Non-promotional not for new designs FTR-K1 SERIES POWER RELAY 1 POLE - 20/25/30A - Heavy power control VF Series FEATURES UL, CSA, VDE recognized TV-15 rated 1 form A contact (SPST-NO) Heavy duty 20 to 30A small power relay High inrush current and high surge voltage - Inrush current 65A - Surge strength 10,000V Printed circuit coil terminals type available Small package meets high density mounting requirement Flux proof sealing, RTII RoHS Compliant Please see page 7 for more information PARTNUMBER INFORMATION [Example] VF (a) B - 6 (b) (*) (c) H (d) U (e) (a) Relay type VF : VF Series (b) Terminal Nil B : Top -- All tab-terminal : Top -- Tab terminal (contacts) Bottom -- PCB terminal (coil and movable contact) : Top -- Tab terminal (coil) Screw tight terminal (contacts) : Top -- Screw tight terminal (contacts) Bottom -- PCB terminal (coil and movable contact) D P (c) Coil rated voltage 6 : 3....60VDC Coil rating table at page 3 (d) Contact rating H M L : 30A (applicable for D.P.) : 25A : 20A (e) Approvals U : UL, CSA, VDE rating acquired Note: Actual marking omits hyphen (-) of (*) 1 FTR-K1 SERIES VF SERIES SPECIFICATION Item Contact Data Timing Data Insulation VFD, VFP - ( ) H VF ( ) - ( ) M VF ( ) - ( ) L Construction Single Material Silver alloy (AgSnO2 ; AgSnOInO) Resistance (initial) Max. 30mOhm at 1A, 6VDC Resistive 30A, 250VAC 25A, 250VAC 20A, 250VAC Motor 2HP, 250VAC 1.5HP, 250VAC 1HP, 250VAC Max. carrying current 30A 25A 20A Max. switching voltage 250VAC Max. switching power 7,500VA 6,250VA 5,000VA Max. switching current 30A 25A 20A Min. switching load * 1A, 10V Mechanical Min. 5 x 106 operations Resistive load Min. 100 x 103 operations Motor load Min. 200 x 103 operations Rated Power (at 20 ° C) 1,200 to 1,250mW Operate Power (at 20 ° C) 590 to 620mW Operating temperature range -30 to +65 °C (no frost) Operate (at nominal voltage) Max. 20ms Release (at nominal voltage) Max. 5ms (without diode) Resistance (Initial) Min. 1,000MOhm at 500VDC Dielectric strength Surge strength Other 20A type 1 form A (SPST-NO) Electrical (at contact rating) Coil Data 25A type Configuration Contact rating Life 30A type Vibration Resistance Shock Open contacts 1,200VAC (50/60Hz) 1min. Coil and contacts 4,000VAC (50/60Hz) 1min. Coil and contacts 10.000V/ 1.2 x 50μs standard wave Misoperation 10 to 55Hz double amplitude 1.5mm Endurance 10 to 55Hz double amplitude 1.5mm Misoperation Min. 200m/s² (11 ± 1ms) Endurance Min. 1,000m/s² (6 ± 1ms) Weight Approximately 55 g Sealing Flux proof (RTII) * Minimum switching loads mentioned above are reference values. Please perform the confirmation test with actual load before production since reference values may vary according to switching frequencies, environmental contions and expected reliability levels. 2 FTR-K1 SERIES VF SERIES COIL RATING Coil Code Rated Coil Voltage (VDC) Coil Resistance +/- 10% (Ohm) Must Operate Voltage (VDC) * Must Release Voltage (VDC) * Rated Power (mW) 3 3 7.5 2.1 0.3 1,200 5 5 20 3.5 0.5 1,250 6 6 30 4.2 0.6 9 9 67 6.3 0.9 12 12 120 8.4 1.2 18 18 270 12.6 1.8 24 24 480 16.8 2.4 48 48 1,920 33.6 4.8 60 60 3,000 42.0 6.0 1,200 Note: All values in the table are valid for 20°C and zero contact current. * Specified operate values are valid for pulse wave voltage. SAFETY STANDARDS Type Compliance Contact rating UL UL 508 873 Flammability: UL 94-V0 (plastics) E56140 CSA C22.2 No. 14 LR 35579 VDE 0435 40017717 VF - ( ) - ( ) L 20A, 250VAC (resistive) 1HP, 250VAC/125VAC TV-15, 120VAC VF - ( ) - ( ) M 25A, 250VAC (resistive) 1.5HP, 250VAC TV-15, 120VAC VFD, VFP - ( ) - H 30A, 250VAC (resistive) 2HP, 250VAC TV-15, 120VAC VF-(-;B)-LU: 20A, 250VAC resistive: 100K 15A, 250VAC cos φ 0.7: 100K VF-(-;B)-HU: 30A, 250VAC resistive: 100K 22.5A, 250VAC cos φ 0.7: 100K 3 FTR-K1 SERIES FTR-F1 VF SERIES SERIES CHARACTERISTIC DATA REFERENCE DATA 4 FTR-K1 SERIES VF SERIES DIMENSIONS Dimensions Schematics (TOP VIEW) PC board mounting hole layout (TOP VIEW) VF-type VFB-type Unit: mm 5 FTR-K1 SERIES VF SERIES DIMENSIONS Dimensions Schematics (TOP VIEW) PC board mounting hole layout (TOP VIEW) VFD-type VFP-type Unit: mm 6 FTR-K1 SERIES VF SERIES RoHS Compliance and Lead Free Information 1. General Information All signal and power relays produced by Fujitsu Components are compliant with RoHS directive 2002/95EC including amendments. Cadmium as used in electrical contacts is exempted from the RoHS directives on October 21st, 2005. (Amendment to Directive 2002/95/EC) All of our signal and power relays are lead-free. Please refer to Lead-Free Status Info for older date codes at: http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specified. This material has been verified to be compatible with PbSn assembly process. 2. Recommended Lead Free Solder Profile Recommended solder Sn-3.0Ag-0.5Cu. Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C solder bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity Moisture Sensitivity Level standard is not applicable to electromechanical relays, unless otherwise indicated. 4. Tin Whiskers Dipped SnAgCu solder is known as presenting a low risk to tin whisker development. No considerable length whisker was found by our in house test. 7 FTR-K1 SERIES VF SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: [email protected] Web: www.fcl.fujitsu.com Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: [email protected] Web: emea.fujitsu.com/components/ North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: [email protected] Web: http://us.fujitsu.com/components Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: [email protected] Web: http://www.fujitsu.com/sg/services/micro/components/ ©2011 Fujitsu Components Europe B.V. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. The contents, data and information in this datasheet are provided by Fujitsu Component Ltd. as a service only to its user and only for general information purposes. The use of the contents, data and information provided in this datasheet is at the users’ own risk. Fujitsu has assembled this datasheet with care and will endeavor to keep the contents, data and information correct, accurate, comprehensive, complete and up to date. Fujitsu Components Europe B.V. and affiliated companies do however not accept any responsibility or liability on their behalf, nor on behalf of its employees, for any loss or damage, direct, indirect or consequential, with respect to this datasheet, its contents, data, and information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. Nor do Fujitsu Components Europe B.V. and affiliated companies accept on their behalf, nor on behalf of its employees, any responsibility or liability for any representation or warrant of any kind, express or implied, including warranties of any kind for merchantability or fitness for particular use, with respect to these datasheets, its contents, data, information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. Rev. March 02, 2011 8