ANAREN I100N50X4

ROHS
Compliant
Model I100N50X4
Flange Mount Termination
100 Watts, 50Ω
Description
The I100N50X4 is high performance Aluminum Nitride (AlN) flange mount
termination intended as a cost competitive alternative to Beryllium Oxide
(BeO). The termination is well suited to all cellular frequency bands such
as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling
makes the part ideal for terminating circulators, and for use in power
combiners. The termination is also RoHS compliant!
General Specifications
Features:
• RoHS Compliant
• 100 Watts
• DC – 3.0 GHz
• AlN Ceramic
• Non-Nichrome Resistive
Element
• Low VSWR
• 100% Tested
Resistive Element
Substrate
Cover
Thick Film
AlN Ceramic
Alumina Ceramic
Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed
applicable portions of MIL-E-5400. All dimensions in inches.
Electrical Specifications
Resistance Value:
Power:
Frequency Range:
V.S.W.R.
50 Ohms, ± 2%
100 Watts
DC – 3.0GHz
1.25 : 1
Specification based on unit properly installed using suggested mounting instructions
and a 50 ohm nominal impedance. Storage temperature is -20°C to 85 ºC . Operating
temperature is -55ºC to 125ºC (see chart for derating temperatures). Specifications
subject to change with out notice.
Outline Drawing
Note: All dimensions in inches – 1inch = 2.54cm. Lead Length: 0.150in min.
I100N50X4 (097) Rev D.
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392
Model I100N50X4
ROHS
Compliant
Typical Performance:
Power De-rating:
Mounting Footprint and Procedure:
I100N50X4 (097) Rev D.
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392