Low Profile 10Base-T Interface Module EPE6059GM & EPE6059GM-RC ELECTRONICS INC. • Optimized for AMD/PHY type chip for Card Bus • Robust construction allows for IR/VP processes • Complies with or exceeds IEEE 802.3, 10Base-T Standards • Hipot : 200 Vrms (for 1 minute between channels) • Add “-RC” after part number for RoHS Compliant • Storage Temperature : -40°C to +125°C • Operating Temperature : 0°C to +70°C Electrical Parameters @ 25° C Cut-Off Frequency (MHz) Insertion Loss (dB Max.) Return Loss (dB Min.) ± 1 MHz Xmit/Rcv 1-10 MHz 5-10 MHz @ 20 MHz @ 25 MHz @ 30 MHz @ 40 MHz 30-100 MHz 1-10 MHz Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Between Channels 17/17 -1/-1 -15/-15 -7/-5 -18/-11 -30/-18 -35/-26 -30/-30 -30/-30 • Attenuation (dB Min.) Common Mode Rejection (dB Min.) Crosstalk (dB Min.) Isolation : meets or exceeds 802.3 IEEE Requirements • Characteristic Filter Impedance : 100 Ω • • Referenced to the filter output @ 5 MHz for filter only, excluding resistor network • Package Schematic .790 (20.07) PCA EPE6059GM(-RC) Date Code .085 (2.16) .200 (5.08) .700 (17.78) .530 Max. (13.46) Pin 1 I.D. Receive Channel 3 49.9Ω Solder Pad Layout 13 LPF 5 Pole 2 49.9Ω 100Ω 14 1:1 12 1 .600 (15.24) .040 (1.02) .100 (2.54) .088/.094 (2.24/2.39) Chip Side Transmit Channel 57.6Ω 7 .008/.012 (.203/.305) 0°-8° Media Side 324Ω 6 8 LPF 7 Pole 768Ω .100 (2.54) .040 (1.02) 9 5 Notes : 1:1 57.6Ω .670 (17.02) .016/.020 (.406/.508) 4 10 324Ω Chip Side Media Side Note : All resistors are ± 1%, unless otherwise specified EPE6059GM EPE6059GM-RC SnPb Hot Tin Dip (Sn) † 1. Lead Finish 2. Peak Temperature Rating 225°C 250°C 3. Moisture Sensitive Levels MSL = 3 MSL = 4 (168 Hours, ≤30°C/60%RH) 4. Weight 5. Packaging Information (Tube) (Tape & Reel) 100Ω (72 Hours, ≤30°C/60%RH) TBD grams TBD grams 23 pieces/tube 23 pieces/tube 600 pieces/13” reel 600 pieces/13” reel † Lead Material : Ni Barrier over Cu Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CSE6059GM Rev. 1 7/18/07 JDG TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com