FX-501 Frequency Controlled Crystal Oscillator Features Surface Mount Package Reflow Process Compatible Low Phase Noise Build in PPL-Circuit Previous Vectron Model Number Output Frequency Range Standard Frequencies Typical Applications Base Stations Test Equipment Messurement C3310 10 MHz – 160 MHz 10; 25; 26; 39.3216; 52; 56; 61.44;77.76; 104 MHz 122.88; 153.6; 155.52; 160 MHz Reference Frequency Parameter Min Input frequency 2 Typ Signal Reference Level Reference Input Impedance Units Condition 100 MHz ± 2 ppm 4 Vpp kΩ HCMOS / similar sinewave Max Units Condition 160 MHz HCMOS 0.5 2 Output Frequency Parameter Min Output frequency 10 Typ Signal HCMOS Load 15.0 Rise and Fall time Duty cycle Max 40 pF 5 ns 60 % @ 15 pF 10 to 90 % @ Vs/2 htttp://www.vectron.com Vectron International•267 LowellRoad, Hudson, New Hampshire 03051•Tel:+1-88-VECTRON-1 Vectron International GmbH & Co. KG • Landstraße, 74924 Neckarbischofsheim, Germany • Tel: +49 7268 801 100 FX-501 page: 1/5 Supply Voltage (Vs) Parameter Min Typ Max Units Supply voltage [Standard] 3.135 3.3 3.465 VDC 50 mA steady state @ +25°C & 3.3VDC Units Condition Current consumption Parameter Phase Noise Condition Additional Parameters Min 3 Jitter Typ Max -90 dBc/Hz 10 Hz @ 122,88 MHz -110 dBc/Hz 100 Hz HCMOS -131 dBc/Hz 1 kHz -148 dBc/Hz 10 kHz -156 dBc/Hz 100 kHz -157 dBc/Hz 1 MHz 0.77 ps RMS Weight 9 Processing & Packing @ 10Hz .. 150kHz g Handling & processing note Operating temperature range -20 +70 °C Operable temperature range -30 +85 °C Storage temperature range -55 +125 °C Typical Phase Noise and Jitter 10 MHz; HCMOS output 122,88MHz; HCMOS output Frequency range [Hz] Jitter [ps rms] Frequency range [Hz] Jitter [ps rms] 10Hz to 100kHz 0.708ps 10Hz to 150kHz 0.755ps htttp://www.vectron.com Vectron International•267 LowellRoad, Hudson, New Hampshire 03051•Tel:+1-88-VECTRON-1 Vectron International GmbH & Co. KG • Landstraße, 74924 Neckarbischofsheim, Germany • Tel: +49 7268 801 100 FX-501 page: 2/5 Enclosure Type G218B Input : Single ended (HCMOS or Sinewave) Output : Single ended HCMOS Height “H” Pin Length “L” 5.9 NA Dimensions : mm Pin Connections Description 1 Ref. Frequency in High stable input frequency for syncronisation 2 VCXO Control Test output of the control voltage for the VCXO Only for modul test or observance 3 GND Ground connection. Keep traces physically short and connect immediately to ground plane for best performance 4 RF-OUT RF syncronised output. 5 Lock Detector Output Test output signal for PLL lock detected. High signal PLL in lock Low signal PLL out of lock Only for modul test or observance 6 Vs Power Supply Pin Marking FX-501 Frequency ● AYYWW Parameter Absolute Maximum Ratings Max Units Supply voltage (Vs) Min Typ 6.0 V Maximum output load @ CMOS 40 pF Condition htttp://www.vectron.com Vectron International•267 LowellRoad, Hudson, New Hampshire 03051•Tel:+1-88-VECTRON-1 Vectron International GmbH & Co. KG • Landstraße, 74924 Neckarbischofsheim, Germany • Tel: +49 7268 801 100 FX-501 page: 3/5 Block Diagram VCXO Control VS 1 VS Reference Frequency 4 VCXO 8 5 Loop Filter PLL Circuit VS VCXO 0 VS 5 VCXO 4 0 1 8 0 Lock Detector Standard Shipping Methode Lage im Gurt Position in tape Pin 1 A Abwickelrichtung Unwinding direction X B P Gurtunterseite Tape buttom side K Gurtoberseite Tape upper side *bei W ≤ 24 mm nur untere Lochreihe ∗by W ≤ 24 mm only lower hole line Production tolerance complying DIN IEC 286-3 Enclosure Type Tape width W [mm] Quantity per meter Quantity per reel Dimension P G218B tbd tbd 850 tbd Notes: 1 Contact factory for improved stabilities or additional product options. Not all options and codes are available at all frequencies. 2 Unless otherwise stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25°C) 3 Phase noise degrades with increasing output frequency. 4 Subject to technical modification. 5 Contact factory for availability. htttp://www.vectron.com Vectron International•267 LowellRoad, Hudson, New Hampshire 03051•Tel:+1-88-VECTRON-1 Vectron International GmbH & Co. KG • Landstraße, 74924 Neckarbischofsheim, Germany • Tel: +49 7268 801 100 FX-501 page: 4/5 Recommanded Reflow Profile Profile Feature Pb-Free Assembly/ Sn-Pb Assembly Profile Feature Pb-Free Assembly/ Sn-Pb Assembly Average ramp-up rate (TL to Tp) 3°C/second max. Time 25°C to Peak Temperature 8 minutes max. 150°C 200°C 60-180 seconds Time maintainted above -Temperature (TL) -Time (tL) 217°C 60-150 seconds Preheat -Temperature Min TSmin -Temperature Min Tsmax -Time (min to max) tS TSmax to TL-Ramp-up Rate 3°C/second max Time maintainted above -Temperature (TL) -Time (tL) 217°C 60-150 seconds Time within 5°C of actual Peak Temperature (tP) 20-40 seconds Peak Temperature (TP) max 260°C Ramp-down Rate 6°C/ second max Note: All temperatures refer to topside of the package, measured on the package body surface. SMD oscillators must be on the top side of the PCB during the reflow process How to order this product: Use this worksheet to forward the following information to your factory representative: Model Height - Supply Voltage Code RF Output Code Temperature Range - FX-401 1 - E A J - Height: 1: 5,9 mm RF Output Code: Supply Voltage Code: HCMOS E: 3,3 V A: Reference Frequency - Output Frequency - Temperature Range: H: -30...+85°C J: -20...+70°C htttp://www.vectron.com Vectron International•267 LowellRoad, Hudson, New Hampshire 03051•Tel:+1-88-VECTRON-1 Vectron International GmbH & Co. KG • Landstraße, 74924 Neckarbischofsheim, Germany • Tel: +49 7268 801 100 FX-501 page: 5/5