CANDD TPS_DNX301

0RODUCT $ATA 3HEET
Contact Factory for Replacement Model
7!44
$#$# 0/7%2 3500,9
$.8
&%!452%3
&ULLY )SOLATED /UTPUTS
,OW 0ROFILE v X v X v
/NE 4WO 4HREE AND &OUR
/UTPUT -ODELS
. #URRENT 3HARING
/PTIONAL &AN -OUNTED /N
#OVER
!CTIVE )NRUSH #URRENT ,IMITING
$%3#2)04)/.
4HE $.8 IS A COMPACT WATT MULTIPLE OUTPUT POWER
SUPPLY !LL OUTPUTS ARE FULLY ISOLATED AND REGULATED !CTIVE
CURRENT SHARING CIRCUITRY ON /UTPUT TOGETHER WITH CONTROL
FUNCTIONS AND ALARM OPTIONS SIMPLIFIES . AND REDUNDANT
APPLICATIONS &AN AND DISK DRIVE APPLICATIONS ARE HANDLED BY
THE PEAK CURRENT RATINGS OF THE AUXILIARY OUTPUTS
!'%.#9 !002/6!,3
3EE h3AFETYv SECTION ON PAGE FOR MORE INFORMATION
7EBSITE HTTPWWWCDPOWERELECTRONICSCOM
0OWER %LECTRONICS $IVISION 5NITED 3TATES
% "RITANNIA $RIVE 4UCSON !RIZONA 4EL &AX #$4ECHNOLOGIES.#,
-ILTON +EYNES-+ "5 5+
4EL &AX !NY DATA PRICES DESCRIPTIONS OR SPECIFICATIONS PRESENTED HEREIN ARE SUBJECT TO REVISION BY #$ 4ECHNOLOGIES )NC WITHOUT NOTICE 7HILE SUCH INFORMATION IS BELIEVED TO BE
ACCURATE AS INDICATED HEREIN #$ 4ECHNOLOGIES )NC MAKES NO WARRANTY AND HEREBY DISCLAIMS ALL WARRANTIES EXPRESS OR IMPLIEDWITH REGARD TO THE ACCURACY OR COMPLETENESS
OF SUCH INFORMATION&URTHER BECAUSE THE PRODUCTS FEATURED HEREIN MAY BE USED UNDER CONDITIONS BEYOND ITS CONTROL #$ 4ECHNOLOGIES )NC HEREBY DISCLAIMS ALL WARRANTIES
EITHER EXPRESS OR IMPLIED CONCERNING THE FITNESS OR SUITABILITY OF SUCH PRODUCTS FOR ANY PARTICULAR USE OR IN ANY SPECIFIC A PPLICATION OR ARISING FROM ANY COURSE OF DEALING
OR USAGE OF TRADE4HE USER IS SOLELY RESPONSIBLE FOR DETERMINING THE SUITABILITY OF THE PRODUCTS FEATURED HEREIN FOR USERS INTENDED PURPOSE AND IN USERS SPECIFIC APPLICATION
#$ 4ECHNOLOGIES )NC DOES NOTWARRANT OR RECOMMEND THAT ANY OF ITS PRODUCTS BE USED IN ANY LIFE SUPPORT OR AVIATION OR AEROSPACE APPLICATIONS
$.8 2%6 "
0AGE Input Specifications
Parameter
Operating Range
Conditions
Min
Typ
Max
Units
36
48
72
VDC
36VD
25
APK
72VDC
50
APK
DC
Inrush Current Limiting
Efficiency
48 VDC, at full load
70
%
Remote Sense
Remote Sense is provided on Output #1 and will
compensate for 0.7V of line drop. Remote Sense leads
are protected against open, short and reversal.
Transient Response
The peak output voltage excursion will not exceed 2% and
will recover within 1% in 200 μsec for a 25% load step
change.
Remote On/Off (Optional)
The power supply is turned on with a TTL logic ‘1’ (or open)
signal and turned off by a switch closure or TTL logic ‘0’
referenced to (-) sense terminal. Consult the factory for
other options.
Over Temperature Protection
Thermal switch turns off power supply if overheating occurs
and automatically restarts.
Over Voltage Protection
Output #1: 6.5V ± 0.5 VDC.
The power supply will latch off until AC power is cycled.
Safety
Safety certified to UL/CUL to 1950, File Number E131694
TUV to EN60950/IEC950.
Cooling
The unit is designed to operate with 30 CFM of airflow.
Over Current Protection
Individual current limit on all outputs. Automatic recovery
upon fault removal.
Active Inrush Current Limiting
Inrush current is independent of ambient temperature.
Page 2
DNX301 4/2002 REV B
Output Voltages and Maximum Rated Loads
MODEL NUMBER
OUTPUT #1
VOUT
IMAX
OUTPUT #2
VNOM IMAX/IPK
OUTPUT #3
VNOM IMAX/IPK
OUTPUT #4
VNOM
IMAX
DNX301-U3A
±5V
45A
± 12V
8A/10A
± 12V
8A/10A
-
-
DNX301-U3B
±5V
45A
± 15V
8A/10A
± 15V
8A/10A
-
-
DNX301-U4C
±5V
45A
± 12V
8A/10A
± 12V
8A/10A
± 5V
3.0A
DNX301-U4D
±5V
45A
± 12V
8A/10A
± 12V
8A/10A
± 24V
1.5A
DNX301-U4E
±5V
45A
± 12V
8A/10A
± 12V
8A/10A
± 12V
3.0A
DNX301-U4F
±5V
45A
± 15V
8A/10A
± 15V
8A/10A
± 5V
3.0A
DNX301-U4G
±5V
45A
± 15V
8A/10A
± 15V
8A/10A
± 24V
1.5A
DNX301-U4H
±5V
45A
± 15V
8A/10A
± 15V
8A/10A
± 12V
3.0A
Note: Maximum current ratings are for 10sec maximum. Total power not to exceed 300 watts.
Output Specifications
Parameter
Limits
Regulation
Line
± 0.03%
Load
±0.25%
Cross
±0.05%
Minimum Load
Output #1
3.0A
Auxiliary Outputs
0.1A
Parameter
Conditions
Min
Voltage Adustment Range
PARD
Typ
Max
±5
20 MHz bandwidth
Units
%
1
% P-P
0
50
°C
-20
+85
°C
Temperature
Operating
Storage
Temperature Coefficient (TC)
DNX301 4/2002 REV B
After half hour warm-up
± 0.02
%/°C
Page 3
Mechanical
TOP VIEW
0.040
1.95
8.50
0.25
COVER
0.55
1
TB2
3.90
4.85
1
J9
OUTPUT NO. 1
1
5V RETURN
9.00
TB1
5V
6-32 THD 4 PLC’S
Maximum depth of mounting
scres is 0.156 inches
NOTES:
All measurements are in inches
FAN MOUNTED ON COVER ADDS 1.30”.
COOLING: The DNX301 is designed to operate with 30 CM airflow.
SHOCK AND VIBRATION: The DNX301 meets the requirements of MIL STD-810D.
WEIGHT: Approximately 3 lbs.
Terminal Block 1
Terminal Block 2
FUNCTION
1
DC +
1
-V2
PIN
FUNCTION
2
DC -
2
+V2
1
+ Sense
3
Ground
3
-V3
2
- Sense
4
+V3
3
N/C
5
-V4
4
N/C
6
+V4
5
Start Up Sync.
Page 4
POS
FUNCTION
J9 Connector
Molex No. 22-28-1090
POS
6
N/C
7
Remote Inhibit
8
Current Share
9
Control Signal Rtn
DNX301 4/2002 REV B