THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS X533M2 333M 3.3V SURFACE MOUNT 5.0 x 7.5mm LVDS CLOCK OSCILLATOR X533 ABSOLUTE MAXIMUM RATINGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 100 °C -0.5 - 7.0 Vdc Storage Temperature Supply Voltage (Vcc) OPERATING SPECIFICATIONS DESCRIPTION The Connor-Winfield X533 is a 3.3V Crystal Controlled Oscillator (XO) with LVDS Differential outputs. The X533 is designed for use with PLL systems requiring tight frequency stability vs. temperature. The use of multiplication is utilized in this oscillator design. TABLE 2.0 PARAMETER Center Frequency NOTE MINIMUM NOMINAL MAXIMUM UNITS 100 - 400 MHz -100 - 100 ppm 0 - 85 °C Vdc (Fo) Total Frequency Tolerance Operating Temperature Range NOTE 1 Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 60 mA Jitter (BW=10Hz to 20MHz) - - 10 ps rms Jitter (BW=12kHz to 80MHz) - - 3 ps rms SSB Phase Noise at 10Hz offset - -75 - dBc/Hz SSB Phase Noise at 100Hz offset - -95 - dBc/Hz SSB Phase Noise at 1KHz offset - -110 - dBc/Hz SSB Phase Noise at 10KHz offset - -125 - dBc/Hz SSB Phase Noise at 100KHz offset - -120 - dBc/Hz MINIMUM NOMINAL MAXIMUM UNITS NOTE - 0.3Vcc Vdc 2 - Vdc 2 INPUT CHARACTERISTICS TABLE 3.0 PARAMETER Enable Input Voltage (Low) (Vil) - Disable Input Voltage (High) (Vih) 0.7Vcc FEATURES 3.3V OPERATION LVDS OUTPUT CHARACTERISTICS TABLE 4.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE - - 100 Ohms 3 250 - 450 mV LOAD Output Differential Voltage (Vod) Duty Cycle at 50% Level Rise / Fall Time PACKAGE CHARACTERISTICS Solder Reflow Notes 1.0 2.0 3.0 50 55 % - 0.6 1.0 nS TOTAL FREQUENCY TOLERANCE: ±100ppm TEMPERATURE RANGE: 0 to 85°C DIFFERENTIAL LVDS OUTPUTS TABLE 5.0 Hermetically sealed ceramic package with grounded m etal cover. Package PROCESS RECOMMENDATIONS 45 LOW JITTER <3pS RMS SURFACE MOUNT PACKAGE TABLE 6.0 SMD product suitable for Convection Reflow soldering. Peak temperature 260°C. Maximum time above 220°C, 60 seconds. TAPE AND REEL PACKAGING RoHS COMPLIANT / LEAD FREE Inclusive of calibration @ 25°C, frequency stabili ty vs. temperature, control voltage (Vc) = 1.65 Vdc and aging for ten years. When oscillator is disabled both output are in a high impedance stat e (Tri-State) Vod measured with 100 ohm resistor between the true output and the com plementary output. ORDERING INFORMATION X533 LVDS CLOCK SERIES - 333.00MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: DS019 PAGE 1 OF 2 REV: 02 DATE: 11/07/05 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS Package Outline and Dimensions Pin Connections X533 M2 333M Pin 1 2 3 4 5 6 Function N/C Enable / Disable Ground (Case) Output Q Comp Output Q Vcc Dimensional Tolerance: ±.005 (.127mm) Suggested Pad Layout Timing Chart Solder Profile Test Curcuit Temperature 260°C 260°C 220°C Q 180°C 150°C Vod 100 ohm 120°C 2 Q N/C 0 E/D 120 S Max. 10 S Time 60 S Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET #: DS019 PAGE 2 OF 2 REV: 02 DATE: 11/07/05 aCopyright 2001 Connor-Winfield all rights reserved.