Embedded Power for Business-Critical Continuity Rev. 01.19.06 DS650-9 1 of 4 DS650-9 650 Watts 48V Distributed Power System Distributed Power Bulk Front-End Total Output Power: 650 Watts +48Vdc main Output +3.3vdc Stand-by Output Wide Range Input voltage: 90 - 264VAC Electrical Specifications Special Features Input Input range 90-264 VAC (wide range) • Active Power Factor Correction • EN61000-3-2 Harmonic Compliance • Active AC Inrush Control • 1U X 2U Form Factor • 11.76W / in3 (DS650) • +48Vdc Output • +3.3vdc Stand-By (5V standby - consult factory) • No Minimum Load Required • Hot Plug Operation • N + 1 Redundant • Internal OR'ing Fets • Active Current Sharing (10 - 100% load) • Built-in Cooling Fans (40mm x 28mm) • I2C Communication Interface Bus • EERPOM for FRU Data • Red/Green Bi-Color LED Status • Internal Fan Speed Control • Fan Fail Tach Output Signal • INTEL, SSI Std. Logic Timing • INTEL, SSI Std. FRU Data Format • One Year Warranty Frequency Inrush current 47-53 Hz, single phase AC Safety UL/cUL 60950 (UL Recognized) NEMKO+ CB Report EN60950 EN60950 CE Mark China CCC Efficiency 55A maximum inrush current >82% typical at full load, high line Conducted EMI FCC Subpart J EN55022 Class B Radiated EMI FCC Subpart J EN55022 Class B Power factor 0.99 typical Leakage current 1.40mA @ 240VAC Hold up time 20ms minimum Output Main DC voltage +48v @ 13.2A Stand-By +3.3vsb @ 6A (5V @ 4A available) Adjustment range Factory Set, no pot adjustments +48vdc; +5%/-5% +3.3vsb; +5%/-5% +48vdc;14.5A - 19.8A latches off if overcurrent lasts over 1 second, otherwise it is auto recovery (See Table 1 next page) +3.3vsb, 9A max (hiccup mode) +48vdc; 52.8 - 57.6vdc +3.3vsb; 3.76 - 4.30vdc +48vdc; 36 - 43.2V (latch off) 2 Second max, 20 - 200mS, Monotonic Rise 2 -200mS, Monotonic Rise Regulation Over current Over voltage Under voltage Turn-on delay +48vOutput Rise Time Embedded Power for Business-Critical Continuity Rev. 01.19.06 DS650-9 2 of 4 Logic Control TTL logic LOW if power supply is seated into system connector. This is a short pin. A logic HIGH if the PSU is removed PS_SEATED PWR GOOD AC OK Active TTL LOW when output is within regulation limits. A HIGH logic level if the input voltage is within allowable limits. A TTL logic HIGH level, and a 5mS early warning signal before 48.0v DC output loss of regulation. Temp OK A TTL logic HIGH, when operating within allowable temperature range. PS_INHIBIT/PS_KILL This signal is connected to a short pin on the PSU When left open power supply operation will be inhibited. When the power supply is inserted into the system, this pin will be pull low by the system and turn the power supply on only after all other power supply pins have seated. Environmental Specifications Operating temperature: -10° to 50°C ; 50% power derating at 70°C Storage temperature: Altitude, operating 10,000ft. -40°C to +85°C Electromagnetic -EN61000-3-2, -3-3 susceptibility / Input transients: -EN61000-4-2, 4.3, 4-4, -4-5, 4-11 Level -EN55024:1998 RoHS & lead-free compliant (no tantalum caps.) Humidity: 20 to 90% RH, non-condensing Shock and vibration specificatons complies with Astec Std. Specifications, Q3205 MTBF (Demonstrated) 500K Hrs at full load, 40°C Ordering Information