Tfs125C.doc version 1.2 VI TELEFILTER 12.07.00 Filter Specification TFS 125C 1/5 Measurement condition Ambient temperature TA: Input power level: Terminating impedances at fc: 23 °C 0 dBm input: output: 605 Ω -11 pF 620 Ω -11 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 125C is the maximum of the pass band attenuation amax. The maximum of the pass band attenuation amax is defined as the insertion loss ae. The centre frequence fc is the arithmetic mean value of the upper and lower frequencies at the 1 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed on 125 MHz without tolerance. The given values for the relative attenuation arel and for the group delay ripple have to be reached at the frequencies given below also if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value tolerance / limit Insertion loss (Reference level) ae max. min. Nominal frequency fN - Centre frequency fc 125,0 dB Passband ripple within ± 150 kHz Relative attenuation arel fN ..... fN ± 150 fN ± 0,4 MHz...fN ± 0,6 fN ± 0,6 MHz...fN ± 1,2 fN ± 1,2 MHz...fN ± 1,8 fN ± 1,8 MHz...fN ±3,4 fN ± 3,4 MHz...fN ±9,5 fN ± 9,5 MHz.. fN ±13 fN ± 13 MHz...fN +450 KHz MHz MHz MHz MHz MHz MHz MHz 125,0 - ± 150 kHz 1,25 max. min. min. min. min. min. min. min. 1,25 2,0 .8,0 20,0 25,0 30,0 43,0 55,0 max. 1,7 µs max. 150,0 ns max. IP3 ***) min. Input power level: MHz min. VSWR: Operating temperature range Temperature coefficient of frequency ( Tcf ) ****) Frequency inversion temperature To dB dB MHz Group delay **) Group delay rippel **) within 8,0 5,0 dB dB dB *) dB dB dB dB dB dB 2,3: 1 60,0 dB - 10 °C ... + 85 °C T.B.D T.B.D max. 10,0 dBm *) The rejection is relative to the point of maximum insertion at centre frequency **) measured with smoothing; smoothing aperture ≤ 30 KHz ***) modulation signals: fN and fN-28 MHz each of 10 dBm ****) ∆fc(Hz) = Tcf(ppm/K²) x (To - TA) ² x fCAT (MHz) Generated: Sabah Checked/Approved: VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] Vectron International, Inc. 267 Lowell Road Hudson, NH 03051 / USA Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information Tfs125C.doc version 1.2 VI TELEFILTER 12.07.00 Filter Specification TFS 125C 2/5 Construction and pin connection (All dimensions in mm) 13.3 10 11 12 9 7 8 TFS 125C M46 1 2 3 1 2 3 4 5 6 7 8 9 10 11 12 6 6.5 MAX. 5 4 10 Datecode Ground Ground Ground Ground Output RF Return Output Ground Ground Ground Ground Input Input RF Return Date code: Year+week K 1998 L 1999 M 2000 N 2001 ...... 50 Ω matching network: L2 L1 11 Input 50 Ohm 5 Output SAW C1 C2 50 Ohm 6 12 1,2,3,4,7,8,9,10 VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] Vectron International, Inc. 267 Lowell Road Hudson, NH 03051 / USA Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information Tfs125C.doc version 1.2 VI TELEFILTER 12.07.00 Filter Specification TFS 125C 3/5 Stability characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Damp heat: (cycle) 25 °C to 55°C / 95% r.H. / 10 cycles DIN IEC 68 - 2 – 30 Db 4. Resistance to solder heat (reflow): max. 2 times reflow process; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: IEC 286 - 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: Real of empty components at start: Real of empty components at start including leader: Trailer Tape (all dimensions in mm) W Po Do E : : : : 24 ± 0,3 4 ± 0,1 1,5 + 0,1 1,75 ± 0,1 F : G (min) : 11,5 ± 0,1 0,60 P2 : P1 : D1(min) : 2 12 1,5 ± 0,1 ± 0,1 ± 0,2 ± 0,2 1700 min 300 mm min 500 mm min 300 mm EMBOSSED CARRIER TAPE Do Po P2 E Ao F D1 CT W Bo G Ao Bo : : 7,1 13,9 CT : 21,5 ± 0,1 P1 COVER TAPE W 2 Reel (all dimensions in mm): A : W1 W2 (max) : : N (min) : 330 24,40 +2,0 30,4 60 C C : 13 A ± 0,5/-0.2 N W 1 The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. The marking of the filters is able to read if the view is directed on the upper side of the carrier tape with the sprocket holes on the left side of the tape. VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] Vectron International, Inc. 267 Lowell Road Hudson, NH 03051 / USA Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information Tfs125C.doc version 1.2 VI TELEFILTER 12.07.00 Filter Specification TFS 125C 4/5 Air reflow temperature conditions 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods 150 °C - 170 °C 60 sec. - 90 sec. main-heating periods over 200 °C 20 sec. - 25 sec. peak temperature 255 °C ± 5 °C Chip-mount air reflow profile 260 240 220 200 temperature / °C 180 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 140 160 180 200 220 240 time / sec. Table for temperature vs. time during the air reflow process Tolerance of temperatures: ± 5 °C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / °C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / °C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 Vectron International, Inc. 267 Lowell Road Hudson, NH 03051 / USA Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information Tfs125C.doc version 1.2 VI TELEFILTER Filter Specification 12.07.00 TFS 125C 5/5 History Version Reason of Changes 1.0 1.1 - generation of specification according to hudson specification Sabah - correction according to customer specification (Nokia) Sabah - IP3: instead of ‘No statement’ is ≥ 60 dBm - VSWR (max): instead of ≤ 2.0:1 is ≤ 2.3:1 min. 55 dB - Rejection (f ≥ fN ± 13000 KHz): instead of min. 60 dB is - Operational temperature range changed from -10 .... 80 °C to -10 ..... 85 °C - The sprocket holes: instead of the right side of the tape is on the left side of the tape (according to customer requirement, e mail from: 7. Juli.00) Sabah 1.2 VI TELEFILTER Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] Name Date 07.10.1999 27.03.2000 12.07.2000 Vectron International, Inc. 267 Lowell Road Hudson, NH 03051 / USA Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information