DC-AC INVERTER UNIT PS-DA0151-02(S) (5 W SINGLE OUTPUT) (PRELIMINARY INFORMATION) DESCRIPTION : This low profile DC to AC Inverter is developed for single lamps. Optimized for Sharp: LQ057Q3DC12, 26th Sept. 2006 02 APPLICABLE LCD: Lamp Voltage 690 Vrms Lamp Current 5.0 mArms Lamp Start Up Voltage 2.400 Vrms (Vin : 5 Vdc) FEATURES : Current balance circuit Extra high starting Voltage Dimming function over ext. PWM-signal RoHS compliant (S) TEMPERATURE & HUMIDITY : Operating Temperature Range Storage Temperature Range Humidity DIMENSIONS : -30°C ~ +70°C (only LQ057Q3DC12) -30°C ~ +85°C 95 %RH max L x B x H 100 x 30 x 9 mm SM02(8.0)B-BHS-1-TB (JST) Pin 1 Pin 1 Unit : mm Weight :15 (g) typ. Note: Please use plastic screw in case of a non-insulating mounting base! Components No. 1 2 3 Part Description PCB Connector CN1 Connector CN2 Qty. 1 1 1 Material UL94V-0 (FR-4 or CEM-3) S5B-PH-SM3 SM02(8.0)B-BHS-1-TB Note t=1m m JST or equal JST or equal Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (1) Version 1.0.1, 6th October 2008 DC-AC INVERTER UNIT PS-DA0151-02(S) (5 W SINGLE OUTPUT) Input side CN1: Pin No. Symbols Vin CN 1-1 GND CN 1-2 Ext. PWM CN 1-3 N.C. CN 1-4 N.C. CN 1-5 (PRELIMINARY INFORMATION) Output side CN2: Pin No. Symbols VLOW CN 2-1 N.C. CN 2-2 VHIGH CN 2-3 Ratings 4.75~5.25 Vdc 0 ~ 5 Vdc (L activ) - Ratings (GND) 690Vrm s (5m Arm s ) - ELECTRICAL CHARACTERISTICS : Conditions Parameters Symbols Output Current Output Current Input Current Frequency Open Circuit Voltage No Load Shotdown Iout Iout Iin F Vopen Ts d Note 1 : Note 2: Vin (V) Vbr (V) 5±0.25 5±0.25 5±0.25 5±0.25 5.0 5±0.25 0.0 5.0 0.0 0.0 0.0 0.0 Specification Tu (°C) -30 -30 -30 -30 -30 -30 ~ +70 ~ +70 ~ +70 ~ +70 ~ +70 ~ +70 Min. Typ. Max. 4.5 50 2.200 - 5.0 10 0.7 60 2.400 1.0 5.5 1.1 70 2.700 - Unit Note m Arm s % Adc kHz Vrm s s ec Dut y 100 % witho ut lo ad Please keep minimum of 2mm clearance (all directions) between inverter high voltage area as marked on mechanical drawing and any conductors. The external PWM frequency should be in a range of 100 ~ 500 Hz. For other frequency please request. The optimum is normally at 250 Hz, and minimizes the interference disturbances of the vertical sync. frequency. TEST CIRCUIT : Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (2) Version 1.0.1, 6th October 2008 DC-AC INVERTER UNIT PS-DA0151-02(S) (5 W SINGLE OUTPUT) (PRELIMINARY INFORMATION) ORDER KEY : PS-DA0151-02-x With order of this innverter please give the following key: -x Without Vrmt -A: With Vrmt by CN1 Pin5 Examples: PS-DA0151-01 (S) Inverter without Vrmt PS-DA0151-01-A (S) Inverter with Vrmt Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (3) Version 1.0.1, 6th October 2008