Embedded Power for Business-Critical Continuity Rev. 5.01.09_52 DS2000-3 of 4 DS2000-3 2000 Watts 12 V Distributed Power System Distributed Power Bulk Front-End Total Output Power: 2000 Watts +12 Vdc main Output +3.3 Vdc Stand-by Output Wide Range Input voltage: 90 - 264 Vac Electrical Specifications Special Features •Active power factor correction •EN61000-3-2 harmonic compliance •Active AC inrush control •1U X 3U form factor •26.14 W / in3 •+12 Vdc output •+3.3 Vdc Stand-By (5 V standby - consult factory) •No minimum load required •Hot plug operation •N + 1 redundant •Internal OR’ing fets •Active current sharing (10 - 100% load) •Built-in cooling fans (40 mm x 28 mm) •I2C communication interface bus •PM Bus compliant •EERPOM for FRU data •Red/Green bi-color LED status •Internal fan speed control •INTEL, SSI Std. logic timing •INTEL, SSI Std. FRU data format •One year warranty Safety • UL/cUL 60950 (UL Recognized) • NEMKO+ CB Report EN60950 • EN60950 • CE Mark • China CCC Input Input range 90-264 Vac (wide range) 90 - 264 1200 W load, nominal 100 Vac 180 - 264 2000 W load, nominal 200 Vac Frequency Inrush current 47-63 Hz, single phase AC Efficiency 55A maximum inrush current >89% typical at full load, high line Conducted EMI FCC Subpart J EN55022 Class B Radiated EMI FCC Subpart J EN55022 Class B Power factor 0.99 typical Leakage current 1.40 mA @ 240 Vac Hold up time 12 ms minimum Output Main DC voltage Stand-By Adjustment range Regulation Over current Over voltage Under voltage Turn-on delay +12 V Output Rise Time +12 V @ 164.2 A 180 - 264 Vac +12 V @ 100 A 90 - 264 Vac +3.3 Vsb @ 9 A (5 V @ 5 A TBA) Factory Set, no pot adjustments +12 Vdc; ±5% +3.3 Vsb; ±5% +12 Vdc; latches off if overcurrent lasts over 1 second, otherwise it is auto recovery (See ordering info next page) +3.3 Vsb, 9 A max (same as +12 Vdc) +12 Vdc; 13.2 - 14.4 Vdc +3.3 Vsb; 3.76 - 4.30 Vdc +12 Vdc; 9 - 10.8 V (latch off) 2 Second max, 5 - 300 ms, Monotonic Rise 5 - 50 ms, Monotonic Rise Embedded Power for Business-Critical Continuity Logic Control PS_SEATED TTL logic LOW if power supply is seated into system connector. This is a short pin. A logic HIGH if the PSU is removed PWR GOOD Active TTL LOW when output is within regulation limits. AC OK A LOW logic level if the input voltage is within allowable limits. A TTL logic HIGH level, and a 2mS early warning signal before 12.0v DC output loss of regulation. PS_INHIBIT/PS_KILL This signal is connected to a short pin on the PSU When left open power supply operation will be inhibited. When the power supply is inserted into the system, this pin will be pull low by the system and turn the power supply on only after all other power supply pins have seated. Environmental Specifications Operating temperature -10 °C to 50 °C ; Derate output power to 50% at 70 °C Storage temperature -40 °C to +85 °C Altitude, operating 10,000 ft Electromagnetic susceptibility / Input transients -EN61000-3-2, -3-3 -EN61000-4-2, 4.3, 4-4, -4-5, 4-11 Level -EN55024:1998 RoHS & lead-free compliant (no tantalum caps). Humidity 20 to 90% RH, non-condensing Shock and vibration Specifications complies with Astec Std. Specifications, Q3205 MTBF (Demonstrated) 500 K Hrs at full load, 40 °C Ordering Information Output DS2000-3 Nominal Output Set Point Total Minimum Voltage Set Point