Low Profile SMD 10Base-T Interface Module for PCMCIA ELECTRONICS INC. EPE6050GM • Optimized for AMD/PHY type chip for Card Bus • Robust construction allows for IR/VP processes • Complies with or exceeds IEEE 802.3, 10Base-T Standards • Hipot : 200 Vrms (for 1 minute) Electrical Parameters @ 25° C Common Mode Rejection (dB Min.) Cut-Off Frequency (MHz) Insertion Loss (dB Max.) Return Loss (dB Min.) ± 1 MHz Xmit/Rcv 1-10 MHz 5-10 MHz @ 20 MHz @ 25 MHz @ 30 MHz @ 40 MHz 30-100 MHz 1-10 MHz Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Xmit/Rcv Between Channels 17/17 -1/-1 -15/-15 -7/-5 -18/-11 -30/-18 -35/-26 -30/-30 -30/-30 • Attenuation (dB Min.) Crosstalk (dB Min.) Isolation : meets or exceeds 802.3 IEEE Requirements • Characteristic Filter Impedance : 100 Ω • • Referenced to the filter output @ 5 MHz for filter only, excluding resistor network • Schematic 7 Transmit Channel 274Ω 68.1Ω 49.9Ω 8 6 806Ω LPF 7 Pole 5 100Ω 2 9 49.9Ω 10 1 1:1 68.1Ω Receive Channel 3 4 274Ω Chip Side 13 LPF 5 Pole 100Ω 1:1 12 Chip Side Cable Side 14 Cable Side Note : All resistors are ± 1%, unless otherwise specified Package .790 (20.07) Pin 1 I.D. .085 (2.16) .200 (5.08) .095 (2.41) PCA .520 EPE6050GM (13.21) Date Code .700 (17.78) .030 (.762) .595/.605 (15.11/15.37) .088/.094 (2.24/2.39) Pad Layout .033/.010 (.076/.254) .100 (2.54) .008/.013 (.203/.330) 0°-8° .040 (1.02) .017/.022 (.432/.559) .670 (17.02) .097/.103 (2.46/2.62) Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CSE6050GM Rev. A 3/1/05 MH TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com