
As surroundings darken, it switches
automatically from color to black-and-white
mode to enhance sensitivity.
Outdoor
Surveillance Camera
Operation Manual
150.0
P/N:3810-0054S Rev 0 03/18
olor Mod
e
READ AND KEEP THIS
OPERATION MANUAL
)
ndition
• D
(C
co
t
h
78.0
Video Output
Video
(Yellow)
• The wire is polarized.
• Use 12VDC
power source.
J504
Service Monitor Connecter:
Use service monitor connector
to set camera angle & focus
when installing.
VR501
Power- 12VDC
(Red)
No. Function Terminal Color
Remark
#1 Video Output
Yellow
1.0 Vp-p
#2 Power Input
Red
12VDC(10V~15V), 0.3A(Max)
#2
a
ON
J505
SW501
NAME AND FUNCTION:
Vari-focal Lens Type
1
3
2
Photo Sensor
3
IR LED
850nm / 30°(18EA)
b
Function Selection Switch:
•BLC(Back Light Compensation)
ON/OFF
•AGC(Auto Gain Control) ON/OFF
•D/N(Day & Night) ON/OFF
•DSS(Digital Slow Shutter) ON/OFF
•D.Z(Digital Zoom) ON/OFF
•FLK(Flickerless) ON/OFF
1
2
3
4
5
6
b
CAUTION : When AGC is off,
D/N does not work because the
D/N switching function is
dependent on the AGC level.
TROUBLESHOOTING:
If you have trouble operating your camera, refer to the following.
If the guidelines do not enable you to solve the problem,
contact an authorized technician.
The image does not
appear on the screen.
• Check the power source for the monitor and
The image on the
screen is dim.
• Check if the lens is stained. If dirty, clean the lens with
camera and ensure that the voltage and polarity
are correct.
a soft, clean cloth.
• Adjust the Back Focus of the lens again.
2
4
1
y
g
a
#1
Note
If there is a bright spot light in the scene,
smearing or blooming may occur.
Confirm that the power supply provides
sufficient power before connecting the
camera.
a
FLK
D.Z
DSS
D/N
AGC
BLC
!
• IP65
OFF
OFF
ON
ON
ON
OFF
It can damage CCD.
• Weatherproof Housing
ON
ON
OFF
OFF
OFF
ON
Never point the camera into strong
light or the sun.
• Electronic Sensitivity-up(DSS) On/Off
12VDC Power Type
It can cause malfunctions to occur.
!
• Super Digital Noise Reduction (SDNR)
Li
Connecting to Monitor and Power
Do not install the camera under unstable
lighting conditions.
Do not drop the camera or subject
to physical shock.
• 3.8 - 9.5 mm DC Vari-focal Auto Iris Lens
CAMERA SET-UP:
GND
Severe lighting change or flicker can cause
the camera to work improperly.
• AGC, BLC, Flickerless On/Off
Low-
Do use the camera under conditions where
temperatures are within -10°C to 45°C.
Be especially careful with ventilation under
high temperatures.
• Auto White Balance
)at
Do not install the camera in extreme
temperature conditions.
CONNECTION:
• High Resolution: 550 TV Lines
M
PRECAUTIONS:
Need Help?
Call 1.800.796.CCTV for sales, service and customer support.
www.honeywellvideo.com
• 1/3" Sony Super HAD CCD
ght (B/W
CAUTION - When this camera is installed near equipment, like a wireless
communication device that emits a strong electromagnetic field, some
irregularity such as noise on the monitor screen may happen.
2 : 1 Interlace
15.734kHz
15.625kHz
59.94Hz
50Hz
1/3 inch SONY Super HAD CCD
410K
470K
50dB Min. (AGC Off)
550 TV Lines
1.0 Vp-p (75 Ohms, composite)
Vari-focal Lens (F=1.2, f=3.8~9.5mm)
Manual
Internal
0.3 Lux (color)/ 0.008 Lux (DSS On) / 0 Lux (IR LED On)
1/60 ~ 120,000 Sec.
1 /50 ~ 120,000 Sec.
Auto
On / Off Selectable
On / Off (Max 32 times)
On / Off (2 x)
AUTO
Power (Red Jack), Video (Yellow Jack)
-10°C ~ 45°C
-20°C ~ 65°C
12VDC (10V~15V), 0.3A/3.6W (Max)
75 x 78 x 150mm
Approx. 800g
Ni
WARNING - Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
PAL
PAL : 625 Lines
de
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against harmful interference in a
commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and use in accordance with the instructions, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause interference, in which case the user will be
required to correct the interference at his own expense.
NTSC
NTSC : 525 Lines
o
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1)This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
!
Operation
Manual
•
Signal System
Scanning System
Scanning Frequency (H)
Scanning Frequency (V)
Image Sensor
Total / Effective Pixels No.
S / N Ratio
Resolution
Video Output Level
Lens
Focus
Sync. System
Sensitivity (F1.2)
Electronic Shutter
White Balance
AGC/ BLC/ D&N/ FL
DSS
D-ZOOM
DNR
Input / Output Connector
Operrating Temperature
Storage Temperature
Power Consumption
Dimensions (WxHxD)
Weight
Regulatory Notice
!
Series
SPECIFICATIONS:
75.0
!
HB73
Bracket Mounting Screws
Model
!
Sun Visor Fastener
L-Wrench
5
Bright Adjustment V.R
Used to adjust video output level of DC driven auto iris lens.
When the brightness control of the monitor does not operate correctly,
you can optimize the picture picture by controlling the DC level of camera.
4
Zoom Handle
Used to adjust zoom magnification by
turning.
5
Focus Handle
Used to provide for accurate focusing
of object within the lens field of view.
The camera does not work
properly, the surface of the
camera case is hot, and a black
line appears on the screen.
• Check if you have connected the camera to a proper
The screen blinks a lot.
• Check if the camera is pointed toward the sun or a
power source and If there is no problem with the power,
turn the unit off immediately and seek assistance from
our Customer Service department.
fluorescent lamp.
• Adjust the angle or location of the camera if too much
light is coming into the screen.