THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0701 FPLD52TE1 622.08M 3.3V SURFACE MOUNT CLOCK OSCILLATOR ABSOLUTE MAXIMUM RATINGS PARAMETER MINIMUM NOMINAL -40 - 85 °C (Vcc) -0.5 - 7.0 Vdc MINIMUM MAXIMUM UNITS - NOMINAL 341.20000 400.00000 622.08000 644.51000 644.53125 666.51430 669.32660 - MHz -50 - 50 ppm 0 - 70 °C Vdc Storage Temperature Supply Voltage MAXIMUM UNITS OPERATING SPECIFICATIONS NOTE DESCRIPTION TABLE 2.0 PARAMETER Center Frequency (Fo) Total Frequency Tolerance Operating Temperature Range 1 (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 100 mA Jitter (BW=10Hz to 20MHz) - - 5 ps rms Jitter (BW=12kHz to 80MHz) - - 1 ps rms SSB Phase Noise at 100Hz offset - -60 - dBc/Hz SSB Phase Noise at 1KHz offset - -90 - dBc/Hz SSB Phase Noise at 10KHz offset - -130 - dBc/Hz SSB Phase Noise at 100KHz offset - -135 - dBc/Hz MINIMUM NOMINAL MAXIMUM UNITS NOTE - 1.68 Vdc 2 - Vdc 2 INPUT CHARACTERISTICS TABLE 3.0 PARAMETER Enable Input Voltage (Low) (Vil) - Disable Input Voltage (High) (Vih) 2.275 LOW VOLTAGE PECL OUTPUT CHARACTERISTICS MINIMUM NOMINAL MAXIMUM UNITS NOTE - - 50 Ohms 3 (High) (Voh) 2.275 - - Vdc (Low) (Vol) - - 1.68 Vdc 45 50 55 % - - 1 nS Duty Cycle at 50% Level Rise / Fall Time 20% to 80% PROCESS RECOMMENDATIONS Solder Reflow Wash Notes 1.0 2.0 3.0 LOW PROFILE, SURFACE MOUNT PACKAGE 3.3V OPERATION LOAD PACKAGE CHARACTERISTICS FEATURES TABLE 4.0 PARAMETER Package The Connor-Winfield FPLD52TE1 is a 3.3V Clock Oscillator (XO) with Differential LVPECL outputs and Enable/Disable function. The FPLD52TE1 is designed for use with applications requiring low jitter and tight stability. No multiplication schemes are used in this oscillator design. NOTE Supply Voltage Voltage FPLD52TE1 TABLE 1.0 UNITS LOW JITTER <1pS RMS FREQUENCY TOLERANCE: ±50ppm TEMPERATURE RANGE 0 to 70°C DIFFERENTIAL LVPECL OUTPUTS ENABLE / DISABLE FUNCTION TABLE 5.0 Non-hermetic package consisting of an FR4 subs trate with grounded metal cover. TAPE AND REEL PACKAGING TABLE 6.0 The component solder used internal to this device has a m elting point of 221°C. The peak temperature inside the device should be less t han or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. ORDERING INFORMATION FPLD52TE1 - 622.08MHz Inclusive of calibration @ 25°C, frequency stabilit y vs. temperature, supply and load variations, shock, vibrat ion and aging for ten years. Control voltage (Vc) = 1.65 Vdc. When oscillator is disabled the true output is in a low state (Vol) and the complementary output is in the high stat e (VoH). Outputs are enabled with no connection on enable pad. 50 ohm termination into Vcc -2V or Thevein equivalent. LVPECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Ec181 PAGE 1 OF 2 REV: 01 DATE: 8/4/03 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS .140 MAX (3.56mm) CW FPLD52TE1 622.08M Pin 1 2 3 4 5 6 Function N/C Enable / Disable Ground (Case) Output Q Comp Output Q Vcc Dimensional Tolerance: ±.005 (.127mm) 2 N/C E/D Specifications subject to change without notice. DATA SHEET #: Ec181 PAGE 2 OF 2 REV: 01 DATE: 8/4/03 aCopyright 2001 Connor-Winfield all rights reserved.