PRELIMINARY DATA SHEET GaAs MMIC DBS TWIN IF SWITCH AMPLIFIER FEATURES UPG2050GR OUTLINE DIMENSIONS (Units in mm) • TWO INDEPENDENT IF AMPLIFIER CHANNELS 16 pin HTSSOP • TYPICAL GAIN PER CHANNEL: 14 dB (ZO = 50 Ω) 0.20±0.10 6.4±0.3 1.8 0.4 0.5 • FREQUENCY RANGE OF 950 MHz TO 2150 MHz • INTEGRAL SWITCHING TO CHANNEL INPUT 5.5±0.3 0.20±0.10 2.7 N TO EITHER CHANNEL OUTPUT 0.65±0.1 • CHANNEL TO CHANNEL ISOLATION: 30 dB TYP • SMALL 16 PIN HTSSOP PACKAGE 5.2±0.2 0.1 0.9±0.2 2.5 1.5 DESCRIPTION The UPG2050GR is intended for use in Direct Broadcast Satellite (DBS) applications within the Low Noise Block (LNB) down-converter for systems where at least two LNB outputs are required. It offers two intermediate frequency amplifier channels that can independently select 1 of 2 IF inputs. It is housed in a very small 16 pin plastic HTSSOP package and is available on tape and reel. NEC's stringent quality assurance and test procedures assure the highest reliability and performance. ELECTRICAL CHARACTERISTICS (TA = +25°C, VDD = +5 V, VCONT1 to VCONT4 = 0/+5V, ZO = 50Ω each port, unless otherwise specified) PART NUMBER PACKAGE OUTLINE SYMBOLS PARAMETERS AND CONDITIONS UPG2050GR 16 pin HTSSOP UNITS MIN TYP MAX IDD Supply Current, VDD = +5 V, RF OFF mA 25 40 50 GA Power Gain, f = 1.5 GHz, PIN = -30 dBm dB 11 14 19 ∆GA Insertion Loss Flatness, |GA (0.95 GHz)—GA (1.5 GHz)| dB — 1.5 3.5 ∆GA Insertion Loss Flatness, |GA (1.5 GHz)—GA (2.15 GHz)| dB — 2.0 3.5 ISOL Channel Isolation, f = 0.95 GHz to 2.15 GHz dB 25 30 — RLOUT Output Return Loss, f = 0.95 GHz to 2.15 GHz dB — 10 — POUT Output Power, f = 1.5 GHz, PIN = -5 dBm dBm 5 8 — ICONT Control Current, VCONT = +5 V/0 V, RF OFF mA — — 0.5 California Eastern Laboratories UPG2050GR ABSOLUTE MAXIMUM RATINGS1 (TA = +25°C) SYMBOLS UNITS RATINGS PART NUMBER PACKAGE QUANTITY V +6 UPG2050GR-E1 16 Pin Plastic HTSSOP 3000 pcs/Reel VCONT1, 2, 3, 4 Control Voltage 1, 2, 3, 4 V -1.0 to +6.0 PT Total Power Dissipation2 W 2 TA Operating Ambient Temp. °C -40 to +85 Storage Temperature °C -65 to +150 VDD PARAMETERS ORDERING INFORMATION Supply Voltage TSTG RECOMMENDED OPERATING CONDITIONS (TA = +25°C) SYMBOL PARAMETER VDD Notes: 1. Operation in excess of any one of these parameters may result in permanent damage. 2. Mounted on a 50 x 50 x 1.6 mm double copper clad epoxy glass PWB, TC = +85˚C. UNITS Supply Voltage MIN TYP MAX V +4.5 +5 +5.5 VCONT(H) Control Voltage (High) V +4.5 +5 +6.5 Control Voltage (Low) V -0.5 0 +0.5 VCONT(L) EVALUATION CIRCUIT (VDD = +6.0 V, VCONT1 to VCONT4 = +5 V/0 V, ZO = 50 Ω, DC Blocking Capacitor = 51 pF VCONT1 VCONT2 1000 pF VDD 1000 pF C = 51 pF IN1 (L) OUT 1 ZO = 50Ω 16 9 1 8 ZO = 50 Ω IN2 (R) ZO = 50Ω ZO = 50Ω OUT 2 C = 51 pF 1000 pF 1000 pF VCONT3 VCONT4 VDD CHANNEL SELECT TRUTH TABLE OUTPUT CONTROL PIN On-Channel OUT1 OUT2 L L L R R L R R IN1—OUT1 IN1—OUT2 IN1—OUT1 IN2—OUT2 IN2—OUT1 IN1—OUT2 IN2—OUT1 IN2—OUT2 CONNECTION VCONT2 VCONT3 VCONT4 Low High High Low Low High Low High High Low High Low High Low Low High TOP VIEW PIN CONNECTION AND INTERNAL BLOCK DIAGRAM PIN NO. VCONT1 PIN NO. CONNECTION 1 IN2 9 OUT1 2 GND 10 VDD 3 VCONT3 11 VDD 4 VCONT4 12 GND 5 GND 13 VCONT2 6 VDD 14 VCONT1 7 VDD 15 GND 8 OUT2 16 IN1 EXCLUSIVE NORTH AMERICAN AGENT FOR 16 15 14 13 12 11 10 9 1 8 2 3 4 5 6 7 RF, MICROWAVE & OPTOELECTRONIC SEMICONDUCTORS CALIFORNIA EASTERN LABORATORIES • Headquarters • 4590 Patrick Henry Drive • Santa Clara, CA 95054-1817 • (408) 988-3500 • Telex 34-6393 • FAX (408) 988-0279 24-Hour Fax-On-Demand: 800-390-3232 (U.S. and Canada only) • Internet: http://WWW.CEL.COM DATA SUBJECT TO CHANGE WITHOUT NOTICE 01/19/2000