S358 Semiconductor Low Power Dual OP AMP Description The S358 consists of two independent high gain Internally frequency compensated operational amplifiers designed to operate from a single power supply over a wide range of voltage. Features • • • • • • Input common mode voltage range includes ground Internally frequency compensated for unity gain Large DC voltage gain : 100dB Wide bandwidth for unity gain : 1 MHz Very low power consumption Wide supply voltage range : Single : 3V ~ 30V, Dual : ±1.5 ~ ±15V Applications • Transducer amplifier • DC gain blocks • Conventional operational amplifiers Ordering Information Type NO. S358 Marking Package Code S358 SOP-8 Outline Dimensions unit : mm Block Diagram KSI-8001-003 1 S358 Absolute maximum ratings Characteristic Symbol Ratings Unit Supply voltage VCC 36 or ±18 V Differential input voltage VIND 32 V Input voltage VIN -0.3 ~ +32 V Power Dissipation PD 300 mW Operating temperature Topr -45 ~ +85 °C Storage temperature Tstg -55 ~ 150 °C Electrical Characteristics (Unless otherwise specified. VCC = 5V and –45 °C ≤ Ta ≤ +85 °C) Characteristic Input offset voltage Input offset voltage drift Input offset current Input offset current drift Input bias current Symbol VIOS ∆VIOS/∆T IIB ±2 ±7 Rg = 0Ω, 0V ≤ VIC ≤ VCC-1.5V - - ±9 Rg = 0Ω - 7 - - ±5 ±50 (Ta=25 °C) - ICC Large signal voltage gain GV VOH VOL - - 10 - - 45 250 - 40 500 0 - 0 - VCC = 30V, RL = ∞ - 1 2 VCC = 5V, RL = ∞ - 0.7 1.2 25 100 - 15 - - - (Ta=25 °C) VCC = 30V mV µV/ °C nA pA/ °C nA V V mA (Ta=25 °C) VCC = 30V RL=2 KΩ 26 - - RL=10 KΩ 27 28 - - 3 20 mV VCC =5V, RL ≤10 KΩ V/mV V CMRR (Ta=25 °C) 65 90 - dB PSRR (Ta=25 °C) 65 100 - dB 20 40 - 10 20 - 10 20 - 5 8 - 12 50 - µA - 40 60 mA IO+ VCC = 15V IO- ISC (Ta=25 °C) VIN+ = 1V, VIN- = 0V (Ta=25 °C) VIN+ = 0V, VIN- = 1V VOUT = 200mV, VIN+ = 0V, VIN- = 1V Output short circuit to ground VCC –1.5 VCC –2 Unit VCC = 15V RL ≥ 2 KΩ VCC = 15V Output sink current ±150 - (Ta=25 °C) Supply current Output source current (Ta=25 °C) Min. Typ. Max. - ∆IIOS/∆T VICR Common mode rejection ratio Power supply rejection ratio 5V ≤ VCC ≤ 30V IIOS Input common mode voltage range Output voltage swing Test Condition Ta=25 °C KSI-8001-003 (Ta=25 °C) mA mA 2 S358 Electrical Characteristic Curves Fig. 1 ICC-VCC Fig. 2 IIB-VCC Fig. 3 VIOS-Ta Fig. 4 IO-Ta Fig. 5 CMRR-f Fig. 6 VOR-f KSI-8001-003 3 S358 These AUK products are intended for usage in general electronic equipments(Office and communication equipment, measuring equipment, domestic electrification, etc.). Please make sure that you consult with us before you use these AUK products in equipments which require high quality and/or reliability, and in equipments which could have major impact to the welfare of human life(atomic energy control, airplane, spaceship, traffic signal, combustion central, all types of safety device, etc.). AUK cannot accept liability to any damage which may occur in case these AUK products were used in the mentioned equipments without prior consultation with AUK. KSI-8001-003 4