10Km Gigabit Ethernet SFP Transceiver SP-GB-LX Features • Data Rate 1.062 to 1.25 Gb/s • Single 3.3V Supply • 10km Reach • 13dB Typical Link Budget • Commercial, Reduced and Industrial Temp. Operation • 1310nm FP Laser • Fibre Channel 100-SM-LC-L Compliant • Gigabit Ethernet IEEE 802.3ah Compliant • SFP MSA SFF-8074i Compliant • Telcordia GR-468 Compliant • Digital Diagnostic SFF-8472 Compliant • Color code Bail Latch : Blue • RoHS compliant General Operation Symbol Min. Typ. Max. Supply Voltage Parameter Vcc 3.135 3.3 3.465 Unit V Total Current ICC - - 300 mA Power Supply Rejectiona PSR 100 - - mVp-p Operating Case Temperature (-CxA) Topr -5 - 70 ºC Operating Case Temperature (-RxA) Topr -20 - 85 ºC Operating Case Temperature (-TxA) Topr -40 - 85 ºC Storage Temperature Tstg -40 - 85 ºC Data Rate GbE DR - 1250 - Mbps Data Rate FC DR - 1062.5 - Mbps Symbol Min Typical Max Unit Optical Power Pop -9 -5 -3 dBm Average Launch Power (Tx:Off) Poff - - -30 dBm Extinction Ratio ER 9 - - dB a) 20Hz to 155MHz Transmitter Specifications (Optical) Parameter Eye Mask IEEE 802.3ah compliant Total Jitter TJ - - 200 ps Optical Rise Timeb tr - - 260 ps b Optical Fall Time tf - - 260 ps Mean Wavelength λ 1270 1310 1355 nm Spectral Width (RMS) ∆λ Relative Intensity Noise RIN IEEE 802.3ah 1000BASE-LX10 Compliant - - -120 dB/Hz b) 20%-80% values LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS833-Jul1008 Rev A.7 10Km Gigabit Ethernet SFP Transceiver SP-GB-LX Transmitter Specifications (Electrical) Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω Vin, p-p 250 - 1200 mV Vfault 2 - Vcc V Vnormal Vd Vee - Vee + 0.5 V TxDisable_Disable 2 - Vcc V TxDisable_Enable Ven Vee - Vee + 0.8 V Parameter Symbol Min Typical Max Unit Receiver Power Lowc - -24 -22 dBm Receiver Power Highc Rsens,low Rsens,high -3 0 - dBm Damage Threshold for Receiver Pin, damage 6 - - dBm λ 1270 - 1355 nm RX_r - - -12 dB LOS Assert - -38 - - dBm LOS De-Assert - - - -22 dBm LOS Hysteresis - 0.5 - - dB Input Differential Impedence PECL Single Ended Data Input Swing TxFault_Fault TxFault_Normal Receiver Specifications (Optical) Wavelengthd Maximum Reflectance of Receiver -12, 27-1, PRBS of c) Measured at BER of 10 d) Operational over 1200-1625nm range at eye center Receiver Specifications (Electrical) Parameter Symbol Min Typical Max Unit PECL Single-Ended Data Output Swing Vout,p-p 185 - 800 mV Data Output Rise Time tr - - 260 ps Data Output Fall Time tf - - 260 ps Timing and Electrical Symbol Min Typical Max Unit Tx Disable Negate Time Parameter t_on - - 1 ms Tx Disable Assert Time t_off - - 10 µs Time to Initialize, Including Reset of Tx Fault t_init - - 300 ms Tx Fault Assert Time t_fault - - 100 µs Tx Disable to Reset t_reset 10 - - µs t_loss_on - - 100 µs t_loss_off f_serial_clock Rx_LOSH 2 - 100 100 Vcc µs KHz V LOS Assert Time LOS De-assert Time Serial ID Clock Rate RX_LOS Voltage (high) RX_LOS Voltage (low) RX_LOSL - - 0.8 V LOS Output Voltage-Fault VLOS fault 2 - Vcc V VLOS normal Vee - Vee + 0.5 V MOD_DEF (0:2)-High Vh 2 - V MOD_DEF (0:2)-Low VI Vee - Vcc Vee + 0.5 LOS Output Voltage-Normal LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 V LUMNDS833-Jul1008 Rev A.7 10Km Gigabit Ethernet SFP Transceiver SP-GB-LX Diagnostics Parameter Range Accuracy Unit Calibration Formula Temperature (-CDA) -5 to 70 ±3 ºC External Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Temperature (-RDA) -20 to 85 ±3 ºC External Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Temperature (-TDA) -40 to 85 ±3 ºC External Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Voltage 0 to Vcc 0.1 V External V(Volts) = Vslope*Vad (16 bit unsigned integer) + Voffset Bias Current 0 to 120 5 mA External I(mA) = Islope * Iad(16 bit unsigned integer)+Ioffset Tx Power -9 to -3 ±3dB dBm External Tx_PWR(µW) = Tx_PWRslope*Tx_PWRad(16 bit unsigned integer)+Tx_PWRoffset Rx Power -22 to -3 ±3dB dBm External Rx_PWR(µW) = A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Pinout Definitions Pin Function Notes 1 VeeT TX GND 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX GND 15 VCCR RX Power 16 VCCT TX Power 17 VeeT TX GND 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS833-Jul1008 Rev A.7 10Km Gigabit Ethernet SFP Transceiver SP-GB-LX EEPROM Serial ID Name of Field Vendor Name Vendor OUI Vendor P/N LUMINENTOIC.COM Discription of Field SFP Vendor name (ASCII) IEEE vendor OUI code for LuminentOIC Inc. Part number in ASCII, e.g. SP-GB-LX-CDA Address Hex 20 4C L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 41 50 P 42 47 G 43 42 B 44 4C L 45 58 X 46 43 C 47 44 D 48 41 A 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 ASCII S LUMNDS833-Jul1008 Rev A.7 10Km Gigabit Ethernet SFP Transceiver SP-GB-LX Outline Drawing Units in mm(inches) LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS833-Jul1008 Rev A.7 10Km Gigabit Ethernet SFP Transceiver SP-GB-LX Suggested Transceiver interface 1�H Vcc 10�F 1�H 0.1�F VCCT .01�F Protocol IC R1 LuminentOIC SFP 10K� TX_DISABLE TX_DISABLE TX_FAULT TX_FAULT TD + SerDes Laser Driver .01�F 100� TD VEET .01�F VCCR 10�F 0.1�F RD + Receiver Amplifier .01�F 100� RD - RX_LOS RX_LOS Vcc R VEER 1 R1 R1 .01�F EEPROM R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1=4.7K to 10K� LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS833-Jul1008 Rev A.7 10Km Gigabit Ethernet SFP Transceiver SP-GB-LX Ordering Information Available Options: SP-GB-LX-CDA SP-GB-LX-TDA SP-GB-LX-RDA SP-GB-LX-CNA SP-GB-LX-TNA SP-GB-LX-RNA Part numbering Definition: SP - GB - LX - Temperature Diagnostic Revision • SP = Small Form Pluggable GB = 1.25Gbps LX = IEEE 802.3 LX Interface • Operating Temperature C = Commercial temperature (-5 to 70ºC) R = Reduced Industrial (-20 to 85ºC) T = Industrial temperature (-40 to 85ºC) • Diagnostic D = Digital Diagnostic (SFF-8472) N = No Diagnostic • Design Revision A = RoHS compliant Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS833-Jul1008 Rev A.7