VECTRON TFS210C

tfs210c.doc
version 1.6
09.08.2001
______________________________________________________________________________________________________
VI
TELEFILTER
Filter Specification
TFS 210 C
1/5
______________________________________________________________________________________________________
Measurement Condition
23 C
0 dBm
Ambient temperature:
Input power level:
Terminating impedances *
Input:
Output:
295
295
|| 1,15 pF
|| 1,15 pF
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 210 C is the minimum of the pass band attenuation amin. The minimum of the pass
band attenuation amin is defined as the insertion loss ae . The centre frequency fc is the arithmetic mean value of the upper and lower frequencies
at the 3 dB filter attenuation level relative to the insertion loss a e. The nominal frequency fN is fixed on 210,38 MHz without tolerance. The given
values for the relative attenuation a rel and for the group delay ripple have to be reached at the frequencies given below also if the centre
frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance
for the centre frequency fc.
D a t a
typ. Value
Insertion Loss
(Reference level)
ae = amin
Nominal Frequency
fN
3 dB - Band Width
BW
Relative Attenuation
fN ± 0
kHz ... fN ± 13
fN ± 13
kHz ... fN ± 15
kHz
kHz
fN
fN
fN
fN
fN
fN
kHz
kHz
MHz
MHz
MHz
± 60
± 60
± 120
+ 420
+ 1,25
- 420
kHz
kHz ...
kHz ...
kHz ...
MHz ...
kHz ...
fN
fN
fN
fN
fN
± 120
± 420
+ 1,25
+ 2,05
2,05
Group Delay Distortion
fN ± 0
kHz ... fN ± 11
arel
Variation/ Limitation
6,6 dB
max. 8,0 dB
54
210,38 MHz
kHz
min. 30
23
-
kHz
max. 1,5 dB
max. 3
dB
dB
min.
min.
min.
min.
min.
min.
20
20
40
50
55
60
dB
dB
dB
dB
dB
dB
max. 9
µs
GDD
kHz
-
Temperature Coefficient of Frequency
TCf **
Frequency Inversion Temperature
T0
Operating Temperature Range
- 0,036 ppm/K
+ 25
°C
2
- 10°C ... + 60°C
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
**)
reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz)
Generated:
Checked / approved:
______________________________________________________________________________________________________
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603)
598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs210c.doc
version 1.6
09.08.2001
______________________________________________________________________________________________________
VI
TELEFILTER
Filter Specification
TFS 210 C
2/5
______________________________________________________________________________________________________
Construction and Pin Configuration
(All dimensions in mm)
1
2
3
4
5
6
7
8
9
10
S 210 C
N32
Datecode
Output
Ground
Ground
Ground
Ground
Ground
Input
Ground
Ground
Ground
Datecode
L
M
N
...
50
Year + week
1999
2000
2001
test circuit 1
L1
L2
7
1
C1
C2
2,3,4,5,6,8,
9,10,11,12
50
test circuit 2
C1
C2
1
7
L1
L2
2,3,4,5,6,8,
9,10,11,12
______________________________________________________________________________________________________
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603)
598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs210c.doc
version 1.6
09.08.2001
______________________________________________________________________________________________________
VI
TELEFILTER
Filter Specification
TFS 210 C
3/5
______________________________________________________________________________________________________
Stability Characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 1,5 mm or 20g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each. / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
max. 2 times reflow process;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
Reel of empty components at start:
Reel of empty components at start including leader:
Trailer
Tape (all dimensions in mm)
W
:
16
± 0,3
Po
:
4
± 0,1
Do
:
1,5
+ 0,5
+ 0,5
D1
:
1,5
E
:
1,75 ± 0,1
F
:
7,5 ± 0,1
G (min) :
P2
:
2
± 0,05
:
8
± 0,1
D1(min) :
1,5
Ao
5,5
Bo
EMBOSSED CARRIER TAPE
Do
Po
P2
E
Ao
:
:
F
D1
13,4
± 0,1
W
Bo
0,6
P1
3000
min 300 mm
min 500 mm
min 300 mm
G
P1
± 0,1
7,5
± 0,1
COVER TAPE
W 2
Reel (all dimensions in mm):
A
:
330
W1
:
W2 (max) :
16,4 +2
22,4
N (min)
:
50
C
:
13
+ 0,5 / - 0,2
C
A
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
The marking of the filters is able to read if the view is directed on the upper side of the carrier tape with the sprocket holes on the
right side of the tape.
______________________________________________________________________________________________________
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603)
598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs210c.doc
version 1.6
09.08.2001
______________________________________________________________________________________________________
VI
TELEFILTER
Filter Specification
TFS 210 C
4/5
______________________________________________________________________________________________________
Air reflow Temperature Conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
______________________________________________________________________________________________________
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603)
598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
tfs210c.doc
version 1.6
09.08.2001
______________________________________________________________________________________________________
VI
TELEFILTER
Filter Specification
TFS 210 C
5/5
______________________________________________________________________________________________________
History
Version
Reason of Changes
Name
Date
1.6
Add “History”
Add “50 test circuit”
Correct “Tape and reel” information
Herrler
09.08.2001
______________________________________________________________________________________________________
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603)
598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.