D LW 0 5 5W DC-DC Regulated Dual Output Converter series Features : 2:1 wide input range 4:1 wide input range(option) 1000VDC I/O isolation 3000VDC I/O isolation(option) Built-in EMI filter Protections: Short circuit / Overload Cooling by free air convection Six-sided shield metal case 100% burn-in test Low cost / High reliability Approvals: FCC / CE 2 years warranty SPECIFICATION ORDER NO. DLW05A-05 DLW05B-05 DLW05C-05 DLW05A-12 DLW05B-12 DLW05C-12 DLW05A-15 DLW05B-15 DLW05C-15 DC VOLTAGE 5V 12V 15V CURRENT RANGE 50 ~ 500mA 20.8 ~ 208mA 16.7 ~ 167mA 5W RATED POWER OUTPUT RIPPLE & NOISE (max.)Note.2 50mVp-p LINE REGULATION Note.3 0.2% LOAD REGULATION Note.4 0.5% SWITCHING FREQUENCY VOLTAGE RANGE 50KHz min. A: 9 ~ 18VDC EFFICIENCY (Typ.) 75% DC CURRENT B: 18 ~ 36VDC 77% 77% C: 36 ~ 72VDC 80% Full load A: 556mA B: 270mA C: 135mA No load A: 33mA C: 10mA B: 16mA 83% 82% 81% 85% 83% Pi network Fuse recommended FILTER PROTECTION 160 ~ 250% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed All output equipped with short circuit OVERLOAD PROTECTION (Note. 5) 60mVp-p 2.0% VOLTAGE ACCURACY INPUT 60mVp-p SHORT CIRCUIT Protection type : Hiccup mode, recovers automatically after fault condition is removed WORKING TEMP. -25 ~ +71 WORKING HUMIDITY 20% ~ 90% RH non-condensing -25 ~ +105 , 10 ~ 95% RH ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION WITHSTAND VOLTAGE (Refer to output load derating curve) 0.03% / (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1 cycle, period for 60min. each along X, Y, Z axes I/P-O/P:1KVDC I/P-O/P: 100M Ohms / 500VDC / 25 / 70% RH SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION Compliance to EN55022 Class B, FCC part 15 Class B Compliance to EN61000-4-2,3,4,5,6,8, light industry level, criteria A EMS IMMUNITY 800khrs min. MIL-HDBK-217F(25 ) MTBF OTHERS DIMENSION 50.8*25.4*11.27mm or 2.0"*1.0"*0.44" inch (L*W*H) WEIGHT 32g Derating Curve Pin Configuration Mechanical Specification Unit:mm 11.27 2.5 15.2 10.2 10.2 1 3 4 2 BOTTOM VIEW 5 0.8 2.5 25.4 10.2 5.1 10.1 20.3 + 0.2/-0 5.8 Pin no. Output Dual 1 2 3 4 5 + Vi n - Vi n + Vo u t COM - Vo u t 100 LOAD (%) 50.8 15.3 80 -25 0 25 50 60 71 Ta ( NOTE 100 ) 1.All parameters are specified at normal input, rated load, 25 70% RH Ambient. 2.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 3.Line regulation is measured from low line to high line at rated load. 4.Load regulation is measured from 10% to 100% rated load. 5.Please prevent the converter from operating in overload or short circuit condition for more than 30 seconds. File Name:DLW05-SPEC 2008-05-12