PRELIMINARY DATA SHEET NPN SILICON HIGH FREQUENCY TRANSISTOR FEATURES UPA810TF OUTLINE DIMENSIONS (Units in mm) • SMALL PACKAGE OUTLINE: SOT-363 package measures just 2 mm x 1.25 mm • LOW HEIGHT PROFILE: Just 0.60 mm hight • HIGH COLLECTOR CURRENT: IC MAX = 100 mA PACKAGE OUTLINE TS06 (Top View) 2.1 ± 0.1 1.25 ± 0.1 0.65 DESCRIPTION 1 6 2 5 3 4 2.0 ± 0.2 The UPA810TF contains two NE856 NPN high frequency silicon bipolar chips. NEC's new low profile TF package is ideal for all portable wireless applicatons where reducing component height is a prime consideration. Each transistor chip is independently mounted and easily configured for two stage cascade LNAs and other similar applications. 0.6 ± 0.1 0.45 ABSOLUTE MAXIMUM RATINGS1 (TA = 25°C) SYMBOLS PARAMETERS UNITS RATINGS VCBO Collector to Base Voltage V 20 VCEO Collector to Emitter Voltage V 12 VEBO Emitter to Base Voltage V 3 IC Collector Current mA 100 PT Total Power Dissipation 1 Die 2 Die mW mW 110 200 TJ Junction Temperature °C 150 TSTG Storage Temperature °C -65 to +150 +0.10 0.22 - 0.05 (All Leads) 1.3 0.13 ±0.05 0 ~ 0.1 PIN OUT 1. Collector Transistor 1 2. Base Transistor 2 3. Collector Transistor 2 4. Emitter Transistor 2 5. Emitter Transistor 1 6. Base Transistor 1 Note: Pin 1 is the lower left most pin as the package lettering is oriented and read left to right. Note: 1.Operation in excess of any one of these parameters may result in permanent damage. ELECTRICAL CHARACTERISTICS (TA = 25°C) PART NUMBER PACKAGE OUTLINE SYMBOLS UPA810T S06 PARAMETERS AND CONDITIONS UNITS ICBO Collector Cutoff Current at VCB = 10 V, IE = 0 µA IEBO Emitter Cutoff Current at VEB = 1 V, IC = 0 µA hFE Forward Current Gain1 at VCE = 3 V, IC = 7 mA fT Gain Bandwidth at VCE = 3 V, IC = 7 mA GHz Feedback Capacitance2 at VCB = 3 V, IE = 0, f = 1 MHz pF |S21E|2 Insertion Power Gain at VCE = 3 V, IC =7 mA, f = 1 GHz dB Noise Figure at VCE = 3 V, IC = 7 mA, f = 1 GHz dB hFE1/hFE2 hFE Ratio: hFE1 = Smaller Value of Q1, or Q2 hFE2 = Larger Value of Q1 or Q2 TYP MAX 1.0 1.0 70 Cre NF MIN 3.0 120 4.5 0.7 7 250 1.5 9 1.2 2.5 0.85 Notes: 1. Pulsed measurement, pulse width ≤ 350 µs, duty cycle ≤ 2 %. 2. The emitter terminal should be connected to the ground terminal of the 3 terminal capacitance bridge. For Tape and Reel version use part number UPA810TF-T1, 3K per reel. California Eastern Laboratories EXCLUSIVE NORTH AMERICAN AGENT FOR RF, MICROWAVE & OPTOELECTRONIC SEMICONDUCTORS CALIFORNIA EASTERN LABORATORIES • Headquarters • 4590 Patrick Henry Drive • Santa Clara, CA 95054-1817 • (408) 988-3500 • Telex 34-6393 • FAX (408) 988-0279 24-Hour Fax-On-Demand: 800-390-3232 (U.S. and Canada only) • Internet: http://WWW.CEL.COM 2/99 DATA SUBJECT TO CHANGE WITHOUT NOTICE