VECTRON TFS150T

Filename: tfs 150t.doc
Version 1.2
VI TELEFILTER
20.09.2005
Filter specification
TFS 150T
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0
°C
dBm
55 Ω || -21,9 pF
55 Ω || -17,7 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS150T is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The reference frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The temperature coefficient of frequency Tcf is valid both for the reference frequency fc and the
frequency response of the filter in the operating temperature range. The bandwidth shift of the filter in the operating temperature range is included in the
production tolerance scheme.
Data
typ. value
Insertion loss
(reference level)
ae
24,1
Nominal frequency
fN
-
Centre frequency
fC
150,0
PB
Passband
max.
25
150,0
fN
±
dB
150,0
MHz
± 0,1
MHz
8,05
MHz
dB
dB
max.
1,0
16,62
17,11
17,54
MHz
MHz
MHz
min.
max.
max.
16,5
17,2
18,4
MHz
MHz
MHz
2,5
20
35
48
53
55
2,8
dB
dB
dB
dB
dB
dB
µs
max.
min.
min.
min.
min.
min.
max.
3
15
30
45
50
50
4
dB
dB
dB
dB
dB
dB
µs
80
ns
max.
150
ns
BW
Bandwidth
3
dB
15
dB
45
dB
Relative attenuation
fC
… fC ±
8,60 MHz … fC ±
fC ±
8,80 MHz … fC ±
fC ±
9,20 MHz … fC ±
fC ±
10
MHz … fC +
fC +
140
MHz … fC fC Absolute group delay within PB
MHz
0,7
Pass band ripple (p-p)
dB
tolerance / limit
8,25
8,80
9,20
10
400
10
arel
MHz
MHz
MHz
MHz
MHz
MHz
Group delay ripple within PB (p-p)
Operating temperature range
OTR
- 25 °C ... + 80°C
-
Storage temperature range
Temperature coefficient of frequency
-
TCf **
-87
- 40 °C ... + 85°C
ppm/K
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fCAT (MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 150t.doc
Version 1.2
VI TELEFILTER
20.09.2005
Filter specification
TFS 150T
2/5
0
3.86
-1
3.74
-16
-2
3.62
-24
-3
3.5
-32
-4
3.38
-5
3.26
-6
3.14
-56
-7
3.02
-64
-8
2.9
-72
-9
2.78
-40
-48
-80
131
134.8
138.6
142.4
146.2
150
153.8
frequency in MHz
157.6
161.4
165.2
169
-10
141
142.8
144.6
146.4
148.2
150
151.8
frequency in MHz
153.6
155.4
157.2
delay in µs
0
-8
magnitude in dB
magnitude in dB
Filter characteristic
2.66
159
Construction and pin connection
(All dimensions in mm)
TFS 150T
●
T39
Date code
1
2
3
4
9,10,11,12
13
14
15
16
21,22,23,24
Ground
Input RF Return
Input
Ground
Ground
Ground
Output RF Return
Output
Ground
Ground
Date code:
T
U
V
...
Year + week
2005
2006
2007
50 Ohm Test circuit
L
C
L
2
2
L
15
3
SAW
14
L
4
C
1, 4, 9, 10, 11, 12, 13, 16,
21, 22, 23, 24
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 150t.doc
Version 1.2
VI TELEFILTER
Filter specification
20.09.2005
TFS 150T
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan,
3 plans; DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4;
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 150t.doc
Version 1.2
VI TELEFILTER
20.09.2005
Filter specification
TFS 150T
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 150t.doc
VI TELEFILTER
Version 1.2
Filter specification
20.09.2005
TFS 150T
5/5
History
Version
Reason of changes
Name
Date
1.0
- generation of development specification
Strehl
27.06.2005
1.1
- change remark of characteristics, passband and limit for centre frequency
Strehl
10.08.2005
1.2
- terminating impedance, typical values, filter characteristic and matching configuration added Pfeiffer
20.09.2005
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.