PS-15 15W Single Output Switching Power Supply series Features : Universal AC input / Full range Low leakage current <0.5mA Protections: Short circuit/Over load /Over voltage/Over temperature Cooling by free air convection 100% full load burn-in test Fix switching frequency at 67KHz Low cost High reliability 2 years warranty SPECIFICATION MODEL OUTPUT INPUT PS-15-5 PS-15-12 PS-15-15 PS-15-24 DC VOLTAGE 5V 12V 15V 24V 48V RATED CURRENT 2.8A 1.25A 1A 0.625A 0.313A CURRENT RANGE 0 ~ 2.8A 0 ~ 1.25A 0 ~ 1A 0 ~ 0.625A 0 ~ 0.313A RATED POWER 14W 15W 15W 15W 15W 120mVp-p 120mVp-p 150mVp-p 200mVp-p RIPPLE & NOISE (max.) Note.2 100mVp-p VOLTAGE TOLERANCE Note.3 2.0% 2.0% 2.0% 2.0% 2.0% LINE REGULATION 1.0% 1.0% 1.0% 0.5% 0.5% LOAD REGULATION 1.0% 1.0% 1.0% 0.5% 0.5% SETUP, RISE TIME 5 ~ 24V:1200ms, 30ms HOLD UP TIME(Typ.) 100ms at full load VOLTAGE RANGE 85 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY(Typ.) 74% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 0.4A/115VAC LEAKAGE CURRENT OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 4) HARMONIC CURRENT OTHERS NOTE PS-15-48 48V:1200ms, 75ms at full load 120 ~ 370VDC 77% 78% 77% COLD START 40A/230VAC <0.5mA / 240VAC Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16.2V 17.25 ~ 20.25V 27.6 ~ 32.4V Tj 140 typically (U1) Detect on main control IC 55.2 ~ 64.8V Protection type : Hiccup mode, recovers automatically after fault condition is removed -10 ~ +60 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes EN60950-1 CB Approved by TUV I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC Compliance to EN55022 (CISPR22) Class B Compliance to EN61000-3-2,-3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11 Light industry level, criteria A DIMENSION 94*49*25mm (L*W*H) 0.083Kg; 120pcs/10.96Kg PACKING 79% 0.2A/230VAC 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:PS-15-SPEC 2006-04-13 PS-15 15W Single Output Switching Power Supply Mechanical Specification series Unit:mm 94 87 To chassis Grounding CN1 1 2 42 49 1 2 3 CN2 3.5 25 4- AC Input Connector (CN2) : JST B3P-VH or equivalent Assignment AC/N No Pin AC/L Pin No. 1 2 3 DC Output Connector (CN1) : JST B2P-VH or equivalent Mating Housing Terminal JST VHR or equivalent JST SVH-21T-P1.1 or equivalent Pin No. 1 2 Assignment +V -V Mating Housing JST VHR or equivalent Block Diagram Terminal JST SVH-21T-P1.1 or equivalent fosc : 67KHz RECTIFIERS & FILTER EMI FILTER I/P FG RECTIFIERS & FILTER POWER SWITCHING PWM CONTROL Output Derating +V -V DETECTION CIRCUIT Static Characteristics 100 100 90 80 80 70 LOAD(%) LOAD (%) 60 40 20 -10 -10 60 50 40 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 (HORIZONTAL) 85 90 95 100 105 264 INPUT VOLTAGE (V) 60Hz File Name:PS-15-SPEC 2006-04-13