PMP 7 Rectifier Module Description The Power-One PMP 7 rectifier module provides a cost-effective power solution in the highest possible density. Built on the latest advances in the resonance switch mode approach (soft-switching), the PMP 7 is the next evolution in our small convection cooled rectifier series. Optimized for telecom applications, the module is designed to work in a multitude of different subrack/shelf configurations incorporating the Power-One PCU controller and various distribution options. Features • 208/240 VAC input • 24V, 48V, or 60V DC output • Input overvoltage disconnection • Thermal protection • Active load sharing • Hot-swappable • Up to 92% efficient • International standards compliance • Natural convection cooling PPS 7 3500 System Shown • Low weight www.power-one.com PMP 7 Rectifier Module Mechanical Input Model PMP 7.24 PMP 7.48 Input Voltage 205-250V AC ±10% single phase, (44-66Hz) (-15% for PMP7.60) 185-160V at reduced output power Current (max.) <3.55A <4.35A Dimensions 62 x 129 x 232mm (2.4 x 5.1 x 9.1in.) Weight 1.65kg (3.6lbs.) Cooling Natural convection <4.35A Soft Start <11A peak max. 5ms Harmonics EN 61000-3-2 Power Factor >0.99 at max. load Surge Immunity EN 61000-4-5 Fuse T 6,3A Connection IEC-320/C14 EMC <15.5A peak max. 5ms PMP 7.60 <20A peak max. 5ms Insulation Enclosure IP20 Mounting In 19” subrack up to 5 modules Other Technical Data Safety EN 60950 UL 1950 and IEC60950 , Class 1 CSA C22-2 No. 950 Protection Short circuit proof, automatic current limiting, selective shutdown of modules at excessive output voltage. Thermal protection reduces the output power at environmental temperatures above maximum level. Shut down at >75°C with an automatic restart.* Input over-voltage disconnection at >275VAC with automatic reset at >260VAC. EN 61000-6-2, EN 61000-6-3, FCC Part 15 Class B Output Model PMP 7.24 PMP 7.48 PMP 7.60 Output Voltage 22.5-28VDC 45-56VDC 56-70.5VDC Power (max.) 560W 672W 635W Current (max.) 20A 12A 9A Efficiency >89.5% (at 40-90% load)* Reinforced insulation tested at: 4.25 kV DC primary-secondary, 2.12 kV DC primary-ground, 0.75 kV DC secondary ground >92% >92% Green LED Power ON Red LED High output voltage/ shutdown Red LED Low voltage/ module failure Indications Tolerance Vout +/- 1% Transient Response +/- 5% at load variation 10-90% or 90-10%, recovery time 10ms Load Sharing <5% of nominal current Audible Noise <35dBA Ripple <100mV p-p (BW. 30MHz) Operating Temperature* -25 to +55°C up to 2000m -25 to +45°C above 2000m Psophometric <2mV, according to CCITT norms Storage Temperature -40 to +85°C Radiated EMC EN 61000-6-2, EN 61000-6-3, FCC Part 15, Class B Environment Storage: Transport: Operation: Connection EMC DIN 41612F EN 61000-6-2, EN 61000-6-4 *Average performance for a single module. ETS 300 019-2-1 ETS 300 019-2-2 ETS 300 019-2-3 Note: All specifications are subject to change without notification. 11V0005-028 PMP 7 V3.0 www.power-one.com