AEROFLEX DATA EXCHANGE PROGRAM TRANSMITTAL PRODUCT CHANGE NOTICE 1. TITLE 2. DOCUMENT NUMBER MICROCIRCUIT, MEMORY, DIGITAL,CMOS, 1MEG x 32BIT (32M), RADIATION-HARDENED, DUAL VOLTAGE SRAM with embedded EDAC, MULTICHIP MODULE SPO-2012-PCN-0008 4. MANUFACTURER NAME AND ADDRESS 5. MANUFACTURER POINT OF CONTACT NAME AEROFLEX COLORADO SPRINGS, INC. Mike Leslie 4350 CENTENNIAL BOULEVARD COLORADO SPRINGS, COLORADO 80907-3486 6. MANUFACTURER POINT OF CONTACT TELEPHONE 3. DATE (Year, Month, Date) 2012, OCTOBER, 04 (719) 594-8148 7. MANUFACTURER POINT OF CONTACT EMAIL [email protected] 8. CAGE CODE 9. EFFECTIVE DATE 10. PRODUCT IDENTIFICATION CODE 11. BASE PART 67268 June 15, 2010 QS16, QS17 UT8ER1M32M/S 12. BLANK 13. SMD NUMBER 14. DEVICE TYPE DESIGNATOR 5962-10202 01 - 04 15. RHA LEVELS 16. QML LEVEL R Q, Q+, V 17. NON QML LEVEL 18. BLANK HiRel, Proto 19. PRODUCT CHANGE Aeroflex is working in coordination with DLA Land and Maritime to revise SMD 5962-10202, revision level B, for the following changes: Section 1.5 (sheet 3) PREVIOUS with no latch-up ...................................................... > 111 MeV-cm2/mg 7/ 9/ -16 Single event upset .................................................... 6.0 x 10 errors/bit-day 8/ 9/ CORRECTED ≤ 110 MeV-cm2/mg 7/ 9/ -16 8.1 x 10 errors/bit-day 8/ 9/ Table IB and note /5 (sheet 9) PREVIOUS: Table IB. SEP test limits All 5/ Soft error rate = 6.0 x 10 5/ 5/ -16 1/ 2/ >111 error/bit-day assuming ………………. CORRECTED: Table IB. SEP test limits All 5/ Soft error rate = 8.1 x 10 5/ -16 1/ 2/ 5/ ≤110 error/bit-day assuming ………………. 20. DISPOSITIONARY RECOMMENDATION: 21. ADEPT REPRESENTATIVE Timothy L. Meade ADEPT FORM F##### REV - USE AS IS 22. ☐ SIGNATURE CONTACT MANUFACTURER ☐ REMOVE & REPLACE ☐ CHECK & ☒ USE AS IS 23. DATE 2012, October, 04 RELEASE DATE: 11/11/11 ADDED: Alternative marking as package pin one indenifier to FIGURE 1. Case outline (sheet 13). CORRECTED: Drawing of original pin one identifier corrected and Detail B added. PREVIOUS: CORRECTED: (SEE NOTE 9) ADDED: Note 9 (sheet 14): 9/. A dot may be marked on lid to indicate pin 1 index within area shown. ADEPT FORM F##### REV - RELEASE DATE: 11/11/11