PCA1401A PHASE LOCKED LOOP 9939 Via Pasar • San Diego, CA 92126 TEL (858) 621-2700 FAX (858) 621-2722 Rev A1 PHASE NOISE (1 Hz BW, typical) -50 -60 -70 -80 -90 FEATURES • Frequency Range: 1401 - 1402 MHz • Step Size: 1000 KHz • cPLL - Style Package APPLICATIONS • Fixed Wireless Broadband Equipment • Point-to-Point Microwave Radio • Satellite Communication Systems -100 -110 -120 -130 -140 100 1000 VALUE 1401 - 1402 PERFORMANCE SPECIFICATIONS Frequency Range 10000 100000 UNITS MHz dBc/Hz Phase Noise @ 10 kHz offset (1 Hz BW, typ.) -103 Harmonic Suppression (2nd, typ.) dBc Sideband Spurs (typ.) -15 -70 Power Output 0±2 dBm Load Impedance 50 Ω Step Size 1000 KHz Charge Pump Output Current 1250 µΑ 2 mSec 3 -40 to 85 mSec Switching Speed (typ., adjacent channel) Startup Lock Time (typ.) Operating Temperature Range dBc °C cPLL Package Style POWER SUPPLY REQUIREMENTS Supply Voltage (Vcc, nom.) Supply Current (Icc, typ.) 5 Vdc 35 mA All specifications are typical unless otherwise noted and subject to change without notice. APPLICATION NOTES • AN-107 • AN-200 • AN-201 : How to Solder Z-COMM VCOs / PLLs : Mounting and Grounding of Z-COMM PLLs : PLL Fundamentals AN-202 : PLL Functional Description NOTES: Reference Oscillator Signal: 5 MHz<f o s c <100 MHz Frequency Synthesizer: Analog Devices - ADF4113 © Z-Communications, Inc. Page 1 All rights reserved LOW COST - HIGH PERFORMANCE PHASE LOCKED LOOP PCA1401A PAGE 2 FREQUENCY (MHz) VCO TUNING CURVE, typ. 85 25 -40 °c °c °c TUNING VOLTAGE (Vdc) OUTPUT POWER (dBm) VCO POWER CURVE, typ. 25 °c FREQUENCY (MHz) PHYSICAL DIMENSIONS Top View 12 11 1. The inside radius of all 14 half holes at the perimeter of the board 10 are plated to provide a surface for the attachment of the PLL Module to the motherboard. 5 pads are for grounding, 8 pads are for signal interface. 2. The surface of the shield is tin-plated and may be soldered to. Bottom View 9 Z-COMM PCAXXXXX W/O # 1 2 3 The shield's base metal is brass. 3.The ground plane on the bottom side is ground and attaches to a ground track on the top side of the board as well as to the shield. 8 4. Unless otherwise noted all dimensions are in inches. 5.Unless otherwise noted all tolerances are as follows: .xxx = ± .010 7 P1 RF OUTPUT P2 REFERENCE OSCILLATOR INPUT 4 5 6 P3 CLOCK P4 DATA P5 LOAD ENABLE P6 LOCK DETECT SIDE VIEW P7 VCC P8 GROUND P9 NO CONNECTION P10-12 GROUND © Z-Communications, Inc. Page 2 Printed in the U.S.A.