THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D A TA SHEET CRYSTAL CONTROLLED OSCILLATORS ABSOLUTE M AXIMUM RATING S PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -55 - 125 °C -0.5 - 7.0 Vdc MINIMUM 200 -20 -30 -40 NOMINAL - UNITS MHz ppm ppm °C Vdc Storage Temperature Supply Voltage (Vcc) OPERATING SPECIFIC ATIONS PARAMETER Center Frequency Frequency Stability Total Frequency Tolerance Operating Temperature Range NOTE TABLE 2.0 - MAXIMUM 800 20 30 85 Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 80 mA Jitter (BW=10Hz to 20MHz) - - 8 pS RMS Jitter (BW=12kHz to 20MHz) - - 3 pS RMS MINIMUM NOMINAL MAXIMUM UNITS NOTE - Vdc 3 1.68 Vdc 3 MAXIMUM 50 1.68 55 1 UNITS Ohms Vdc Vdc % nS (Fo) INPUT CHARACTERISTICS Disable Input Voltage (High) (Vih) 2.275 Enable Input Voltage (Low) (Vil) - - (Voh) (Vol) MINIMUM 2.275 45 - NOMINAL 50 - PECL OUTPUT CHARACTERISTICS DESCRIPTION 1 2 The Connor-Winfield FPLD64BEX is a fixed frequency, surface mount Crystal Controlled Oscillator (XO) designed for applications requiring low jitter and a ±20ppm frequency stability. Operating at 3.3V supply voltage, the FPLD64BEX provides LVPECL Differential Outputs with Enable/Disable function. TABLE 4.0 PARAMETER LOAD Voltage (High) (Low) Duty Cycle Rise / Fall Time 20% to 80% PACKAG E CHARACTERISTICS Package PROCESS RECOMMENDATIONS Wash FPLD64BEX NOTE TABLE 3.0 PARAMETER Solder Reflow CW 2404 FPLD64BEX 450M SURFACE MOUNT 3.3V LVPECL CLOCK NOTE 4 FEATURES 3.3V OPERATION 5 TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a melting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Notes 1) Frequency stability vs. change in temperature. 2) Inclusive of frequency calibration @ 25°C, frequency stability vs. change in temperature, supply and load variations, shock and vibration and 15 years aging. 3) When the oscillator is disabled, the true output and the complementary output are in the high impedance state. 4) Output must be terminated into 50 ohms to Vcc – 2V or Thevenin equivalent. 5) Duty Cycle measured at 1.977V LVPECL DIFFERENTIAL OUTPUTS ENABLE / DISABLE FUNCTION PAD 2 OVERALL FREQUENCY TOLERANCE ±30ppm SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING ORDERING INFORMATION FPLD64BEX - 450MHz LVPECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: INT Ec207 PAGE 1 OF 2 REV: 00 DATE: 06/21/04 a Copyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. PRODUCT www.conwin.com D A TA SHEET CRYSTAL CONTROLLED OSCILLATORS .230 MAX (5.84mm) CW FPLD64BEX 450M N/C ENABLE / DISABLE GROUND Q OUTPUT Q OUTPUT Vcc 80% 50% 20% N/C E/D Specifications subject to change without notice. DATA SHEET #: INT Ec207 PAGE 2 OF 2 REV: 00 DATE: 06/21/04 a Copyright 2001 Connor-Winfield all rights reserved.