155 Mbps SFP Transceiver (LR1) SP-03-LR1 Features • Single 3.3V Supply • 29dB Minimum Link Budget • Commercial and Industrial Temperature Available • 1310nm FP Laser • SFP MSA SFF-8074i Compliant • GR-253/ITU-T G.957 Compliant • IEEE 802.3ah Fast Ethernet Compliant • Digital Diagnostic SFF-8472 Compliant • Telcordia GR-468 Compliant • Color coded bail latch: Grey • RoHS compliant General Operation Symbol Min. Typical Max. Supply Voltage Parameter Vcc 3.135 3.3 3.465 Unit V Total Current Icc - - 300 mA Power Supply Noise Rejectiona PSR 100 - - mVp-p Operating Temperature (-CxA) Top -5 - 70 ºC Operating Temperature (-TxA) Top -40 - 85 ºC Storage Temperature Tst -40 - 85 ºC Data Rate OC-3/STM-1 DR 125 155 - Mbps Symbol Min Typical Max Unit Optical Power POP -5 -2.5 0 dBm Average Launch Power (Tx:Off) POff - - -45 dBm Extinction Ratio ER 10 - - dB Jgen - - 0.002 UI Optical Rise Timeb tr - - 2 ns Optical Fall Timeb tf - 2 ns Mean Wavelength λ 1263 1310 1360 nm ∆λ - - 3 nm a) 20Hz to 155MHz Transmitter Specifications Parameter Eye Mask Optical Jitter Generation Spectral Width (RMS) SONET/SDH Compliant Dispersion Penalty (40km) - 0.5 1 dB Relative Intensity Noise RIN - - -120 dB/Hz Reflectance Tolerance rp -24 - - dB b) 20%-80% values LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS835-Jan2208 Rev A.5 155 Mbps SFP Transceiver (LR1) SP-03-LR1 Transmitter Specifications (Electrical) Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω PECL Single-Ended Data Input Swing Vin,p-p 250 - 1200 mV TxFault_Fault Vfault 2 - Vcc V Vnormal Vee - Vee+0.5 V Vd 2 - Vcc V Ven Vee - Vee+0.8 V Symbol Min Typical Max Unit Rsens,low - -36 -34 dBm Receive Power High Rsens,high -10 - - dBm Damage Threshold For Receiver Pin,damage 4 - - dBm λ 1263 1310 1360 nm -44 - - dBm LOS De-Assert - - -34 dBm LOS Hysteresis 0.5 - - dB Input Differential Impedence TxFault_Normal TxDisable_Disable TxDisable_Enable Receiver Specifications (Optical) Parameter c Receive Power Low c d Wavelength LOS Assert c) at 10-10, PRBS 223-1 d) Operational over 1200 to 1625nm range Receiver Specifications (Electrical) Parameter Symbol Min Typical Max Unit PECL Single-Ended Data Output Swing Vout, p-p 185 - 800 mV Data Output Rise Time tr - - 2 ns Data Output Fall Time tf - - 2 ns Timing and Electrical Parameter Symbol Min Typical Max Unit t_on - - 25 ms Tx Disable Assert Time t_off - - 10 µs Time to Initialize, Including Reset Of Tx Fault t_init - - 300 ms t_fault - - 100 µs Tx Disable Negate Time Tx Fault Assert Time Tx Disable to Reset t_reset 10 - - µs t_loss_on - - 300 µs LOS De-Assert Time t_loss_off - - 100 µs Serial ID Clock Rate f_serial_clock - - 100 KHz 2 - - V LOS Assert Time RX_LOS Voltage (High) RX_LOS Voltage (Low) LOS Output Voltage-Fault LOS Output Voltage-Normal - - 0.8 V VLOS fault 2 - Vcc V VLOSnormal Vee - Vee+0.5 V MOD_DEF (0:2)-High Vh 2 - Vcc V MOD_DEF (0:2)-LOW Vl Vee - Vee+0.5 V LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS835-Jan2208 Rev A.5 155 Mbps SFP Transceiver (LR1) SP-03-LR1 Diagnostics (SP-03-LR1-xDA) Parameter Range Accuracy Unit Calibration Temperature (-CDA) -5 to 70 ±3 ºC External Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Formula Temperature (-TDA) -40 to 85 ±3 ºC External Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Voltage 0 to Vcc ±0.1 V External V(Volts) = Vslope*Vad (16 bit unsigned integer) + Voffset Bias current 0 to 120 ±5 mA External I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX Power -5 to 0 ±3dB dBm External TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer) +TX_PWRoffset RX Power -34 to -10 ±3dB dBm External RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Pinout Definitions Pin Function 1 VeeT Notes TX GND 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX GND 15 VccR RX Power 16 VccT TX Power 17 VeeT TX GND 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS835-Jan2208 Rev A.5 155 Mbps SFP Transceiver (LR1) SP-03-LR1 EEPROM Serial ID Name of Field Vendor Name Vendor OUI Vendor P/N LUMINENTOIC.COM Description of Field SFP Vendor name(ASCII) IEEE vendor OUI code for LuminentOIC Inc. Part number in ASCII, e.g. SP-03-LR1-CDA Address Hex ASCII 20 4C L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 41 50 P 42 30 0 43 33 3 44 4C L 45 52 R 46 13 1 47 43 C 48 44 D 49 41 A 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 S LUMNDS835-Jan2208 Rev A.5 155 Mbps SFP Transceiver (LR1) SP-03-LR1 Outline drawing Units in mm(inches) LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS835-Jan2208 Rev A.5 155 Mbps SFP Transceiver (LR1) SP-03-LR1 Suggested Transceiver interface 1�H Vcc 10�F 1�H 0.1�F VCCT .01�F Protocol IC R1 LuminentOIC SFP 10K� TX_DISABLE TX_DISABLE TX_FAULT TX_FAULT TD + SerDes Laser Driver .01�F 100� TD VEET .01�F VCCR 10�F 0.1�F RD + Receiver Amplifier .01�F 100� RD - RX_LOS RX_LOS Vcc R VEER 1 R1 R1 .01�F EEPROM R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1=4.7K to 10K� LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS835-Jan2208 Rev A.5 155 Mbps SFP Transceiver (LR1) SP-03-LR1 Ordering Information Available Options: SP-03-LR1-CDA SP-03-LR1-TDA SP-03-LR1-CNA SP-03-LR1-TNA Part Numbering Definition: SP - 03 - L R 1 - Temperature Diagnostic Revision • SP = Small Form Pluggable • 03 = OC-3/STM-1 (155 Mbps) • LR1 = Long Reach 40km • Operating Temperature C = Commercial temperature (-5 to 70ºC) T = Industrial temperature (-40 to 85ºC) • D = Digital Diagnostic (SFF-8472) N = No Digital Diagnostic • Ordering Information A = RoHS compliant Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS835-Jan2208 Rev A.5