VECTRON TFS149C

Filename: tfs 149c.doc
Version 1.2
VI TELEFILTER
06.04.2005
Filter specification
TFS 149C
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0.
°C
dBm
18 Ω || -4,5 pF
33 Ω || -6,3 pF
Characteristics
Remark: Reference level for the relative attenuation arel of the TFS149C is the minimum of the pass band attenuation amin. The minimum of the pass
band attenuation amin is defined as the insertion loss ae. The reference frequency fc is the arithmetic mean value of the upper and lower frequencies at the
28 dB filter attenuation level relative to the insertion loss ae. The temperature coefficient of frequency Tcf is valid both for the reference frequency fc and the
frequency response of the filter in the operating temperature range. The bandwidth shift of the filter in the operating temperature range is included in the
production tolerance scheme.
Data
Insertion loss (reference level)
ae = amin
Centre frequency at ambient temperature TA
fc
Pass band
PB
typ. value
tolerance / limit
25
dB
max.
MHz
149,9 ± 0,1
dB
max.
1,2
-
min.
min.
14,1
14,4
MHz
MHz
-
max.
max.
max.
15,2
15,3
17
MHz
MHz
MHz
dB
dB
max.
max.
1,2
3
38
50
45
51
53
44
50
45
35
60
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
min.
min.
min.
min.
min.
min.
min.
min.
min.
min.
28
43
40
48
48
42
48
43
28
50
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
2,9
150
µs
ns
max.
4
max. 200
µs
ns
- 81
ppm/K
149,9
0,7
Pass band ripple ( p–p ) :
fC
26
± 7,1
dB
MHz
MHz
dB
Bandwidth within operating temperature range
1,2 dB
3
dB
28
43
48
dB
dB
dB
arel
Relative attenuation
fC
... fC ±
fC ± 7,05 MHz ... fC ±
fC + 7,6
fC + 7,9
fC + 8,5
fC +11
fC - 22,9
fC - 14
fC - 13
fC - 8,5
fC - 7,8
fC ±22,9
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
...
...
...
...
...
...
...
...
...
...
fC +
fC +
fC +
fC +
fC fC fC fC fC fC ±
7,05 MHz
7,2 MHz
7,9
8,5
11
22,9
14
13
8,5
7,8
7,6
95
0,7
2,5
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
MHz
Group delay ( mean value in PB )
Group delay ripple in PB:
Temperature coefficient of frequency
Frequency deviation of fc over temperature
Tcf
dB
dB
-
∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fCTA (MHz)
Operating temperature range
-
- 25 °C ... + 80 °C
Storage temperature range
-
- 40 °C ... + 85 °C
*) The terminating impedances depend on parasites and q-values of matching elements and the board used, and are to be understood as reference values
only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
generated:
checked / approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 149c.doc
Version 1.2
VI TELEFILTER
06.04.2005
Filter specification
TFS 149C
2/5
0
4.17
-8
-1
4.02
-16
-2
3.87
-24
-3
3.72
-4
3.57
-5
3.42
-6
3.27
-56
-7
3.12
-64
-8
2.97
-72
-9
2.82
-32
-40
-48
-80
100
110
120
130
140
150
160
frequency in MHz
170
180
190
200
delay in µs
0
magnitude in dB
magnitude in dB
Filter characteristic
2.67
-10
142 143.6 145.2 146.8 148.4 150 151.6 153.2 154.8 156.4 158
frequency in MHz
Construction and pin connection
(All dimensions in mm)
13 Max.
35 Max.
TFS 149C
●
T16
4,5 Max.
Date code
ø 0,45
5,2 Max.
0,25
ø1
1
9
24
Ground
Input RF Return
Input
Ground
Ground
Ground
Output RF Return
Output
Ground
Ground
Date code:
T
U
V
...
Year + week
2005
2006
2007
12
7,62
4
1
2
3
4
9,10,11,12
13
14
15
16
21,22,23,24
16 13
21
2,54
11X2,54=27,94
50 Ohm Test circuit
3
15
SAW
C1
L1
2
C2
14
L2
1, 4, 9, 10, 11, 12, 13, 16, 21, 22,
23, 24
alternative:
L1
3
15
L2
SAW
C1
2
14
C2
1, 4, 9, 10, 11, 12, 13, 16, 21,
22, 23, 24
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 149c.doc
Version 1.2
VI TELEFILTER
Filter specification
06.04.2005
TFS 149C
3/5
Stability characteristics :
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 149c.doc
Version 1.2
VI TELEFILTER
06.04.2005
Filter specification
TFS 149C
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 149c.doc
VI TELEFILTER
Version 1.2
Filter specification
06.04.2005
TFS 149C
5/5
History :
Version
Reason of changes
Name
Date
1.0
- generate development specification
Steiner
21.02.2005
1.1
- correct attenuation according to customer request
Steiner
22.02.2005
1.2
- terminating impedance, typical values and filter characteristic added
- matching configuration modified
Pfeiffer
06.04.2005
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.