Datasheet

PHOTOSENSOR MODULES
H13320 SERIES
OVERVIEW
The H13320 series photosensor modules contain a highvoltage power supply circuit and a 13-mm (1/2") diameter sideon photomultiplier tube in a compact aluminum housing. Its
photocathode has a reflection mode that delivers high quantum
efficiency at wavelengths above 600 nm, an adequate gain of
up to 107 and fast time response.
These modules are suitable for integration to portable devices
because they are low power consumption and can be operated
by dry battery.
PRODUCT VARIATIONS
Spectral response Photocathode Window material
UV glass
Bialkali
185 nm to 750 nm
UV glass
Multialkali
185 nm to 900 nm
UV glass
Multialkali
185 nm to 900 nm
Type No.
H13320-01
H13320-02
H13320-03
H13320-13
185 nm to 900 nm
Multialkali
UV glass
H13320-04
H13320-05
185 nm to 830 nm
185 nm to 650 nm
Multialkali
Bialkali
UV glass
UV glass
Features
High sensitivity in UV to visible range
For general applications in UV to near IR range
High sensitivity in UV to near IR range
High sensitivity in UV to near IR range,
Higher sensitivity in near IR range than -03
Low dark current. For UV to near IR range
For general applications in UV to visible range
This product can't be used at vacuum environment or reduced pressure environment. Please pay attention when the H13320 series is used for
measuring the light below 190 nm.
Figure 1: Typical spectral response
TPMOB0289EA
TPMOB0290EA
1000
CATHODE RADIANT SENSITIVITY (mA/W)
CATHODE RADIANT SENSITIVITY (mA/W)
1000
H13320-01
100
10
H13320-05
1
0.1
100
200
300
400
500
600
700
WAVELENGTH (nm)
800
900
H13320-13
100
H13320-03
10
H13320-02
H13320-04
1
0.1
100
200
300
400
500
600
700
800
900
WAVELENGTH (nm)
Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office.
Information furnished by HAMAMATSU is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are
subject to change without notice. No patent rights are granted to any of the circuits described herein. ©2016 Hamamatsu Photonics K.K.
PHOTOSENSOR MODULES H13320 SERIES
Figure 2: Schematic diagram
SIGNAL OUTPUT (CURRENT OUTPUT)
HIGH
VOLTAGE
POWER
SUPPLY
CIRCUIT
LOW VOLTAGE INPUT (+3 V to +5 V)
GND
Vref OUTPUT (+1.2 V)
Vcont INPUT (+0.25 V to +1.0 V)
(INPUT IMPEDANCE: 1 MΩ)
SPECIFICATIONS
(at +25 °C)
Parameter
Anode
Cathode
Suffix
Input voltage
Max. input voltage
Max. input current *1
Max. output signal current *2
Max. control voltage
Recommended control voltage adjustment range
Effective area
Peak sensitivity wavelength
Min.
Luminous sensitivity
Typ.
Blue sensitivity index (CS 5-58) Typ.
Red / White ratio
Typ.
Radiant sensitivity *3
Typ.
Min.
Luminous sensitivity *2
Typ.
2
3
Radiant sensitivity * *
Typ.
Typ.
Dark current *2 *4
Max.
Typ.
Rise time *2
Ripple noise *2 *5 (peak to peak) Max.
Max.
Settling time *6
Operating ambient temperature *7
Storage temperature *7
Weight
-01
420
80
120
10
—
90
100
700
5.2 × 105
1
10
H13320 Series
-13
-02
-03
-04
+2.8 to +5.5
+5.5
2.7
10
+1.2 (Input impedance: 1 MΩ)
+0.25 to +1.0 (Input impedance: 1 MΩ)
3.7 × 13.0
450
400
530
450
350
200
620
140
500
300
200
650
—
—
15
—
0.4
0.3
0.43
0.15
105
77
109
70
1000
400
400
300
2000
1200
2600
700
5
5
5
4.2 × 10
3.1 × 10
2.5 × 105
4.3 × 10
1
2
3
0.1
10
10
10
1
1.4
0.5
14
+5 to +50
-20 to +50
104
*1: Input voltage = +5 V, Control voltage = +1.0 V, Dark current output
*2: Control voltage = +1.0 V
*3: Measured at the peak sensitivity wavelength
*4: After 30 minutes storage in darkness
*5: Cable RG-174/U, Cable length 450 mm, Load resistance = 1 MΩ, Load capacitance = 22 pF
*6: The time required for the output to reach a stable level following a change in the control voltage from +1.0 V to +0.5 V.
*7: No condensation
-05
340
20
40
5
—
48
50
300
3.6 × 105
0.5
5
Unit
—
V
V
mA
µA
V
V
mm
nm
µA/lm
—
—
mA/W
A/lm
A/W
nA
ns
mV
s
°C
°C
g
Figure 3: Sensitivity adjustment method
Figure 4: Gain
108
VOLTAGE PROGRAMMING
TPMOB0140EG
POWER SUPPLY
PHOTOSENSOR MODULE
COAXIAL CABLE (SIGNAL OUTPUT)
LOW VOLTAGE INPUT (RED)
GND (BLACK)
Vref OUTPUT (BLUE)
Vcont INPUT (WHITE)
+3 V to +5 V
GND
107
-02/-03/-13
-01
106
+0.25 V to
+1.0 V
-05
GAIN
• Electrically insulate the
reference voltage output.
• Adjust the control voltage to
adjust the sensitivity.