Output DS650-9 Nominal Output Set Point Total Minimum Voltage Set Point Tolerance Regulation Current 48.0vdc 3.3vsb ±0.2% ±1% ±5% ±5% 0A 0A Maximum Current Output Ripple P/P Over Current 13.2A 6.0A 480mV 60mV 14.5 - 19.8* 7A max *Over current latches off if overcurrent lasts over 1 seconds, otherwise it is auto recovery. *For 5vsb, consult marketing. Embedded Power for Business-Critical Continuity Rev. 01.19.06 DS650-9 3 of 4 Mechanical Drawing Condition LED Status +3V3SB-ON; +48VOUT-OFF; AC PRESENT Blinking Green +3V3SB-ON, +48VOUT-ON Solid Green +48V_OCP, +48V_UVP, +48OVP Blinking Red FAN_FAULT, OTP, 3V3 OCP/UVP Solid Red AIRFLOW DIRECTION 3.09" (78.5) .649 (16.5) 11.0" ± .02" (279.4 ±0.5) 7.48" (190.0) (3X) 3.09" (78.5) .315" (8.0) .275" (7.0) MODEL DS850-3 SEE NOTE 3 (65.5) 1.60" (40.7) ASTEC (40.5) 3.20" ±.02" (81.3) ±0.5 (15.5) 10.85" ±.03" (275.5 ±0.7) BI-COLOR LED .638" ±.02" (16.2 ±0.6) 1.58" (40.2) .897" ±.02 (22.8 ± 0.6) .142" ±.02" (3.6 ±0.5) .767" (19.5) CLIP COMPRESSED (2X) 3.30" ±.03" (83.8 ±0.7) 3.09" (78.5) .354" (9.0) FULL R .236" .256" (6.0) (6.5) 1.57" ±.02" (39.9 ±0.5) Embedded Power for Business-Critical Continuity DC Output Connector Pinout Assignment Astec Power Male connector as viewed from the rear of the supply: D1 D2 D3 D4 D5 D6 C1 C2 C3 C4 C5 C6 B1 B2 B3 B4 B5 B6 A1 A2 A3 A4 A5 A6 PB1 PB2 PB3 PB4 PB5 PB6 P1 - Power Supply Side 1. FCI Power Blade 51721 series 51721-10002406AA 2. Molex Power Connector SD-87667 series 87667-7002 Mating Connector (System side) 1.FCI Power Blade 51741-10002406CC Strait Pins 2.FCI Power Blade 51761-10002406AA Right Angle Pin PB 1 PB 2 PB 3 PB 4 PB 5 PB 6 A1 A2 A3 A4 A5 A6 B1 B2 B3 B4 B5 B6 C1 C2 C3 C4 C5 C6 D1 D2 D3 D4 D5 D6 Signal Name +48V RETURN +48V RETURN +48V RETURN +48V +48V +48V PS_ON +48V RMT SENSE RETURN TEMP_OK PS_SEATED ( Power Supply Seated) +3V3 STAND-BY +3V3SB RETURN AC_OK (AC Input Present) +48V RMT SENSE +48V CURRENT SHARE PS_INHIBIT +3V3 STAND-BY +3V3SB RETURN SDA (I2C Data Signal) SCL (I2C Clock Signal) POWER GOOD FAN FAIL (Fan Fail Signal) +3V3 STAND-BY +3V3SB RETURN A0 (I2C Address BIT 0 Signal) A1 (I2C Address BIT 1 Signal) S_INT (Alarm) +3V3 STAND-BY RMT SENSE +3V3 STAND-BY +3V3SB RETURN Rev. 01.19.06 DS650-9 4 of 4 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone: +1 760 930 4600 Facsimile: +1 760 930 0698 Technical Support: +1 888 41 ASTEC or +1 407 241 2752 Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom Telephone: +44 (0) 1384 842 211 Facsimile: +44 (0) 1384 843 355 Units 2111-2116, Level 21 Tower 1, Metroplaza 223, Hing Fong Road Kwai Fong, New Territories Hong Kong Telephone: +852 2437 9662 Facsimile: +852 2402 4426 For global contact, visit: www.astecpower.com [email protected] While every precaution has been taken to ensure accuracy and completeness in this literature, Astec Power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Printed in US A Emerson Network Power. The global leader in enabling business-critical continuity. AC Power Connectivity DC Power Embedded Power Inbound Power Integrated Cabinet Solutions Outside Plant Precision Cooling Site Monitoring and Services EmersonNetworkPower. com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2006 Emerson Electric Co.