3 POSITION SELECTOR SWITCH CONTACT BLOCK OPERATION GUIDE 5 6 CONTACT BLOCK GUIDE × 1 NO (left) × 2 NC in series (side × side) × 1 NO (right) revision for dwg # 1PB-P2AS2-x rev ch.no. - - date description original design 11/5/2007 revised by Philipp E. 1 2 × × 1 NC (right) × × 1 NC (left) × × 2 NO in parallel (side × side) 28 mm [1.1 in] (Left or right as seen from front of operator) max. 4 mm [.15 in] 23 mm [.9 in] 47 mm [1.8 in] 4 71 mm [2.8 in] 95 mm [3.7 in] 10.5 mm [.4 in] 3 24.4 mm [1.0 in] ITEM DESCRIPTION CAT. NO. P2AS2-1 1* Selector Switch P2AS2-3 P2AS2-4 2* Rubber Gasket 2PRG1 3* Mounting Nut P2MN 4* Mounting Bracket P2BRK 5 Panel S1 S2 6** Switch Contacts S3 S4 Up tp six switch contacts can be installed. * = Selector Switch is supplied with rubber gasket, mounting nut and mounting bracket (ITEM 1,2,3 and 4) ** = Switch Contacts must be ordered separatly unless otherwise specified: all dimensions are in millimeters third angle projection tolerance XX XX.X XX.XX ALL = = = = ±1 mm ±0.5 mm ±0.2 mm − mm This Drawing is the property of R M E T R I C 35 Royal Road Flemington, NJ 08822-6000 (908) 806-9400 Fax (908) 806-9490 and is a confidential disclosurelent without consideration other than the borrower’s agreement that it shall not be reproduced, copied, lent or disposed of directly or indirectly nor used for any purpose other than that for which it is specifically furnished. titel COLOR Black Black Black Black Black Black Green Red Green/Gray Red/Gray Type Maintained/2 Position Maintained/3 Position Momentary/3 Position - MIN. QTY. MAX. QTY. 1 1 1 1 1 1 1 1 1 1 1 1 1 6 1 6 1 6 1 6 22 mm Thermoplastic Enclosure Selector Switch P2AS2-x (x=type) drawn by: Philipp Ernstberger checked by: Laszlo Gyorgypal released by: Laszlo Gyorgypal 11/5/2007 drawing no.: rev.: 11/5/2007 1PB-P2AS2-x 11/5/2007 scale: - - sheet: 1 of: 1