S6E2D5 Series Datasheet September 16, 2015 Datasheet Errata for S6E2D5 Series 32-bit ARM® Cortex®-M4F based Microcontroller This document describes the errata for the S6E2D5 Series 32-bit ARM® Cortex®-M4F based Microcontroller datasheet. Compare this document to the device’s data sheet for a complete functional description. Contact your local Cypress Sales Representative, if you have questions. Part Numbers Affected Part Number S6E2D5 Series Page Item Description Original document code: DS709-00021-1v0-E 64 9. Handling Devices Rev. 1.0 June 25, 2015 "Sub Crystal Oscillator" should be added as indicated by the shading below. ■Surface mount type Size: More than 3.2 mm × 1.5 mm Load capacitance: Approximately 6 pF to 7 pF When the Standard setting (CCS/CCB=11001110) Load capacitance: Approximately 4 pF to 7 pF When the low power setting (CCS/CCB=00000100) ■Lead type Load capacitance: Approximately 6 pF to 7 pF When the Standard setting (CCS/CCB=11001110) Load capacitance: Approximately 4 pF to 7 pF When the low power setting (CCS/CCB=00000100) Cypress Semiconductor Corporation December 4, 2015 198 Champion Court San Jose, CA 95134 Document No. 002-05034 Rev. *A 408.943.2600 1 S6E2D5 Series Errata Document Page 92 Item 14.3.1 Current Rating Description Table 14-10 should be added as indicated by the shading below. Table 14-10 Typical and Maximum Current Consumption in Deep Standby Stop Mode, Deep Standby RTC Mode and VBAT Value Pin Frequency Parameter Symbol Conditions Unit Remarks Name (MHz) Typ Max RTC stop Power supply current ICCVBAT VBAT RTC *6 operation - RTC *7 operation 0.009 0.032 μA - 0.994 μA - 1.491 μA 1.0 1.636 μA - 2.828 μA - 4.242 μA 0.7 1.153 μA - 2.277 μA - 3.416 μA *3, *4, *5 TA=+25°C *3, *4, *5 TA=+85°C *3, *4, *5 TA=+105°C *3, *4 TA=+25°C *3, *4 TA=+85°C *3, *4 TA=+105°C *3, *4 TA=+25°C *3, *4 TA=+85°C *3, *4 TA=+105°C *1: VCC=3.3 V *2: VCC=3.6 V *3: When all ports are fixed. *4: When LVD is OFF *5: When sub oscillation is OFF *6: When using the crystal oscillator of 32 kHz (including the current consumption of the oscillation circuit) When the Standard setting (CCS/CCB=11001110) *7: When using the crystal oscillator of 32 kHz (including the current consumption of the oscillation circuit) When the low power setting (CCS/CCB=00000100) 176 15. Ordering Information Ordering Information should be corrected as indicated by the shading below. (Error) Part Number Package S6E2D55G0AGV20000 Plastic・LQFP (0.5 mm pitch), 120 pin (FPT-120P-M21) S6E2D55GJAMV20000 S6E2D55J0AGV20000 Plastic・LQFP (0.5 mm pitch), 176 pin (FPT-176P-M07) S6E2D55G0AGB30000 Plastic・PFBGA (0.5 mm pitch), 161 pin (FDJ161) S6E2D55G0AGZ20000 Plastic・Ex-LQFP (0.5 mm pitch), 120 pin (LEM120) Part Number Package S6E2D55G0AGV20000 Plastic・LQFP (0.5 mm pitch), 120 pin (FPT-120P-M21) (Correct) S6E2D55GJAMV20000 S6E2D55J0AGV20000 Plastic・LQFP (0.5 mm pitch), 176 pin (FPT-176P-M07) S6E2D55G0AGB30000 Plastic・PFBGA (0.5 mm pitch), 161 pin (FDJ161) S6E2D55G0AGE20000 Plastic・Ex-LQFP (0.5 mm pitch), 120 pin (LEM120) Rev. 2.0 September 16, 2015 December 4, 2015 Document No. 002-05034 Rev. *A 2 S6E2D5 Series Errata Document Page 11 Item 2. Features Description Note should be added as indicated by the shading below. (Error) GDC Unit Controller for external graphics display Accelerator for 2D block image transfer (blit) operations Embedded SRAM video memory High-Speed Quad SPI (Serial Peripheral Interface for external memory extensions) SDRAM interface for external memory extensions HBI (Hyper Bus Interface) interface for external memory extensions Maximum core system clock frequency : 160 MHz (Correct) GDC Unit Controller for external graphics display Accelerator for 2D block image transfer (blit) operations Embedded SRAM video memory High-Speed Quad SPI (Serial Peripheral Interface for external memory extensions) SDRAM interface for external memory extensions HBI (Hyper Bus Interface) interface for external memory extensions Maximum core system clock frequency : 160 MHz Note: User can leverage the internal VRAM and external HyperRAM as a graphics memory allowed to be written by GDC. 15 4. Packages “Packages” should be corrected as indicated by the shading below. (Error) Product Name Package S6E2D55G0A S6E2D55J0A S6E2D55GJA LQFP: FPT-120P-M21 (0.5 mm pitch) - LQFP: FPT-176P-M07 (0.5 mm pitch) - - PFBGA: FDJ161 (0.5 mm pitch) - - Ex_LQFP(TEQFP): LEM120 (0.5 mm