PA1219 1800-2000 MHz. Low Noise High Dynamic Range Linear Amplifier PRELIMINARY Features (typical values) Low Cost Ceramic Surface Mount Package Typical NF ................................................ 1.1 dB. IP3 ........................................................ +40 dBm Pout ........................................................ +26 dBm Parame te r Frequency Gain Gain Flatness Reverse Isolation Typical Performance --u-- 25°C --n-- -40°C --∆ ∆ -- +70°C Typical Value M in. Value M ax. Value Units - 18 0 0 2000 MHz 15 . 0 13.0 - dB +/- 0.5 - +/- 0.7 dB - 18 . 0 - - dB G a in (d B ) v s . F r e q u e n c y 16 15 14 13 1800 1900 2000 N F (d B ) v s . F re q u e n c y 1 .5 1 .2 5 Pout @ 1dB. comp. +26 +24 - dBm 1 0 .7 5 Noise Figure VSWR (Input/Output) IP3 Supply Required 1. 1 - 1.5 1.3/1.6:1 - 1.5/1.8:1 Ratio 40 37 - dBm +12V/155 - +12V/180 v./mA 1800 dB 1900 2000 P o u t (d B m ) v s . F re q u e n c y 26 2 5 .5 25 2 4 .5 24 IP3 measured with 2 tones @+10 dBm @ 1 MHz apart Min and max values from -40 to +85 degrees C 1800 1900 2000 V S W R v s . F re q u e n c y Outline Drawings 1 .5 1 .2 5 1 1800 1900 2000 IP 3 (d B m ) v s . F r e q u e n c y SEE ATTACHED DRAWING 41 40 39 38 37 1800 1900 2000 F re q u e n c y in M H z . Maximum Ratings Storage Temperature ....... -65°C to +150°C DC Voltage .................................. +15 volts RF Input Powe....................+23 dBm.CW Heat Spreader Temperature .......... +100°C Rev: 08012001 Specifications subject to change without notice 100 Emlen Way Telford, Pa. 18969 Tel. (215) 723-6011 Fax. (215) 723-6015 PA1219 Page 2