PMP 25 Rectifier Module Description The Power-One PMP 25 rectifier uses resonance switch mode technology (soft switching), and incorporates thermal protection while providing extremely reliable DC power in a small space. Rectifier communication is accomplished using digital interfaces over an RS485 data bus. Information is transmitted to adjacent rectifiers while providing status and identification information to the system controller (PCS). At only 4 rack units high, these compact rectifiers allow for up to five modules in each 23in. rack (4 units in 19in. rack) providing up to 250A at 48V or up to 550A at 24V. With full power available up to 65°C, PMP 25 rectifiers are ideal for any indoor or outdoor application. Features • Compact 4 rack-unit height • 50A output at 48V • 110A output at 24V • 208 / 240 single phase input • Input over-voltage disconnect • Hot-swappable rectifiers • High efficiency, up to 91% • Active current sharing • International standards compliance PPS 25 System Shown www.power-one.com PMP 25 Rectifier Module Input Mechanical Dimensions 196 - 250V AC ±10% single phase, (44-66Hz) 176-160V AC at reduced output power 105 x 176 x 455mm (6.9 x 4.13 x 17.9in.) Weight 6.2kg (13.6lbs.) Current (max.) <22A <20A Cooling Fan: speed controlled and monitored Soft Start <22A <20A Interface RS485 for communication with the supervision module Harmonics EN 61000-3-2 Power Factor >0.98 at 50-100% load Surge Immunity EN 61000-4-5 Fuse F 25A Connection Harting MH - 21 Signal pins, 3 HC pins EMC EN 61000-6-2, EN 61000-6-3, FCC Part 15 Class B Model PMP 25.24 Input Voltage PMP 25.48 Output Model PMP 25.24 PMP 25.48 Power (max.) 3080W 2800W Output Voltage 22-30V DC 44-58V DC Current (max.) 110A 50A Efficiency >89% >91% (@ 40-90%Load)* Tolerance +/- 6% at load variation 10-90% or 90-10%, recovery time 150ms Load Sharing <5% of nominal current Psophometric Connection EMC <100mV p-p (BW. 30MHz) <2mV, according to CCITT norms 8mm HC-pins IP20 Mounting In 19”/ 4U subrack up to 4 In 23”/ 4U subrack up to 5 Other Technical Data Safety EN 60950 CSA C22-2 No. 950, UL 1950 Protection Short circuit proof, automatic current limiting, selective shutdown of modules at excessive output voltage. Thermal protection reduces the output power at environmental temperatures above maximum level. Shut down at >75°C with automatic restart.* Input over-voltage disconnection at >275VAC with automatic reset at >260VAC. Green LED Power ON Yellow LED Thermal Protection Yellow Flashing Comm. Error Red LED Module Failure Indications Audible Noise <60dBA Operating Temperature* 48V: -25 to +60°C 24V: -40 to +65°C Storage Temperature -40 to +85°C Radiated EMC EN 61000-6-2, EN 61000-6-3, FCC Part 15, Class B Environment Storage: Transport: Operation: EN 61000-6-2, EN 61000-6-4 * Average performance for a single rectifier Reinforced insulation tested at: 4.25 kV DC primary-secondary, 2.12 kV DC primary-ground, 0.75 kV DC secondary ground Enclosure Vout +/- 0.5% Transient Response Ripple Insulation ETS 300 019-2-1 ETS 300 019-2-2 ETS 300 019-2-3 Note: All specifications are subject to change without notification. 11V0005-029 PMP 25 V3.0 www.power-one.com