2.0x1.25mm SMD CHIP LED LAMP APT2012MGC MEGA GREEN Description Features 2.0mmx1.25mm SMT LED,0.75mm THICKNESS. The Mega Green source color devices are LOW POWER CONSUMPTION. made with DH InGaAlP on GaAs substrate Light WIDE VIEWING ANGLE. Emitting Diode. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAA7633 REV NO: V.5 DATE: MAR/12/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001819 Selection Guide Part No. Dice APT2012MGC Iv (mcd) @ 20mA Lens Type MEGA GREEN (InGaAlP) Viewing Angle Min. Typ. 2θ θ1/2 18 70 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Mega Green λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 574 nm IF=20mA Mega Green 568 nm IF=20mA Spectral Line Half-width Mega Green 26 nm IF=20mA C Capacitance Mega Green 20 pF VF=0V;f=1MHz VF Forward Voltage Mega Green 2.1 2.5 V IF=20mA IR Reverse Current Mega Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Mega Green Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA7633 REV NO: V.5 DATE: MAR/12/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001819 Mega Green APT2012MGC SPEC NO: DSAA7633 REV NO: V.5 DATE: MAR/12/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001819 APT2012MGC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAA7633 REV NO: V.5 DATE: MAR/12/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001819