pitch) : Supported (Correct) Product Name Package S6E2D55G0A S6E2D55J0A S6E2D55GJA LQFP: FPT-120P-M21 (0.5 mm pitch) - LQFP: FPT-176P-M07 (0.5 mm pitch) - - FBGA: FDJ161 (0.5 mm pitch) - - Ex_LQFP(TEQFP): LEM120 (0.5 mm pitch) - - : Supported : In development 16, 18 5. Pin Assignment Signal name should be corrected as below. (Error) GE_SPCSX_0 (Correct) GE_SPCSX0 (Error) GE_HBCSX_0 (Correct) GE_HBCSX0 (Error) GE_HBCSX_1 (Correct) GE_HBCSX1 21, 23, 48 6. Pin Descriptions Signal name should be corrected as below. (Error) GE_SPCSX_0 (Correct) GE_SPCSX0 (Error) GE_HBCSX_0 (Correct) GE_HBCSX0 (Error) GE_HBCSX_1 (Correct) GE_HBCSX1 December 4, 2015 Document No. 002-05034 Rev. *A 3 S6E2D5 Series Errata Document Page 67 Item 10. Block Diagram Description Signal name should be corrected as below. (Error) GE_SPCSX_0 (Correct) GE_SPCSX0 (Error) GE_HBCSX_0/1 (Correct) GE_HBCSX0/1 93 14.3 DC Characteristics “VFLASH memory Standby current” should be corrected as indicated by the shading below. (Error) Parameter Symbol Pin name VFLASH memory Standby current VFLASH memory Read current ICCVFLASH VCC VFLASH memory write/erase current Conditions Value Min Typ Max At Standby - 15 25 At Read - 9 14 13 20 At Write/Erase - 20 25 Conditions Value Min Typ Max At Standby - 15 35 At Read - 9 14 13 20 20 25 Unit Remarks μA mA 40MHz 80MHz mA (Correct) Parameter Symbol Pin name VFLASH memory Standby current VFLASH memory Read current ICCVFLASH VCC VFLASH memory write/erase current 162, 161, 14.4 AC 162 Characteristics At Write/Erase - Unit Remarks μA mA 40MHz 80MHz mA Signal name should be corrected as below. (Error) GE_SPCSX_0 (Correct) GE_SPCSX0 (Error) GE_HBCSX_0 (Correct) GE_HBCSX0 (Error) GE_HBCSX_1 (Correct) GE_HBCSX1 December 4, 2015 Document No. 002-05034 Rev. *A 4 Errata Document S6E2D5 Series Document History Page Document Title: Datasheet Errata for S6E2D5 Series 32-bit ARM® Cortex®-M4F based Microcontroller Document Number: 002-05034 Rev. ECN No. Orig. of Change ** AKIH Initial release *A 5037589 AKIH Converted to Cypress format Description of Change All trademarks or registered trademarks referenced herein are the property of their respective owners. Cypress Semiconductor 198 Champion Court San Jose, CA 95134-1709 Phone: 408-943-2600 Fax: 408-943-4730 http://www.cypress.com © Cypress Semiconductor Corporation, 2015. The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use of any circuitry other than circuitry embodied in a Cypress product. Nor does it convey or imply any license under patent or other rights. Cypress products are not warranted nor intended to be used for medical, life support, life saving, critical control or safety applications, unless pursuant to an express written agreement with Cypress. Furthermore, Cypress does not authorize its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress products in life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress against all charges. This Source Code (software and/or firmware) is owned by Cypress Semiconductor Corporation (Cypress) and is protected by and subject to worldwide patent protection (United States and foreign), United States copyright laws and international treaty provisions. Cypress hereby grants to licensee a personal, non-exclusive, non-transferable license to copy, use, modify, create derivative works of, and compile the Cypress Source Code and derivative works for the sole purpose of creating custom software and or firmware in support of licensee product to be used only in conjunction with a Cypress integrated circuit as specified in the applicable agreement. Any reproduction, modification, translation, compilation, or representation of this Source Code except as specified above is prohibited without the express written permission of Cypress. Disclaimer: CYPRESS MAKES NO WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Cypress reserves the right to make changes without further notice to the materials described herein. Cypress does not assume any liability arising out of the application or use of any product or circuit described herein. Cypress does not authorize its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress’ product in a life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress against all charges. Use may be limited by and subject to the applicable Cypress software license agreement. December 4, 2015 Document No. 002-05034 Rev. *A 5