W005 - W10 SILICON BRIDGE RECTIFIERS WOB PRV : 50 - 1000 Volts Io : 1.5 Ampere 0.39 (10.0) 0.31 (7.87) 0.22 (5.59) 0.18 (4.57) FEATURES : Glass passivated chip High case dielectric strength High surge current capability High reliability Low reverse current Low forward voltage drop Ideal for printed circuit board + - AC 1.00 (25.4) MIN. 1.10 (27.9) MIN. * * * * * * * 0.034 (0.86) 0.028 (0.71) MECHANICAL DATA : * Case : Reliable low cost construction utilizing molded plastic technique * Epoxy : UL94V-O rate flame retardant * Terminals : Plated leads solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Polarity symbols marked on case * Mounting position : Any * Weight : 1.29 grams AC - + AC 0.22 (5.59) 0.18 (4.57) 0.22 (5.59) 0.18 (4.57) Dimension in inches and (millimeter) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. RATING SYMBOL W005 W01 W02 W04 W06 W08 W10 UNIT 100 200 400 600 800 1000 Volts Maximum Recurrent Peak Reverse Voltage VRRM 50 Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts Maximum Average Forward Current 0.375" (9.5 mm) lead length IF(AV) 1.5 Amps. I FSM 50 Amps. 2 10 A2S Volts Peak Forward Surge Current Single half sine wave Superimposed on rated load (JEDEC Method) Rating for fusing ( t < 8.3 ms. ) Maximum Forward Voltage per Diode at IF = 1.0 Amp. Maximum DC Reverse Current at Rated DC Blocking Voltage Ta = 25 °C Ta = 100 °C Typical Junction Capacitance per Diode (Note 1) Typical Thermal Resistance (Note 2) Operating Junction Temperature Range Storage Temperature Range It VF 1.0 IR 10 µA IR(H) 1.0 mA CJ 14 RθJA 36 pf °C/W TJ - 50 to + 150 °C T STG - 50 to + 150 °C Notes : 1 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts. 2 ) Thermal resistance from Junction to Ambient at 0.375" (9.5 mm) lead length P.C. Board mounting. UPDATE : JANUARY 24, 2000 RATING AND CHARACTERISTIC CURVES ( W005 - W10 ) FIG.1 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT FIG.2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 50 PC Board 0.375(9.5mm) 1.2 PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD OUTPUT CURRENT, AMPERES 1.5 Copper Pads 0.22" x 0.22" (5.5 x5.5mm) 0.9 0.6 0.3 60 Hz, Resistive or Inductive load. 0 0 25 50 75 100 125 150 40 30 20 SINGLE HALF SINE WAVE (JEDEC METHOD) 10 0 175 T J = 55 ° C 1 CASE TEMPERATURE, ( ° C) 1 TJ = 25 °C Pulse Width = 300 µ s 1 % Duty Cycle 0.01 0.6 0.8 1.0 1.2 1.4 1.6 FORWARD VOLTAGE, VOLTS 6 10 20 40 60 100 FIG.4 - TYPICAL REVERSE CHARACTERISTICS REVERSE CURRENT, MICROAMPERES FORWARD CURRENT, AMPERES 20 10 0.4 4 NUMBER OF CYCLES AT 60Hz FIG.3 - TYPICAL FORWARD CHARACTERISTICS 0.1 2 1.8 10 T J = 100 °C 1.0 T J = 25 °C 0.1 0.01 0 20 40 60 80 100 120 PERCENT OF RATED REVERSE VOLTAGE, (%) 140