Oscilent Corporation IF SAW Filter | 820-IF70.0M-D Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 820-IF70.0M-D 20.2 x 12.6 Thru Hole Base Station & Repeater May 02 2003 . TYPE : 70.0 MHz Bandpass Filter 5.5 MHz Bandwidth PART NUMBER : 820-IF70.0M-D . Horizontal : 2.0 MHz/Div Veritical : 10 dB/Div Horizontal : 0.8 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.94 70.00 70.06 MHz Insertion Loss - 20.5 23.0 dB 1dB Bandwidth 5.3 5.5 - MHz 3dB Bandwidth 5.5 5.7 - MHz 40dB Bandwidth - 6.6 6.9 MHz Passband Ripple - 0.9 1.2 dB Group Delay Variation - 150 200 nsec Center Frequency - 2.38 - µsec Ultimate Rejection 50 55 - dB Substrate Material - 112 LT - - Ambient Temperature - 25 - °C Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if70_0d.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 820-IF70.0M-D Page 2 of 2 L1 = 82nH C1 = 130pF L2 = (120+80)nH C2 = 91pF Source/Load Impedance = 50 ohms * PKG Ground can be used for better spurious levels Part No.: 820-IF70.0M-D Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if70_0d.htm 12/28/2005