GND
105
-04
RESISTANCE PROGRAMMING
104
POWER SUPPLY
PHOTOSENSOR MODULE
COAXIAL CABLE (SIGNAL OUTPUT)
LOW VOLTAGE INPUT (RED)
GND (BLACK)
Vref OUTPUT (BLUE)
Vcont INPUT (WHITE)
+3 V to +5 V
GND
CW
103
MONITOR
102
0.25 0.3
POTENTIOMETER (10 kΩ)
When using a potentiometer, adjust sensitivity while monitoring
the control voltage so it does not exceed +1.2 V.
When input voltage is +4 V or less, please set resistance of
potentiometer to 100 kΩ.
0.6
0.7 0.8 0.9 1.0 1.1 1.2
TPMOC0265EA
Figure 6: Ripple noise
TPMOB0287EA
TPMOB0288EA
Vcc = +5.0 V
Vcont = +1.0 V
LOAD RESISTANCE: 1 MΩ
LOAD CAPACITANCE: 22 pF
CONTROL VOLTAGE: +1.0 V
OUTPUT (1 mV/div.)
4
INPUT CURRENT (mA)
0.5
CONTROL VOLTAGE (V)
Figure 5: Output signal current vs. input current
5
0.4
3
2
1
0
0
1
2
3
4
5
6
7
8
9
10
OUTPUT SIGNAL CURRENT (µA)
1 (µs/div.)
Figure 7: DC linearity
20
Figure 8: Pulse linearity
TPMOB0291EA
20
TPMOB0264EA
PULSE WIDTH: 500 ns
REPETITION RATE: 1 kHz
10
Vcont = +0.5 V / +1.0 V
0
DEVIATION (%)
DEVIATION (%)
10
Vcont=+0.25 V
-10
-20
-30
0
-10
Vcont=+1.0 V
-20
Vcont=+0.5 V
-30
Vcont=+0.25 V
-40
0.01
0.1
1
CURRENT (µA)
10
100
-40
0.01
0.1
1
CURRENT (mA)
10
100
PHOTOSENSOR MODULES H13320 SERIES
Figure 9: Dimensional outlines (Unit: mm)
8.8
WINDOW
(7 × 16)
PHOTOCATHODE
53.2 ± 0.5
49.0 ± 0.5
19.7
2.1
19.0 ± 0.5
LOW VOLTAGE INPUT (+3 V to +5 V) : AWG26 (RED)
GND
: AWG26 (BLACK)
Vref OUTPUT (+1.2 V)
: AWG26 (BLUE)
Vcont INPUT (+0.25 V to +1.0 V)
: AWG26 (WHITE)
SIGNAL OUTPUT
: RG-174/U
EFFECTIVE AREA
(3.7 × 13.0 MIN.)
11.7 ± 0.2
MOUNTING
THREADED HOLE
(4 × M2 DEPTH: 4)
450 ± 20
50.8 ± 0.5
FRONT VIEW
SIDE VIEW
DETAILS OF INPUT WINDOW
TPMOA0093EA
9
7
3.7
WINDOW
13
16
18
1.5
8.8
6.0
20.5
EFFECTIVE
AREA
(3.7 × 13.0 MIN.)
7
WINDOW
9
PHOTOCATHODE
TOP VIEW
FRONT VIEW
TPMOA0018EE
RELATED PRODUCT
POWER SUPPLY FOR PHOTOMULTIPLIER TUBE MODULES C10709
The C10709 is the power supply for photomultiplier tube modules which has
5 V input voltage.
This unit can provide both the driving voltage and the control voltage. This
feature enables users to operate the modules easily.
Parameter
Output voltage
Output current
Max.
Control voltage A (variable voltage range)
Terminal connection method
Input voltage
Operating ambient temperature
Dimensions (W × H × D) B
Weight
Description / Value
±5
2.0 (+5 V), 0.2 (-5 V)
+0.25 to +1.8
Binding post
AC100 to AC240
+5 to +50
147 × 61 × 200
Approx. 1.2
Unit
V
A
V
—
V
°C
mm
kg
NOTE: AAdjust within the recommended control voltage range for the photomultiplier tube
module being used.
BExcluding protuberance
HAMAMATSU PHOTONICS K.K.
www.hamamatsu.com
HAMAMATSU PHOTONICS K.K., Electron Tube Division
314-5, Shimokanzo, Iwata City, Shizuoka Pref., 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, Bridgewater. N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218 E-mail: [email protected]
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658 E-mail: [email protected]
France: Hamamatsu Photonics France S.A.R.L.: 19, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10 E-mail: [email protected]
United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road, Welwyn Garden City, Hertfordshire AL7 1BW, United Kingdom, Telephone: (44)1707-294888, Fax: (44)1707-325777 E-mail: [email protected]
North Europe: Hamamatsu Photonics Norden AB: Torshamnsgatan 35 SE-164 40 Kista, Sweden, Telephone: (46)8-509-031-00, Fax: (46)8-509-031-01 E-mail: [email protected]
TPMO1072E01
Italy: Hamamatsu Photonics Italia S.r.l.: Strada della Moia, 1 int. 6, 20020 Arese (Milano), Italy, Telephone: (39)02-93581733, Fax: (39)02-93581741 E-mail: [email protected]
China: Hamamatsu Photonics (China) Co., Ltd.: B1201 Jiaming Center, No.27 Dongsanhuan Beilu, Chaoyang District, Beijing 100020, China, Telephone: (86)10-6586-6006, Fax: (86)10-6586-2866 E-mail: [email protected]
FEB. 2016 IP