Fuse Clips For 1/4 inch (6.35mm) Diameter Fuses TYPE FC-101 .280 PC Board Mount [Ear Stops] .425 BEL .14 .065 .30 .312 Material Brass (65Cu/35Zn), 0.020 inch thick, full hard temper Plating Bright tin (150 microinch, minimum), over nicke barrier plate Solderability Per Mil-Std-202F, Method 208 TYPE FC-102 PC Board Mount [Earless] .280 .425 Torque Minimum 1.0 in.-oz. to twist a fuse in a single clip Extraction Minimum 2 lbs. to extract a fuse from a single clip BEL .14 Marking “bel” die stamped on 1 side .065 .30 Ampere Rating FC-101, -102 -up to 15A. FC-201, -211 -up to 10A NOTE - suitability at higher currents is dependent on fuse type, circuit conditions, AND PC board design (track width/thickness, means to solder clip legs, etc). Each combination of clip, fuse, PC board and operating condition needs to be evaluated .312 For 5mm Diameter Fuses TYPE FC-201 5mm Clip PC Board Mount [Ear Stops] .245 BEL .34 .14 .265 .066 .250 The Type FC-211 Locking Clip is designed for 5 mm diameter fuses, for use in 0.062 inch thick printed circuit boards. The legs have tabs which “lock” into the board and prevent “floating” of the clip during wave solder.This design also allows elimination of the “clinching” operation on the underside of the board. TYPE FC211 Locking Type PC Board Mount [Ear Stops] .245 .34 .059 .035 .011 .14 .045 .265 .25 .028 REF .066 Specifications subject to change without notice Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel: 201-432-0463 • Fax: 201-432-9542 • E-Mail: [email protected] Website: www.belfuse.com 65