AEROFLEX DATA EXCHANGE PROGRAM TRANSMITTAL PRODUCT CHANGE NOTICE 1. TITLE 2. DOCUMENT NUMBER MICROCIRCUIT, MEMORY, DIGITAL,CMOS, 2MEG X 39-BIT (80M), RADIATION-HARDENED DUAL VOLATGE, SRAM, MULTICHIP MODULE SPO-2012-PCN-0010 3. DATE (Year, Month, Date) 2012, OCTOBER, 04 4. MANUFACTURER NAME AND ADDRESS 5. MANUFACTURER POINT OF CONTACT NAME AEROFLEX COLORADO SPRINGS, INC. Mike Leslie 4350 CENTENNIAL BOULEVARD COLORADO SPRINGS, COLORADO 80907-3486 6. MANUFACTURER POINT OF CONTACT TELEPHONE (719) 594-8148 7. MANUFACTURER POINT OF CONTACT EMAIL [email protected] 8. CAGE CODE 9. EFFECTIVE DATE 10. PRODUCT IDENTIFICATION CODE 65342 2012,February, 15 QS14 UT8R2M39 13. SMD NUMBER 14. DEVICE TYPE DESIGNATOR 5962-10206 01, 02 15. RHA LEVELS 16. QML LEVEL 12. BLANK 11. BASE PART R Q, Q+, V 17. NON QML LEVEL 18. BLANK HiRel, Protos 19. PRODUCT CHANGE Aeroflex is working in coordination with DLA Land and Maritime to revise SMD 5962-10206, revision level A, for the following changes: Section 1.5 Radiation features (sheet 3) PREVIOUS: CORRECTED: Effective LET with no latch-up (see 4.4.4.2)...... ≥ 111 MeV-cm2/mg ……..≤ 110 MeV-cm2/mg Table 1B SEP test limits (sheet 9) PREVIOUS: All 6/ 0.8 7/ 7.5x10-8 >111 4/ Soft error rate = 6.3 x 10-7 error/bit-day assuming Adam’s 90% worst case environment, geosynchronous orbit, and 100 mil aluminum shielding. Contact the device manufacturer for detailed information. CORRECTED: All 6/ 0.8 7/ 7.5x10-8 ≤ 110 4/ Soft error rate = 7.3 x 10-7 error/bit-day assuming Adam’s 90% worst case environment, geosynchronous orbit, and 100 mil aluminum shielding. Contact the device manufacturer for detailed information. 20. DISPOSITIONARY RECOMMENDATION: 21. ADEPT REPRESENTATIVE Timothy L. Meade USE AS IS 22. ☐ SIGNATURE CONTACT MANUFACTURER ☐ REMOVE & REPLACE ☐ CHECK & ☒ USE AS IS 23. DATE 2012, October, 04 ADDED: Alternative marking as package pin one indenifier to FIGURE 1. Case outline (sheet 11). CORRECTED: Drawing of original pin one identifier corrected and Detail B added. PREVIOUS: CORRECTED: (SEE NOTE 9) ADDED: Note 9 (sheet 12): 9/. A dot may be marked on lid to indicate pin 1 index within area shown. CORRECTED: FIGURE 2. Terminal connections (sheet 13). PREVIOUS: Terminal Terminal Number Symbol 100 TOP_DQ36 101 BOT_DQ36 CORRECTED: Terminal Terminal Number Symbol 100 BOT_DQ36 101 TOP_DQ36