RL101F THRU RL107F FAST SWITCHING PLASITC RECTIFIER Reverse Voltage - 50 to 1000 Volts Forward Current - 1.0 Ampere Features Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Fast switching for high efficiency Construction utilizes void-free molded plastic technique 1.0 ampere operation at TA=55 with no thermal runaway High temperature soldering guaranteed: 250 /10 seconds, 0.375(9.5mm) lead length, 5 lbs. (2.3kg) tension Maximum Ratings DIM ENSIONS Case: A-405 molded plastic body Terminals: Plated axial leads, solderable per MIL-STD-750, method 2026 Polarity: Color band denotes cathode end Mounting Position: Any Weight: 0.008 ounce, 0.23 gram DIM Maximum Ratings and Electrical Characteristics Symbols inches mm Min. Max. Min. Max. A 0.165 0.205 4.2 5.2 B 0.079 0.106 2.0 2.7 C 0.020 0.024 0.5 0.6 D 1.000 - 25.40 - @25 Note unless otherwise specified RL101F RL102F RL103F RL104F RL105F RL106F RL107F Units Maximum repetitive peak reverse voltage VRRM 50 100 200 400 600 800 1000 Maximum RMS voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC blocking voltage VDC 50 100 200 400 600 800 1000 Volts Average forward current at TA=55 I(AV) 1.0 Amp Peak forward surge current 8.3mS single half sine-wave IFSM 30.0 Amps Maximum instantaneous forward voltage at IFM=1.0A; TJ=25 (Note 3) VF 1.30 Volts Maximum DC reverse current at rated DC blocking voltage IR 5.0 100.0 A TJ=25 TJ=100 Maximum reverse recovery time (Note 1) Trr Typical junction capacitance (Note 2) CJ Maximum thermal resistance Operating and storage temperature range R 150 JL TJ, TSTG 250 1 nS 15.0 F 50 /W -65 to +175 Notes: (1) Reverse recovery test conditions: IF=0.5A, IR=1.0A, Irr=0.25A (2) Measured at 1.0MHz and applied reverse voltage of 4.0 volts (3) Pulse test: pulse width 300uSec, Duty cycle 2% 500 Volts RATINGS AND CHARACTERISTIC CURVES 2 RATINGS AND CHARACTERISTIC CURVES 3