Tolerance Regulation Current 12.0 Vdc 3.3 Vsb ±0.2% ±1% ±5% ±5% 0A 0A Maximum Current Output Ripple P/P Over Current 164.2 A 7.0 A 120 mV 60 mV 120 - 130% of nominal 100 - 125% of nominal *Over current latches off if overcurrent lasts over 1 second, otherwise it is auto recovery. *For 5 Vsb, consult marketing. Rev. 5.01.09_52 DS2000-3 of 4 Embedded Power for Business-Critical Continuity Rev. 5.01.09_52 DS2000-3 of 4 Mechanical Drawing Condition LED Status +3V3SB-ON; +12VOUT-OFF; AC PRESENT Blinking Green +3V3SB-ON, +12VOUT-ON Solid Green +12V_OCP, +12V_UVP, +48OVP Blinking Red FAN_FAULT, OTP, 3V3 OCP/UVP Solid Red Embedded Power for Business-Critical Continuity Americas DC Output Connector Pinout / Functions 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone:+1 760 930 4600 Facsimile: +1 760 930 0698 Unit Connector; Molex Blade, (LPH Series) 45985-xxx Mating Connector; Molex Blade, (LPH Series) SD-45984-1462 Signal Descriptions Signal Pin #Comp Side Top Row A17 A18 A19 A20 A21 A22 A23 A24 A25 A26 A27 A28 A29 A30 A31 A32 Signal Function Signal Description SPARE AC OK# AC input present A0 I2C address bit 0 A2 I2C address bit 2 SCL I2C Clock signal PWOK# Pwr OK output 12LS 12V load share bus +12VRS Rtn +12V Rmt Sen Rtn 3.3vsb Stand-By 3.3vsb Stand-By 3.3vsb Stand-By 3.3vsb Stand-By 3.3vsb Rtn Stand-By return 3.3vsb Rtn Stand-By return 3.3vsb Rtn Stand-By return 3.3vsb Rtn Stand-By return Power Blade PB1 Top +12vdc PB2 Top +12vdc PB3 Top +12vdc PB4 Top +12vdc Rtn PB5 Top +12vdc Rtn Signal Pin #Solder Side Bottom Row A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 A11 A12 A13 A14 A15 A16 Signal Function SPARE FAN FAIL# Fan Fail Signal SPARE A1 I2C address bit 1 SDA I2C Data signal PRESENT# Power supply present PSON# Power enable input +12V RS +12V Remote Sense 3.3vsb Stand-By 3.3vsb Stand-By 3.3vsb Stand-By 3.3vsb Stand-By 3.3vsb Rtn Stand-By return 3.3vsb Rtn Stand-By return 3.3vsb Rtn Stand-By return 3.3vsb Rtn Stand-By return Power Blade PB1 Bottom +12vdc PB2 Bottom +12vdc PB3 Bottom +12vdc Rtn PB4 Bottom +12vdc Rtn PB5 Bottom +12vdc Rtn Main Output Main Output Main Output Main Output Main Output Signal Description Main Output Main Output Main Output Main Output Main Output PB2 PB3 PB4 PB5 Europe (UK) Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom Telephone:+44 (0) 1384 842 211 Facsimile: +44 (0) 1384 843 355 Asia (HK) 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong Telephone:+852 2176 3333 Facsimile: +852 2176 3888 For global contact, visit: www.PowerConversion.com techsupport.embeddedpower @emerson.com While every precaution has been taken to ensure accuracy and completeness in this literature, Emerson Network Power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Emerson Network Power. The global leader in enabling business-critical continuity. AC Power Connectivity Mating Connector - Molex p/n: 45984-1462 PB1 Rev. 5.01.09_52 DS2000-3 of 4 DC Power Signal Pin A1 Bottom Left Signal Pin A17 Top Left Embedded Computing Embedded Power Monitoring Outside Plant A17 OPTIONAL GUIDES TOP ROW BOTTOM ROW Power Switching & Controls Precision Cooling Racks & Integrated Cabinets TOP ROW BOTTOM ROW Services Surge Protection A1 NO OF SIGNALS OPTIONAL SEE CHART OPTIONAL PEGS EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2009 Emerson Electric Co.