THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ABSOLUTE MAXIMUM RATINGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL -40 - 85 °C (Vcc) -0.5 - 7.0 Vdc Storage Temperature Supply Voltage MAXIMUM UNITS OPERATING SPECIFICATIONS DESCRIPTION MINIMUM NOMINAL MAXIMUM UNITS NOTE 16 -20 0 - MHz ppm °C 1 - 250 20 70 (Vcc) 3.135 3.3 3.465 Vdc (Icc) - - 60 mA Jitter (BW=10Hz to 20MHz) - - 5 pS RMS Jitter (BW=12kHz to 20MHz) - - 1 pS RMS Start Up Time - - 10 mS NOMINAL MAXIMUM - UNITS NOTE Vdc 2 1.68 Vdc 2 Center Frequency Total Frequency Tolerance Operating Temperature Range (Fo) Supply Voltage Supply Current INPUT CHARACTERISTICS TABLE 3.0 PARAMETER Disable Input Voltage (High) (Vih) MINIMUM 2.275 Enable Input Voltage (Low) (Vil) - - MINIMUM NOMINAL MAXIMUM UNITS NOTE 2.275 40 - 50 - 50 1.68 60 1 Ohms Vdc Vdc % nS 3 PECL OUTPUT CHARACTERISTICS TABLE 4.0 PARAMETER (High) (Low) (Voh) (Vol) Duty Cycle Rise / Fall Time 20% to 80% PACKAGE CHARACTERISTICS Package PROCESS RECOMMENDATIONS Solder Reflow Wash FPLD54TE2 NOTE TABLE 2.0 PARAMETER LOAD Voltage CW 0701 FPLD54TE2 155.52M SURFACE MOUNT 3.3V LVPECL CLOCK 4 The Connor-Winfield FPLD54TE2 is a fixed frequency, surface mount Crystal Controlled Oscillator (XO) designed for applications requiring low jitter and a ±20ppm overall stability. Operating at 3.3V supply voltage, the FPLD54TE2 provides LVPECL Differential Outputs with Enable/Disable function. FEATURES 3.3V OPERATION LVPECL DIFFERENTIAL OUTPUTS ENABLE / DISABLE LOW JITTER <1pS RMS TABLE 5.0 Non-hermetic package consisting of an FR4 subst rate with grounded metal cover. OVERALL FREQUENCY TOLERANCE ±20ppm SURFACE MOUNT PACKAGE TABLE 6.0 The component solder used internal to this device has a m elting point of 221°C. The peak temperature inside the device should be less t han or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Notes 1) Includes initial tolerance, deviation over temperature, s upply and load variations, shock, vibration and 20 years aging. 2) When the oscillator is disabled, the true out put is in a low state (Vol) and the complementary output is in the high stat e (VoH). 3) Output must be terminated into 50 ohms to Vc c – 2V or Thevenin equivalent. 4) Duty Cycle measured at 1.977V TAPE AND REEL PACKAGING ORDERING INFORMATION FPLD54TE2 - 155.52MHz LV PECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: INT Ec154 PAGE 1 OF 2 REV: 00 DATE: 4/4/02 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW FPLD54TE2 155.52M Q OUTPUT ENABLE / DISABLE GROUND Q OUTPUT N/C Vcc Dimensional Tolerance: ±.005” (.127mm) 80% 50% 20% N/C 2 Specifications subject to change without notice. DATA SHEET #: INT Ec154 PAGE 2 OF 2 REV: 00 DATE: 4/4/02 aCopyright 2001 Connor-Winfield all rights reserved.